Having problems with your Vacuums ?

Hoover aquamaster recently purchased hoover aquamaster, trying to shampoo carpet, can't get water to come down tubes, water keeps going into dirty water tank.help!!!!!!!!!!!!!!!


Answers :

Sounds like you need to attach the air hose
\015\012
\015\012with reservoir in place you clip on the lid with tubes attached, one of them goes down to the floor cleaning nozzle, the other tube should be about 20cm long with an end piece,
\015\012
\015\012this is the air hose and it fits into a small hole under the reservoir on the motor housing (the heavy mains powered part that clips onto the big recovery drum that sits on floor)
\015\012
\015\012it's mentioned briefly in the manual, here it is in pdf form http://www.box.net/shared/rnh39ffjcq
I'm residnt in Portugal.
\015\012my hoover aquamaster vacuum hose is damaged. Where shall I look for new,
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover aquamaster recently purchased hoover aquamaster, trying to shampoo carpet, can't get water to come down tubes, water keeps going into dirty water tank.help!!!!!!!!!!!!!!!


Sounds like you need to attach the air hose\015\012\015\012with reservoir in place you clip on the lid with tubes attached, one of them goes down to the floor cleaning nozzle, the other tube should be about 20cm long with an end piece, ... Vacuums

Suction button Although my Hoover Spin scrub is working perfecting dispensing the solution, when I go to suck up the solution from the carpet--I am having problems with the RED suction button that keeps popping up. I have to stop the cleaner and lift up the dirty water container to break the suction. Ive tried cleaning the netting that is encased around it, but still no luck. Any help would be appreciated! Thanks


This happens when the filter on the inside of the lid for the dirty water tank is pushed all of the way up. You need to leave a 1/4 in. gap from the top to the top of the filter ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I love my hoover F5912-900 scrubber however it has stopped sucking up the water. Is there a place that it could be blocked with dog hair or other dirt?It blows out air, but does not **** up the dirty water. How would I go about unclogging it?


Hi Shirley. Im afraid I do not have a solution for you rather I have the same problem.exactly it only blows..My machine is brand new I was using it for the 2nd time only......i also cannot find anywhere to unclog this thing....I even took the front p ... Hoover F5912-900 Upright Steam Vacuum

I have the Hoover max Extract 77 and when I'm cleaning the carpet, the clean water tank leaks on the floor, even if I'm not squeezing the trigger. The clean tank doesn't leak when I fill it, but once I place it where it fits and start using the vacuum, the clean water drains out on the floor. The dirty tank fills up, so the suction works, but, I don't know what is going on?


... Hoover Vacuums

Dirty water not going into container - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Make sure filters are clean ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Just bought a Hoover steam vac. Did the dining room. everything okay.. emptied recovery tank and replaced. started on living room. dirty water not going into recovery tank. carpets very wet. What did I do wrong and how do I correct it


You may have put the lid on your recovery tank on wrong. on some models you have to lock the front in first then snap it down in the back. if you can pull the lid away from the tank then its on wrong and isnt making a seal. ... Vacuums

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

The cleaner/water solution dispenses into the carpet, cleans it, pulls out the pet hair, but no dirty water goes into the dirty water reservoir! is all this dirty water going into my carpet?


The pet hair may be clogging the water return inlet I suugest you clean the bushes and inlet as well ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My hoover steamvac wont **** up dirty water float


This will also happen if the recovery tank lid is not securely latched or the lid gasket is bad and is leaking air. No vacuum, and the tank overflow ball snaps into place. I had a tank lid latch fail, and the symptoms you report were identical. ... Hoover F7431-900 SteamVac Vacuum

Does the dirty water go into the bladder? I thought that the bladder was the holding tank for dirty water. Any water (very little) was collected and sat on top of bladder. Any advise is appreciated


... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Hoover Max Extract 77 fills the dirty water tank with clean water from the clean tank.


... Hoover Vacuums

Shampooer instructions..... I have a Kirby Generation 3 with the shampooer. it has been awhile since i have used it and i sort of remember how to attach it but i was wondering this vacuum has a tray and i assume it is for sucking up the dirty water but when i went to use it no dirty water was going into the tray.....help what did i do wrong......thank you for your time...............spanny


Try this link....http://reviews.ebay.com/KIRBY-CARPET-SHAMPOOER-INSTRUCTIONS-MANUAL-DIRECTI ... Kirby Generation 3 Bagged Upright Vacuum

Can't find info for hoover steam vac spin scrub model # F5905900 on Hoover website, doesn't show that model number at all...looking for mesh (kind of cone/cylinder shape) that goes in dirty water tank (I think) and also the tool (wand) that slides into front to clean it out. It doesn't pull all the water up very well and the filter has been missing for some time. I don't know if that has anything to do with it or not. As far as the wand tool goes, I have taken the cover off at this point and


The cleanout tool is part # 43514001. The filter is # 90001398. Be sure to leave a 1/2 inch gap between the top of the filter and the bottom of the lid. If you need a manual, try model F5914-900 0r F5912-900 on Hoover.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The suction on my Hoover Spin Scrub 50 is suddenly not working. This is the 2nd or 3rd time I've used it and until now it has done a great job. But now it leaves my carpets soaking wet with no hope of drying and no dirty water is being suctioned into the dirty water tank. Help!


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a bissell 12 amp dirtlifter powerbrush pro heat.where does the clean water go?and where does the dirty water go that comes back off the floor?


... Vacuums

My Bissell proheat shampooer releases the shampoo on the carpet but when I go to ****-up the dirty water into the plastic bucket to empty it there is no dirty water. Please advise or refer a repair place close to Pinellas Park, FL 33782. I have used this machine for about 2 years.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

The Hoover Steamvac Widepath will NOT pick up water. The dispenser with cleaner DOES have water. The TANK that would receive the dirty water is NOT full. All tanks are on properly and the machine will still not pick up the used water. I found a tear in the interior hose leading to the receiving tank and repaired throughly with electrical tape. Still will not pick up the water. Any suggestions?


Sounds like a clogged air path (no vacuum action) from the floor pick-up to the collection tank. Take the tanks off and deal with the vacuum problem alone. The collection tank should have a air exit vent--is it clear? Check the interior hose that you ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

The hoover steam vac 5 brush agitator dispenses water and soap but does not show any return water to dirty water reservoir. The carpet seems damp but not soaked, still a bit troubling no waste water...what up ?


You do not have the needed vacuum on the dirty water intake. Possible causes are:\015\0121. No adapter sleeve in the back of the dirty water tank (the one that you remove to put the fabric hose adapter in)\015\0122. The dirty water top i ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl


There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

My Miele vacuum cleaner has the red triangle light on and keeps switching on and off. Is it broken? have been hoovering upstairs and I noticed the hoover had the red triangle light on. I changed the hoover bag but it still kept going on and off. Is this an overheating problem or is the hoover on the way out?


... Miele Vacuums

Hoover SteamVac Plus 1200 upright hot water extractor Water/carpet cleaner applying o.k. Suction on the "floor" does not work. Suction on the hand tool works somewhat, but water is not collecting in the bucket. There is suction coming from the floor but water is not going into the bucket. It does not appear to be clogged because I can feel with my hand that air is flowing from the floor. The water is not being sucked into the bucket.


... Hoover Vacuums

Hoover Agility Steam Vac has no suction for the dirty water


Broken suction hose. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

The water tank on my bissell proheat 2x is not keeping the clean and dirty water separate. I;ve checked the container and there doesn't seem to have anything wrong with it. Also when I switch the machine on you can see the "washing" action, after a few minutes this seems to stop - there is water and forumula in the machine. Only had it a year!


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I am using a hoover steam vac and the button keeps popping up to say that the water is full. That makes the thing stop sucking up water out of the carpet. Problem is, it has barely sucked up any water yet. Help!


Have u tried cleaning it out really good make sure any areas that water is **** up through are free of hair, lint ect. ... Hoover Vacuums

Dirty water is not going into the tank, it's leaking out the bott


I would check the lower hose assembly. it seems they wear out where the handle closes and opens put the handle down and look in to see if its broke. if so its only like 20 for a new one and a pain to get the old one out.... ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0889 seconds