Having problems with your As Seen On TV Microfiber Replacement Pads for H2O Mop X5 Steam Mo ?

H2o mop not pumping water

\015 Not pumping water\015

Answers :

Repair Help & Product Troubleshooting for As Seen On TV Microfiber Replacement Pads for H2O Mop X5 Steam Mo

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I am looking for a new water pump for my H2O Mop.

I took the pump apart and applied a small amount of silicone lubricant to the main o-ring. Bingo it now works lie new. It also saved me $65.00 which was the price of a new main body(what a ripoff). ... Vacuums

Water pump does not wok - As Seen On TV Microfiber Replacement Pads for H2O Mop X5 Steam Mo

... As Seen On TV Microfiber Replacement Pads for H2O Mop X5 Steam Mo

HELP! My HAAN floor steam mop water pump went silent & dead! Heat element still heats, but the pump is inactive.

... Vacuums

I have a Thane h2o mop ultra, I added some bleach to the water tank to clean better, the unit worked for a while, enough to clean 1 room, then even if the tank is still full of water the steam is not

... Vacuums

H2o mop leaks large amounts of water straight from the box

... H20 x 5 Mop

H2o mop problems keeps leaking water from pressure release valve

... Vacuums

My h2o steam mop does not produce steam.I have only used it 6 times. I have tried using 1 part vinegar and 2 parts water to clean the system but no joy.

The H2O Mop X5 is designed to thoroughly clean floor surfaces, such as marble, ceramic, carpet, stone, linoleum, and sealed hardwood floors and parquet. Not all floor types are suitable for steam cleaning. For more details about h2o mop please ... Vacuums

Shark Steam Mop S3501: Water leaks out but the steam does not reach the pad even with vigorous pumping. The pad mechanism blew off at one point before I realized there was a problem.

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My new H2O Mop Ultra (Danoz) seems to heat up ok then when the light switches to green and I start using it, the orange light comes back on as well as the green. Produces steam to start with but then it starts to spit water too and everything ends up wet. Any ideas on whats wrong or should I just send it back?

That is a major hardware fault, I have seen this numerous times with these H2O mop's... They seem to either work perfectly for a long while or have problems right off the bat. You definitely want to send this unit back and either get a refund or at ... Vacuums

I pumped my steam mop to get started as I always do. I heard a loud pop and now it won't produce steam and leaks water on the floor.

I was mopping with mine a couple months ago when it stopped producing steam. I pumped it several times resulting in a really loud pop (sounded like a .22 going off) followed by a large release of steam from the housing followed by water trailing on ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Shark steam mop - Model S3501 does not produce steam. I checked the water after 10 minutes. It was completely cold. I primed the pump several times as suggested in the user instructions

\012Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Ste ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My h2o steam mop doesn't produce any steam,I already remove the head and then I put vinegar and water solution in the tank 2x and it doesn't produce any steam....

... Vacuums

My mop will not steam when pumped. Just the cold water in the tank comes out.

Hi,heater is broken...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Eur ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

H2o mop pump - Vacuums

... Vacuums

Saeco Odea Giro pumps the water but the internal spline or gear is not turning moving the ground coffee grinds to the point where the water can pump to the front exit lines so the water is pumped into the over flow resevoir. How do I replace the gear or check to make sure this is the problem. I want to replace this myself.. Also how do I get the unit apart it seems to be bullet proof. Is this a common problem.

It is a common problem if it is what I think it is. However your description is a little confusing. So the coffee does get ground up, but then has a hard time getting to the next stage of the process? Please clarify... And no water gets pumped th ... Vacuums

I have a Saeco Armonia Espresso Machine. The water pump was running when the tank ran out of water and when I refilled the tank, it wouldn't start again. I unpugged it and turned everything off overnight. The pump is very loud and won't pump any water.

Common on Armonia...There is no water in the system, so the pump is pumping air!!you have to push on the usual button but make sure the hot water button (for tea for ex) on the right side (same as steam opening valve) of the machine is op ... Saeco Vacuums

Hi my proheat bissell 7901 stopped pumping water to the floor, but it pumps water from the hand hose. I read the manual and followed how to check belt and the flat belt on right side of shampooer is fine and I turned on and it turns and so do the brushes at the bottom of the machine. I was reading online and I guess there's two belts on this machine? where can I find the other belt to see if it needs replacing. I guess it's a ribbed belt? that is the water pump belt?

Just taken ours apart with the same problem... found it was caused by the 2 halves of the main casing coming apart in the area where the upright pedal release is. I found this to be due to the upper casing having broken in 2 places - the bottom of th ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My Steam mop (model 90Y5F) is dripping water from the join at base of water bottle. It started off small and is now rapidly increasing. I spend more time going over the spills than actually mopping. Is there a way to prevent it as the little area where the water is meant to drip thru is flooded - I still get plenty of water through to the pad though.

... Vacuums

Shark steam mop will not release water or steam.

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My kenwood steam mop makes for very wet mopping is this supposed to be? My floors are a lot wetter than when I use a traditional mop. When I fill the tank and turn it on the water seems to just leak from the bottom so I have only been half filling it and then the water light comes on within 2 mins of when steam starts to appear. What am I doing wrong??

... Vacuums

Bissell ProHeat 2X Select Upright Deep Cleaner not pumping water to floor. Water is not flowing out of the pouch area into the carpet. Water does not come out of the blater, I have checked the line & valve and they are clear how do I check the pump

Make sure you have soap in the soap container or the water will not pump. Sounds strange I know. Even if you have the soap mixture selector turned off, it seems that these machines won't pump clear water unless the soap resovior has fluid in it. D ... Vacuums

My Bissell Quicksteamer Model 1960-R won't spray cleaning solution. I have cleaned it and taken apart the whole thing. I can't find any problems. The holes are not cloged where the water comes out as I disconnected it and blew through it to be sure. The lines show water trying to go through. It is as if it doesn't have enough power to pump the water out when I squeeze the trigger. I am thinking it is the pump thing but can't find a replacement part for it.

... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

The automatic drain hose is hooked up to the back of the unit, but when the bucket is full, the automatic pump does not work. The automatic pump should come on and empty the bucket, but it does not come on unless the water is siphoned manually through the tube. Then the pump come on and empties the bucket. I have reattached the tube and still had to manually siphon the water through the tube. Any suggestions?

Any automatic pumps operate off a swith that is turned on when the water rises. They normally have some type of ball lift, that will raise the switch when water is high and then drops with the water and shuts the pumps off. It sounds like yours is ... Vacuums

Leaking h2o mop

... H20 x 5 Mop
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0492 seconds