Having problems with your Vacuums ?

Hoover Freejet Cyclonic will not charge after battery run flat

\015 Vac worked perfectly for 2 years, living on its charge base as advised. When the battery began to run down faster I let it run completely flat as recommended, for a complete recharge which has always worked fine. This time the whole vac was dead. I've tested the fuse in plug and wall socket with other items. The cord to the base is undamaged, so there appears to be power to the charge base.The battery pack inside vac appears intact also. \015\012Replacement Batteries cost same as a new vac, or service call, and I dont want to do that as problem seems to me to be the charge base.\015\012Any ideas?\015

Answers :

Basically, the batterie pack is shot and it will cost about £40.00 ish to replace. as you said, a right rip off
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover Freejet Cyclonic will not charge after battery run flat


Basically, the batterie pack is shot and it will cost about £40.00 ish to replace. as you said, a right rip off ... Vacuums

The PCB controlling the battery charger is overheating and the led dosen't illuminate when charging, could the led be shorted internally causing the problem. The vacuum in question is a Hoover Freejet Cyclone SU144S2 001


The problem was caused by the failure of 7 of the 1.2volt cells in the battery pack, the other problems were symptoms of the battery pack failure. Replaced the thermal cutout a 131 degree C component on the PCB in the docking station for the vacuum w ... Vacuums

I have had a Hoover Linx cordless stick vac for several months. Even after charging the battery the vacuum will not run at all. What are potentially the problems and how do I get it fixed.


... Hoover Platinum LiNX Cordless Stick Vacuum

I purchased a brand new P113 Ryobi charger about 2 years ago. It has never worked. If I put a P104 battery in for a charge, it looks like it works correctly. I push the battery tester on the battery itself, and it says full charge, but when I go to use the bateery, it dies right away. I have tried three new P104 batteries. The batteries charge on my charger at work with no problem. The funny thing is, I don't need a battery in the charger and the charger does the same thing, It runs the test


If you have your receipt, check with Ryobi to see if it is still under warranty. It comes with either a 2 or 3 year warranty, depending on when it was purchased. If it is still covered, get it replaced/repaired. If it is not, buy the P117 charger. $3 ... Ryobi P113 18 Volt One Charger 140501001

The battery will not charge in the sweeper. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. So the power supply and the battery are both good. Obviously there is a circuit failure in the on board charging control. Anyone know a fix or a likely faulty component? I had a shark handheld about 8 years ago and it developed the same problem. I examined the little circuit board inside but saw no visible indications that would isolate t


... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

After charging overnight, Roomba only runs about 25 minutes before shutting down with a red light.At this point the battery measures 15.13 volts ( about 1.26 volts per cell ) My hobby experience is that a ni/cad or ni/mh battery nominal charged voltage is about 1.2 volts per cell, and that the recommended end point voltage should be about 1.0 volts per cell. Seems like the battery is ok, butsome kind of voltage regulator is shutting things down prematurely. Is this happening, and , if so, how ca


Reset the Roomba by removing it from the charger, then holding "spot" and "dock" for about twelve seconds. When you let go, the unit will play an ascending series of notes. Then recharge it overnight. If the run time is still short, give Customer Sup ... iRobot Roomba 560 Robotic Vacuum

My Infinuvo Cleanmate QQ2 will not accept a full charge. It runs for 10 - 15 minutes and then says "battery low". I have a new battery and charger. I have charged it directly without the home base and have left it charging for days. Any suggestions? Thanks, Linda


... Infinuvo QQ1 CleanMate 365 Robotic Vacuum

Our roomba 560 wont charge have replaced the battery Tested the charing unit with another roomba that all seems ok put the uncharged battery into another Roomba but im guessing it now has a memory as this wont charge in the other hoover. Any ideas what may be wrong


Try cleaning the battery contacts with a little rubbing alcohol or contact cleaner on a foam swab, or a bit of paper towel. Take a litle time, it doesn't always dissolve instantly. (Don't use a pink pencil eraser, it would scrub off the plating that ... iRobot Roomba 560 Robotic Vacuum

Roomba 4320 will not charge the battery but does run


... Vacuums

I have bought a HOOvER freespace 2000W cyclonic vacuum cleaner but it runs VERY HOT and I am wondering if this is the usual running temperature. I have cleaned the air intake filter and removeed the e


... Vacuums

Just put a new battery in scuba and it runs about 30 seconds (completely charged)


1) replace again the batteries by new ones and completely charged.2) test the charger if if functioning properly, can be faulty, and not charge well the batteries.3) test the power supplies inside from the scuba, to due some short circuit dra ... iRobot 5800 Scooba Vacuum

My cordless freejet wont charge - Hoover Freejet Fj120wb2 3-In-1 Rechargeable Cordless Stick Vacuum Cleaner With Detachable Hand-Held, 12 V


... Hoover Freejet Fj120wb2 3-In-1 Rechargeable Cordless Stick Vacuum Cleaner With Detachable Hand-Held, 12 V

I installed a new battery in my Roomba 540. It charges and runs directly with power cord but will not charge on dock. When I push the dock button, it acts like it "sees" the dock and approaches it and even slides on, but then gets back off again and just keeps going back and forth until I turn it off.


... Roomba Robotic Floor Bagless Vacuum

I have a irobot roomba 560, that doesnt go back to dock for charging, he just runs until the battery runs out? What can I do to make it go back to the dock ?


... iRobot Roomba 560 Robotic Vacuum

My shark vx3 vacumn has stopped running... i tried recharging it, but still no luck... i then put a new battery pack on it and tried recharging, still it won't run... the charge light, (green) is on, the three red lights come on and flash when i push the on button...what should i do next?? this unit is about 6 months old... help!!


... Euro-Pro Shark Cordless Stick Vacuum SV775R Vacuum

I think the battery is not holding its charge anymore. The red (charging) light does change to green but only runs a few yards on leaving the dock.


You have dead nimh (nickle metal hydride) batteries.You\012will need a ... iRobot Roomba 560 Robotic Vacuum

My dyson DC16 constantly shuts off even when battery is fully charged. I cleaned the filters to see if that was the problem. It only runs for a few seconds before it shuts off. It will run intermittently for about 10 minutes before dying completely. Please advise


Hi its Darran at Dyson. From your description of the problem, it sounds as though there is a problem with the battery. Your DC16 will have been supplied with a 2 year guarantee. If it still within this period, please contact ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My DC 16 will only run for a second each trigger pull. The battery is fully charged, it has plenty of suction, just wont run for more than a second. I cleaned the filters.


I had the same problem with my Dyson DC16, where it only runs for a few seconds at a time with each trigger pull. My husband called Dyson (Canada) and without hassle they shipped us a replacement part which I just received this morning. The replace ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Roomba discovery on full charge power up and it will run 5 sec power button then flashes red and roomba quits. I have tried removing battery and holding power button for 30 sec then charging same result


Unfortunately the batteries on the roombas can go bad and not hold a charge and need to be replaced, also you should check all the brushes and wheels on the bottom, if they are bound up it would stop the roomba from working. the two brush rollers can ... Vacuums

Hoover battery powered SU144S2 not holding charge


... Vacuums

Hoover linx motor makes a lot of noise when running


... Hoover Platinum LiNX Cordless Stick Vacuum

Roomba charged (new battery just installed) and won't run


Charging circuit on the roomba will sometime stop the unit from running. Just repaired one the other day doing just that. (Replace the main board, if you don't haave electronic repair skills, or the equipment to do it) ... iRobot Roomba 4210 Bagless Robotic Vacuum

After a full charge will only run for about a minute then stop. New batteries purchased, same result.


I fixed that same problem!! take it apart and you will see tons or hair and long threads of string wrapped up around the bearing under the belt. its super easy. my 3 year old and i did it together. whats happening is all that gunk is making the belt ... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0874 seconds