Having problems with your Vacuums ?

Air lock in case case ih ps160 sprayer

\015 Air lock develops when the tank runs dry so can't spray until the airlock is gone\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Air lock in case case ih ps160 sprayer

... Vacuums

This is not an electrolux problem, but I am hoping one of the experts can answer the question. I have a Sears air compressor that suddenly stopped working. After looking at how the motor case is put together, it appeared that it would essentially have to be destroyed to get it apart and into the motor. I received a new compressor for my birthday so I decided to tear into the old one to do some diagnosis. After getting into the case where I could see the motor/pump, I have discovered the prob

This is intersesting. I think the fuse is simply a heat sensor. If you by pass this the only problem you may run into is if the motor over heats it my eventually burn out. However, for what you are using it for overheatin should not be an issue. This ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Dyson DC 14 hose has no suction, with or without brush attachments. Hot air shoots out from the base of the canister when I try to use the hose. I cleaned the top filter, but can't figure out how to remove the hepa filter to clean it without destroying the case. It looks like it might take three hands to insert pennies and "flip" the case open as is suggested on a youtube video for a different model. Would this even help, assuming I could get the thing open?

... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Have a Eureka Power Plus 12.0 Amps Model 4702 Type A 120 volts and 60 HZ that there is something wrong that it isn't picking up right and you can actually feel the air coming out of it near where the bagless canister attaches. My thoughts are that a seal is missing around where the hole lines up when the cannister is locked in. This Vac was my Mom's and she passed away and I think a part went missing maybe when it was taken apart to clean the filter and empty the canister. Need to figure out if

... Vacuums

I have a zenith four band portable radio that is in good shape. It has a VHF antenna 6 button on top of metal case. They are as follows from left to right, air, psb, fm, am, afc, and off and on button. On the face of radio on the bottom it reads Zenith solid state AC- Battery the model number is RF86Y. It was in the family many years. I was wondering the value of it. It still plays good. Thanks David

... Vacuums

I have a Sebo air belt K1 How do you open the outer casing so as to replace the electric cable.

OK, but be warned... it's not so difficult getting the thing apart, but making a neat job of reassembly has been known to drive grown men to despair. And that's because you have to remove the airbelt. But first things first:1. remov ... Sebo K1 airbelt Bagged Canister Vacuum

Dyson DC05 buring smell and stopped working. On quick inspection, tiny bits of copper wire inside air filter case. Motor windings possibly burned-out?

Scrapped it! ... Vacuums

I have a GE model #SCA1000HBB02. Recently the control buttons quit working. I thought maybe someone locked the controls but thats not the case. The display lights up shows the time but thats all. I unplugged it and then powered it back up the display comes up to set the time but the buttons will not allow. Any help would be appreciated. Thanks, Gary

Sorry but this is the vacuum area, your problem maybe the main board or a fuse. please go to the microwave forum. ... Vacuums

My Dyson DC27 Animal is stuck (Locked) in the upright position. Everything seems to be ok with no apparent cracks or breakages. I don't want to force it in case something snaps.

Dysons are notorious for this problem. You will have to just force it and clean any obstructions. ... Vacuums

The portable sprayer wont work. No blockages in the pick up tube and a good amount of air is being blown through?

Hello, paulI was trying to help you out here. Maybe this will help some? I was going backto some customers that asked questions in the recent past and even fartherback. It appeared that no one answeredsome of them, So, I thought I would ta ... Kirby G4 Bagged Upright Vacuum

I have a roomba 551. Have cleaned and removed every bit of dirt and hair off it bu the brush cage won't close when the larger bush is put in. The cage will only click locked on one side, and the other side keeps hitting the brush and won't close. It's almost as if the bursh itself is not even, but this doesn't seem to be the case either. I've even tried removing the yellow rings, but makes no difference. Occasionally it runs fine, but most of the time the roomba just hobbles and clacks as i

Hi, had the same problem, it was like the main brush no longer fit into it's slot, so the brush cage would not latch. I discovered that the yellow bearing tip on the main brush twists off, and inside I found a lot of hair twisted around the pin. Th ... Vacuums

The case for the bobbin is not locked in and the machine will now sew White Stylemaker 3100 (sewing machine)

... Vacuums

I have a Neotec XJ-2000 ionic air purifier. On the bottom of the device, it says I should open the casing and take out and clean the dust filter every month. I haven't done it in years and no longer have the manual. How do I open it up to get the dust filter out?

... Vacuums

I have a Panasonic MC-E3011 and it won't ****. I have checked all the pipes from the beater to the inlet at the dust bag, and they are both clear, pluss the air comming out of the vent at the bottom of the upright (above the beater) casing seems abnormally hot. I have allso checked the the belt and beater bar and they are functioning A1 OK.

... Panasonic MC-V7395 Vacuum

It will empty the cleaner but will not spray water filter is clean spray heads were taken off & i could blow threw them is it a case of no prime in pump if so should i fill pump i had this thing all apart and i now know evry inch of this matchine when i pull the triger it sometimes will spray for a sec.but thats it i also took the switch out and air goes threw when i press the switch if it is the prime in the pump how can i fill the pump . what hose on the pump will prime i thankx for your advic

The problem is most likely that your pump belt is worn, stretched or broken. Here you can get the belts you need and view the manual:htt ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Bissell proheat blowing out air instead of sucking in air

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I just bought a Samsonite "Freeminder Flex" backpack with handle. My issue is with the lock... The combination for this lock was set to open at 0-0-0. It opened and locked perfectly at first. But after following the instruction to set up the new combination code, it doesnt lock anymore....please help and thanks! Linda

... Vacuums

Model # zw5000y8 The air conditioner is less than 2 years old, and has leaking water from the from of the air conditioner. I contacted Home Depot where I purchased the item and the only advice they could offer was that there was something wrong. I purchased two of the same air conditioner and I havent had any issues with the other. Can someone please offer any advice on the reason that the air conditioner is leaking from the front and filling up with water, not the normal condensation,

... Vacuums

Overheating VAX Mach Air

... Vacuums

My air con remote controller, Model RCS-3S4E-G of Sanyo do not seem to work when it is point directly towards the air conditioned system. Why is it so? And i have to manually climb up to turn the switch on for the air condition.

... Vacuums

Food Saver VAC 550. It used to work great, but now it doesn't remove all of the air from the package. It seals, but with air in the package. I have cleaned the vacuum seal, but it still leaves air in the package.

My FoodSaver vac 550 won't turn off after it's done sealing. what does this mean? Can anyone please help me out. ... Vacuums

I have a JAZZ portable power pack (300c) that I've had for a long time. When I plug it up to charge it, it want take a full charge. Also the air compresser doesn't pump air like it should. It mainly in the motor for air pump.

... Vacuums

How do I get my vacuum cleaner to blow air instead of **** air? I want to use it to blow up an air bed - Nilfisk King 240

... Nilfisk Vacuums

My Singer Futura CE-150 keeps locking up.. The wheel will not turn and the needle locks-up.. I have re-threading and cleaning out the bobbin area but it is still locked up

... Vacuums

No suction I have the central vac type. It has no suction at the can. I pulled the hose going to the walls and tested there...and nothing. I removed the dirt can and checked the motor ...it is spinning but does not feel like any suction. I checked the exhaust and it is pushing strong air out. I also cleaned the filter and still nothing. Is there a relay or something that would cause only exhaust air. I emptied the can of dirt and put it back together and have absolutely no air.....hear the motor

On some units there is a screen that protects the impeller of the motor. If this gets sealed off with debris then it is like putting a potato in the tail pipe of a car. Taking the top off the unit reveals the motor. DO UN-PLUG the unit first from th ... Electrolux Central Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0219 seconds