Having problems with your Vacuums ?

Eureka Boss central vac wont turn on?

\015 I believe the overload protection came on when there was something caught in the filter? When I unplugged it and waited 30 secs the light came back on but when i tried the switch on the hose the light went out again???\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Eureka Boss central vac wont turn on?


... Vacuums

We have an Eureka The Boss Central Vac Model ACV2001B. When you plug in the vac the motor starts momentarily and then stops. What could be the problem? Thank you.


Most likely there is a short in the low voltage wiring in the hose. ... Vacuums

Eureka enviro vac 3041bz son sucked a sock up in the vacuum, its turned off. I removed the sock from the tube. Now it wont turn back on. Is there a reset switch and if so where is it located


... Eureka 411A Upright Vacuum

My home has a central vacuum system hook-up but no vacuum installed. My friend upgraded his central system and gave me his Eureka Mega Boss central vacuum system and the accessories, including the pow


The power head requires 120 Volts. Some hoses have a receptacle in the handle for the power head plug, and the hose has a cord at the wall inlet end that plugs into a receptacle. Some hoses have a plug at the wall inlet end that plugs into a 120Volt ... Eureka 1810 Central System Vacuum

My eureka central vac power brush turns off when pushing forward than back on when pushing back. Ever seen this before?


Yes I repair them all the time. What that means is that the connection of the hose handle to the power brush upper wand is loose. This can happen over time with use. The connection just loosens up. Do you have the exact model of the power brush? ... Eureka 1810 Central System Vacuum

I need a new sweep n groom carpet accessory that is part of Eureka Mega Boss central vac?


... Vacuums

I have a eureka cv2301b central vac system that turns on and works when the system is plugged in but when operating the hose and head inside the house you cannot shut off the system even if you unplug the hose from the wall... Whats going on


... Eureka CV2301 Bagged Central System Vacuum

Continuous running My Eureka Central Vac will not turn off. I have to unplug it.


Central vacs have relays in them, some stand alone, others mount on a circuit board. A stuck relay causes this type of problem. At the unit disconnect the low voltage wires, plug in your unit, does it still come on, if it does then you have a bad ... Eureka 1810 Central System Vacuum

I have the Eureka 4870 "The Boss" Smart Vac. The beater bar began to turn constantly and can't be shut by moving the Brush Roll Contol to Bare Floor position or the machine to the upright postion. It has also eaten two new belts. A local tech says he has seen this problem whereby the free-wheel assembly that makes contact with the belt to engage the beater bar is misalgned and cannot disengage. It is usually the chassis which would mean replacement of enough parts that would not be worthwhile


... Eureka Smartvac 4870 Bagged Upright Vacuum

My Electrolux central vac wont cut off when you turn the switch off or unplug the hose from the wall. Any suggestions? Sheldon


Hi,\012The realy that turns it on is stuck... the relay will need to be replaced...\012\012heatman101 ... Electrolux Central Vacuum

Vac motor runs but belt wont turn - Eureka Power Plus 4703D Bagless Upright Vacuum


Its time to check and/or change your belt. to do this you want to remove the two screws on the top casing and remove the cover. There are detailed belt change instructions on a sticker under the top casing on how to remove the brush and b ... Eureka Power Plus 4703D Bagless Upright Vacuum

Eureka The Boss Smart Vac, beater bar stops turning when you use it on carpet


It is a simple fix that you need. Your belt needs to be replaced. After a period of time, the belt stretches to the point where it is still strong enough to spin the brush when you have the machine upside down to look at it, but when you put the mac ... Eureka Vacuums

I replaced the belt in our Eureka Boss Smart Vac, it still seems loose, it uses a type R belt. The beater belt still doesn't seem to turn properly and seems that it doesn't pick up very well when I use it on my berber carpet. We have 2 dogs and I like to use it frequently. I have changed the bags and belt......


Check to see that the beater brush is not frozen up. Pull the brush and clean it, spraying some WD40 on each end piece that holds the brush in place.\015\012Also be sure the belt is properly installed so that the brush turns in the correct direction ... Eureka Vacuums

We just moved in - the house is about 9 years old. I have a Eureka Mega Boss central vac - looks like model # is CV20220. 12.4 amps, 120 volts. Can't figure out what type of bags I need. Can you help?


Well, for this unit you will need any of the following bags, Eureka genuine Part# 90610Eureka replacement (Central vac bag) another genuine bag style called CV-1, and/or CV-2Kenmore Central vac bagsMost of th ... Vacuums

My eureka enviro vac shut off and wont turn back on it was clogged but does not smell burnt . is there a reset or some kind of shut off when it gets clogged?


Same thing happened to me. I checked the owner's manual and it turns out the Eureka Envirovac has a built-in thermal cut-off switch. So anytime the motor gets too hot, it just shuts down. Most of the time this is because it gets plugged or the fil ... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

I have a Eureka Mega Boss Central Vac Model # CV1801P. The suction works when the handle button is pushed left (floor mode) but no suction happens when the button is pushed right. When the floor attachment is hooked up and the button is pushed right, the brush rotates, but there is no suction.


... Eureka Vacuums

Kenmore canister model 116.25513506 wont turn on. when handle switch is turned to floor. vac motor does not turn on. When switch is turned to carpet, floor nozzle works but vac motor does not. I checked fuse, all o.k. checked continuity for plug, o.k. removed wires for bag full switch...motor wont run. I wired motor directly power cord...motor runs. Thinking it must be the circuit board, how do I bypass it or test it?


... Vacuums

I have a Eureka 'The Boss Smart Vac'. The beater


Yes, you need to replace the belt. You should actually change this belt every year. Here is a link to the belt you need and the manual which has instructions: ... Eureka Smartvac 4870 Bagged Upright Vacuum

I have a Eureka Boss Smart Vac. The vacuum doesn't pick up well


... Eureka Smart 4870DT Bagged Upright Vacuum

Eureka central vac 's power stopped won't start again.


I took to dealer I bought from . He examined it. The motor is gone needs new one. Thanks, Ann ... Eureka 1810 Central System Vacuum

Eureka Boss height adjustment not working so brush stops turning


... Eureka Boss? SmartVac 4870MZ Bagged Upright Vacuum

Eureka the Boss SmartVac just turned off and won't turn on


Make sure it is not the electrical outlet that has tripped. If not then you basically have 3 choices. Cord, switch, motor. A service tech. should be able to diagnose. ... Eureka Smartvac 4870 Bagged Upright Vacuum

Getting a Eureka central vac cloth bag back in after cleaning


I found that if you start by making sure that the tab that you pull to remove the filter is in a spot where you can reach it next time you need to remove it. Next, put the filter in over the inlet spoutand push it up to the white "stops" then gently ... Vacuums

On my M&S Air Vac AV425 central vaccuum system, the system usually turns on by inserting the vaccuum hose into one of the vaccuum outlets. However, it now runs continuously. I am able to turn it off only by unplugging the vaccuum from the electrical outlet. I would like to know how to trouble shoot the problem or how to find someone who services Air Vac systems in the Bridgewater, New jersey area.


We are a central vacuum service company and we service all of new jersey. sounds like you have a short some where that keeps your unit running or it could be your relay module thats stuck our number is 908-721-7595 its j&j central vacuum services ... Vacuums

Eureka Central Vac-Sweeper -Model B1501


First undo the hose from the base and then take the cover off from under the vacuum, remove the brush roller and belt, then note where the suction hole is and shine a light through the hole and look in the other side, if there isn't any light, then p ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0580 seconds