Having problems with your Vacuums ?

I have an Electrolux ra122b fridge for my camper van 12volt and 240volt I want to no how to connect the 240volt to it


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have an Electrolux ra122b fridge for my camper van 12volt and 240volt I want to no how to connect the 240volt to it


... Vacuums

Want to replace connection pipe part #KC92PBZTZV06 that goes into the cannister. Want to seperate it from adapter #4370325 without breaking it. I have the new connection pipe.


... Kenmore Vacuums

TRYING TO REPLACE THE PLUG ON An ELECTROLUX Z5915 1600W vacuum cleaner, IT HAS TWO WIRES from the cord.....BROWN AND BLUE.....BUT 3 POSSIBLE CONNECTIONS ON THE PLUG NOTED N, L and the earth connection.


... Electrolux Vacuums

I have a very old toastmaster small heater model 2517. I use to have it at work to keep under my desk for heat on my feet. I want to give it to my son for his pop up camper. My question is, are these heaters safe for campers?


They are inherently unsafe regardless of safety tiptoe switches. go for a modern ceramic heater. much safer. why court a disaster for such a small dollar amount. ... Vacuums

When running the 2100 Electrolux vacuum, it is stopping and starting when pulling or pushing the floor attachment. Seems like the connection at the top of the handle is a little loose or the electric tabs are loose where the hose connects. Any ideas?


Other option is that on the hose end of the electrical connection, you can use an awl on the electrical connections to bend them in slightly so they make good contact when they are automatically plugged in when you connect the wands. HOWEVER, ONLY D ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Want to read an instruction manual for Electrolux Vitesse 1300 W


... Vacuums

I want to know where is Electrolux service centre in Qatar?


... Electrolux Vacuums

For Kenmore 116.27514700 Progressive powermate vaccuum, how do I take apart the hose from the connection into the canister? I have a short in the hose and want to replace just the hose.


... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

The wall heater I want to instal has to black connector wires instead of two different colours How are the supposed to connect


A heater has no polarity and so the just hook the two wires up to the white and black house wires, either black can go to either house wire. ... Vacuums

My beater bar does not work on my vacuum. The problem is not in the hose or the attachment, because I connected to another electrolux vacuum and it worked. So the problem must be in the canister.


It's most likely a loose wire in the canister then. I recommend taking the whole vacuum to an Aerus Electrolux store and letting the service tech check it out. They can find out the problem quickly.\015\012Be aware they may try to sell you a ... Electrolux UltraLux 2000 Bagged Canister Vacuum

I want to install a new hose on a Sears vacuum Mod #116.23812300. How do I remove the Hose Connection Cover(#4370325)? It appears to be a flexible plastic part, however, it will not move from it's position on the old hose.


Hi,\015\012\015\012Please CLICK HERE \015\012This guide will explain you how to replace the hose.\015\012\015\012Goodluck.. ... Vacuums

Control cable van you tell me how the control cable connects to the motor unit?


... Hoover U6616-900 WindTunnel Bagless Upright Vacuum

The suction tube broke at the connections. The head won't turn either. I just want to buy a new one. Where? My zip is 36530


Check the Aerus home page: www.aerushome.com. At the bottom is a button titled "Store Locator:.\015\012To make a long explanation short, here's the link that give the 4 st ... Electrolux Lux 7000 Bagged Canister Vacuum

My hoover upright u8172-900. The unit provides suction, but roller does not turn. I can hear the motor click on when it is supposed to. I took the cover off, and found no belt. Does this one operate without a belt, or is it possible the belt was totally obliterated? I saw no place to connect a belt, but I didn't want to do too much disassembly at this time.


You need to replace your belt when belts get old they snap into and sometime or sucked up into your bag ... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

I have a Z5930 vacuum and i want to trace an electrical fault. I need to disassemble it to get to the electrical connections and it is quite a tricky one to get in side. The machine will run and then cut out after a short time. It will then re-start in about 2-3 minutes and run normally again and so on. I was not able to give you the exact model but it is Ultra Filtration Oxygen line


... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Electrolux Diplomat canister vacuum. The bag light comes on and it stops. It has to do with the hose because if I take the hose off, then the vacuum keeps running. I can't see anything blocking the connection. any suggestions on what else to look at?


... Electrolux Vacuums

I want to change the motor on my Electrolux 6500 Epic. How do you get the shell open?


Some use computer proof torx screws,youll ned a v long screwdriver.cheaper to buy another one new ... Electrolux Epic 6500 Vacuum

Have Electrolux 1590 whole house vac, and can't see how to get brushes out. Leads so short, and don't want to break them trying to free brushes. Do they slide out of plastic housing? My eyes not real good, but it looks like the leads are part of a brass sleeve that slides into the plastic housing. It also looks like the plastic housing may be a snap lock type, but I don't see how to open it.


... Electrolux Vacuums

Electrolux oxygen plus 2100w telescopic tube is stuck. I wanted to extend it but the handle will not release and is stuck. Can you offer any suggestions?


I have a electrolux 2000 and my tube has a small tab that you push before it would let me release it. I had trouble getting it off as well. What I did was push the tab, Plasing one foot on the vaccume head holding it down while pulling up and twistin ... Electrolux Vacuums

TOOK MY ELECTROLUX EPIC 6500 CANISTER MODEL 1762 APART TO REPLACE CORD REWINDER. TO MAKE A LONG STORY SHORT,MOST OF THE WIRES CAMES OFF OF HEIR CONNECTIONS. NOW CAN'T FIGURE OUT WHERE THEY GO WITHOUT A SCHMATIC. CAN ANYBODY HELP. THANKS CATHY


Hi,\015\012\015\012I will try to find a service manual for you. ... Vacuums

I have an old Riccar N2000 (biege) the belt connects to a little ''tension'' piece or ''guide'', not to the brush directly as in newer models. When moving-- this piece is somehow no longer there? Where can I get another one? Went to shop in town, they want $60 + labor to put the ''newer'' one piece brush thing in.....


... Vacuums

My built-in Electrolux vac is about 10 years old and I want to clean and oil the main suction motor. At which points do I oil the motor and will 3-in-one oil work or is there a special lubricant. John


Do not oil the motor as it is not required, nor is there any place to put oil. the carbon brushes should be replaced though. carefully remove one brush and bring it to a vacuum repair facility. they should be able to match it up. there is a # on the ... Electrolux Vacuums

I want a plan to connect a piece number 12 kc89vbzpz000 p.c.b. assembly to vacuum cleaner model 116.27650c Kenmore


... Kenmore Vacuums

User manual i have a electrolux masterlux z77 3 in 1. i want to shampoo the carpet but i have no user manual how does it work


HiHeres the instruction bookhttp://safemanuals.com/user-guide-instructions-owner-manual/ELECTROLUX/Z77A-_ERob ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Want instruction on how to change the belt on electrolux velocity


N mine the roller it goes around has a 1/2 block set on each end held down by a spring (streight type) or 2 screws 1 on each side of the block. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0524 seconds