Having problems with your Vacuums ?

Vacuflo model 566Q only runs intermitently and then shuts off via the overload protector.

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vacuflo model 566Q only runs intermitently and then shuts off via the overload protector.

... Vacuums

I have a kenmore upright vacuum model #116.35922500. The agitator tube doesn't turn. It doesn't have a belt for the agitator. It has an overload protector. I reset it, but it keeps poping back up. Should I replace the overload protector?

The reset is for your safety no belt ,probly a direct drive motor issues ,maybe the brushes it is detecting a short and pops the reset. ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

I have an easy flo vacuum model # 199C and it won't shut off. It started out as an intermitent problem but now will not shut off when the hose is unplugged, nor when the off/on switch on the main unit is shut off. the only way to get the motor to stop running is to unplug the unit. Any ideas?

Just had this same problem. I unplugged the low voltage signal wires and the vacuum stayed on. Thus eliminating the possibility of the signal wires shorting out somewhere. I'm not really sure which wire(s) were causing the problem. But when I disasse ... Easy Flo EF1500 Vacuum


The circuit tracks should be getting cut somewhere in between some where so it leeds to this problem. ... Vacuums

The thermal motor protector on sears model 116.35912 Kenmore vacuum won't reset. The manual says to wait 30 minutes and the thermal protector will reset on it's own. It appears I would have to take the vacuum apart to get to the thermal protector. Is it worth the effort or should I trash the vacuum?

... Kenmore Vacuums

Model 2100 canister: Red light comes on to indicate bag is full and machine shuts off. The bag is empty...when I readjust bag, machine will start up again but shut down shortly.

Try this \015\012Electrolux LE, 2100 Hi Tech Canister ... Vacuums

Our Rowenta iron model # Dx 8800 comes on then shuts off in the vertical position after a minute or so. It seems the auto shut off is bad?????

Yes the so called auto shut off is only a small thermostat cost 8-10$ and need to be replaced ... Vacuums

I have a Kenmore Progressive upright model 216-37100800. It is only around 1.5 years old. My wife said that one day after she plugged it and turned it on, it whirred up but then shut off. Since then it will not start. I have noticed that right after I plug it in, if I try to turn it on, the first yellow light in the series of dirt sensor lights turns on then shuts off. After that the light will not light up on pressing the power button, unless I unplug it and plug it back in again. I have seen o

... Kenmore 25512/ 25513 Progressive Canister Vacuum

Kenmore progressive model#116.21612001 worked fine then nothing!

... Kenmore 23313 Whispertone Bagged Canister Vacuum

The motor LG model VKC902H either shuts off or blows a fuse

There will be repairs as it is either a short in your wiring or your armature brushes or brush on one side of the motor is worn down to low, check to see if covered by warranty as these two issues are not normal wear and tear over a period of 20 mont ... Vacuums

Electrolux model 2100 shuts off with slightest suction blockage

This is exactly the symptom you would expect from a defective bag control valve. The actual control valve sits under the dial on top of the vac and often cracks internally. It can be replaced in about 15 minutes by a good tech with genuine parts fro ... Electrolux UltraLux 2000 Bagged Canister Vacuum

I have a Sensor S12 Model SRS12 10120210 motor shuts down after about 3 minutes of using, already checked filters and are ok.

... Windsor SR12 Sensor Bagged Upright Vacuum

Nutone model # cv253 w shuts off

... Broan-NuTone CV353 Central Vacuum

Hoover Model UH71003 Just shut off

... Hoover Elite Rewind Pet Bagless Upright, UH71003

Eureka Boss 4870gz shuts off (thermal protector) after 2 or 3 min

Wiggle the cord while running the vac. if it cuts off from that, then you most likely have a bad switch or cord. if the motor was bad, you would smell it. it smells aweful. ... Eureka Smartvac 4870 Bagged Upright Vacuum

Kenmore model 116.21614 shuts off when floor cleaner is attached. works ok with powermate attachment but with poor suction

... Kenmore Vacuums

Hoover Model U6425-920, Series Q 12.0. runs 3-5 minutes, shuts down on thermal reset. motor shaft and brush both turn freely. cannot detect any roughniss at all in shaft turning.

... Hoover Vacuums

Brand new Steamer.. Worked less than a minute and shut off Trying Model sf 465

Take it back to the stor where you bought it and get another one or get a refund. ... Steam Fast SF-465 Canister Vacuum

Problems with Kenmore Whispertone model 118 Bagged Canister Vacuum Overload Protection Reset won't reset

... Kenmore Whispertone 23312 Bagged Canister Vacuum

I can't get the vacume to run for more than 15 minutes before it shuts down presumably do to overload. But I don't get the warning light and I clean it out regularly. I have to let it sit for hours until it resets and I can finish the job

Sounds like you have a blockage. Check your attachment hose by dropping something through it, if it is all clear, then check your duct hose, this is the hose at the base of the cleaner. Many times this will clog and you might have suctionat your ho ... Vacuums

The hose has a hole in it and the red ball keep shutting it off. Model F581-900 I have another Hoover SteamVac that is broken too. Where can I get these fixed, I live in Crown Point, IN. Thanks Valerie

I think all of the Hoover Stores are out of business.\015\012\015\012Try here for parts\015\012\015\012 ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have an older Electrolux canister vacuum - model #2100 and the temperature sensor shuts down the motor. How to I take apart and clean?

Check to be certain the thermo lite is on and not the bag full indicator. The thermo detector is very reliable, but the bag fill valve often fails. If it is the thermo, check your hose and wand for blockage by dropping a coin through them,before ope ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Nutone model cv-350 vacuum motor will not shut off. I have to unplug system in garage. I disconnected wire to house vacuum inlets and motor is still running. There must be a reset on the motor. I have turned the external switch on and off and still no help.

Mine is the same, and it is the relay welding itself closed. The relay is switched by the low-voltage wiring that connects to the vacuum outlets, and it switches the motor on and off. Mine was welded in the energized position. I have cleaned and file ... Vacuums

Is there a fuse in the hoover wind tunnel model 6425-920, the vacuum just shut off during operation and will not re start with the switch. What should I attempt? Thank you.

There actually IS a fuse/buss of sorts, if you really stretch the definition, anyways...so if your switch checked out good, and your outlet didn't fizzle out and blow a house fuse or trip a breaker, in the machine base, near the motor, there is a "Th ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Kenmore canister. Brush is turning but spitting all dirt under and out the back of the head. I guess the suction is very weak or non at all. What is reseting overload protector doesn't work. Haven't tried yet but just in case. THANKS!

I would look to see if there is a clog. that would be the only reason that the power head would be spitting dirt in back of the power head. check the hose. ... Kenmore Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0691 seconds