Having problems with your Bissell 1425 Little Green ProHeat Handheld Steam Vacuum ?

Hand held piece - the solution doesn't spray out anymore. I have taken it apart to clear any obsticles but still just a few drops come out. It has been several years since we received it as a gift. Any recommendations? -Kevin


Answers :

Most likely the pump. its red and has a couple of wires attached
Repair Help & Product Troubleshooting for Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hand held piece - the solution doesn't spray out anymore. I have taken it apart to clear any obsticles but still just a few drops come out. It has been several years since we received it as a gift. Any recommendations? -Kevin


Most likely the pump. its red and has a couple of wires attached ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

After many years of faithful service our Electrolux Cyclone Power Lite Model Z410A (motorised brush roll). has come to the end of its life. Questions:- Is it now obsolete ? If so can you recommend a similar but suitable model we can purchase ? Regards Peter Downs


... Electrolux Vacuums

Noise My Dyson DC08 is making a loud, rough, vibration/noise that seems to be coming from the from the rotating brush housing. I replaced the old belt which was several years old and slipping. When I run the motor with the new belt removed the machine sounds normal. The bearings on the rotating brush seem to be running smoothly when turned by hand both when out of the brush holder and when installed in the machine. I can't find anything rubbing on the belt or rotating brush. I applied a bit o


Hi there, it's Jack at Dyson.\012I'm sorry to hear you're having difficulty with your Dyson vacuum. From your \012description, it sounds like the model number you've supplied may not be correct, \012as DC08 is a cylinder vacuum which doesn't use ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Our Miele vacuum is only 2/3 years old and seems to have given up the gost, our previous one lasted 15 yrs. The machine starts ok and within 4/5 minutes the power drops down and the hoover comes to a stop and it may re-power itself again within minutes, as of today their is no power when the on button is pressed. What do you think the problem is Thank you.


There is a circut board that is going bad and not providing the power to run the motor. You will need to contact a Miele dealer for that part. It is the only board that is in this machine so they should just need a model number in order to get it ... Oreck XL Ultra Bagged Upright Vacuum

My wife has a Revlon Rv051 curling iron .. has worked fine for several years but now it has stopped working. No response to pushing the ON switch (normally turns on a red LED). I've opened the unit and verified the integrity of the cord and swivel contact between the cord and the PC card. Unfortunately w/o any documentation of the PC card, I'm at a loss as to what to try next. My wife has had this unit for several years ... liked it well enough that she now has two more of the same model but


Is power making it to the switch? Sometimes the plug of the unit with pushbuttons has issues and fails. Maybe you can switch a plug from 1 of the other ones you have to test. ... Vacuums

Bissel spot bot water not coming out of tank is not a year old and tried manual wand and the water doesn't come out there either. any advice. Is not a year old yet.


You could take the end of the handle off 2 screws i think check the line for a clog or just take it to a bissell service center it will be covered under warranty ... Bissell SpotBot Robotic Wet/Dry Vacuum

The one of the controllers for the electric blanket keeps flashing an "e". The other controller is fine. We switched controllers and the same thing happened. We have unplugged the blanket for several minutes and turned off the controller for several minutes. It always goes back to displaying the "e". It is a warmspun blanket and I cannot find any information on the company so that I can contact them to see about the 5 year warranty.


I did some searching-- and I came up with this Linkedin page-- seems to have some information-- Let me know if it helped-http://www.linkedin.com/companies/jla-homeMack B ... Vacuums

I have a Rainbow E2 series, 23, for about 3 years. It has now a different and very aloud sound coming fron around the motor and also I feel it is not suctioning with the same power. If I close the hose like closing totally the suction entrance, the sound comes normally. I will appreciate if some one can tell me what to do, becouse there is not a Dealer in my Contry any more. Thank You. Pierre Chabaneix - Lima-Peru [email protected]


Hi there, Pierre!\015\012Sorry, but I think this is bad news. From your description, I suspect that a motor bearing has failed. The only way to fix it is to replace the motor, and without a dealer in your country, that could be a big problem.\015\012 ... Rainbow E series Canister Wet/Dry Vacuum

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!


Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have a creda aquablue 8.5 kw electric shower. it's only 2 years old, it comes on ok then the light goes out & it goes cold, if you turn it towards cold it comes back on but not for long. i've cleaned the shower head as advised but it made no difference. can you tell me which part is faulty? my son in law is an electrician & could fit it


... Vacuums

My delonghi ec330 espresso machine. it worked fine for a while until one day i forgot to turn it off and it was on for about half the day.later i tried to use it, and the espresso comes out drop by drop now.


... Vacuums

Bissell Quicksteamer I have a Bissell Quicksteamer that is about 5 years old. I went to use it today and hardly any solution was coming out. I could see it suctioning up what little came out, so I took it apart and cleaned it thoroughly. I tried to use again and no solution is coming out. Everything seems to being working just fine. Thanks


Here's a kinda kick yourself quick fix that might be helpful, I took my whole machine apart all the way to the motor to come to realize that the small rubber piece that cover the tip of the water container was jammed in the hole you sli ... Bissell 1770 Quicksteamer II Upright Vacuum

We have a Dyson for several years and now it is very hard to push. In fact the front edge seems to be digging into the carpet as if it is a snow plow. Is Dyson a piece of **** and only lasts a few years ?


It probably needs a new brush roll. Not surprising after "several years". On some models it's advisable, or even essential, to fit a new soleplate at the same time. An easy job and not too costly. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a Fein Turbo III shop vac for several years now...about a year ago, for no apparent reason it changed into a hideously LOUD beast! It's previously low decibel drone is now so loud it makes my ears ring afterwards...its sound is high pitched, almost like its hose is blocked, but it isn't...and suction remains good...I just can't take the sound...Help me.


It sounds like the bearings in the motor are shot. You can try to get a replacement motor, or if you're a mechanical genius type, you might be able to repair the motor bearings. If the shaft is worn, you'll have to buy a new motor.\015\012Y ... Fein 9-77-25 Turbo III Bagged Canister Vacuum

Broan-Nutone Built-in central vac. system. 1 1/2 years old. Motor will not come on on.


... Broan-NuTone VX475 Bagged Central System Vacuum

Windtunnel belt I have a new Hoover Windtunnel canister. The belt keeps coming off. It happened a couple weeks ago (several times after putting the belt back on) so I assumed I might need a new belt as it might have dried out at the store. I ordered new belts and today I used it for about an hour and the belt came off again, twice. There doesn't seem to be anything to hold the belt on the stem as it seems to slip off. I have tried it centered, to the left and to the right....can you help. I am v


I've successfully used a compatible belt - Royal 104425001 .It's still new, but for the time being at least - it works. ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

My Hoover steam vac is not spraying the water. Instead it is ejecting 5 streams. This is a new probolem and in the several years I have used it I haven't had this problem before. I can find nothing in the manual that explains it or "fixes" it;


There is a filter screen under the plastic cover below the brush indicator. If it is dirty clean it. The solution pump works off of vacuum. If this screen is dirty then the pump does not work correctly. Funny, the manual says nothing about this, only ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hi. I purchased a Simplicity Freedom about 2 years ago. I have had it in for various repairs several times. One persistant problem that the repairman cannot seem to fix is the dirt does not fall down into the bag - it just stays up around the suction hole. I only use simplicity bags. Any suggestions would be most appreciated. thank you


You can let the vacuum run alittle longer so the bag fills up with air, also make sure that the bag in on correctly and you have the right bag for the unit. Let me know if this helps. ... Simplicity Vacuums

A few years ago we bought a Dirt Devil Carpet CPR and several bottles of the cleaning solution that goes into the sprayer. We are looking now to find additional bottles of that solution. Where can we find it?


For cleaning solution call 1-800-321-1134 cost is $9 ea. + shipp ... Dirt Devil Carpet CPR Vacuum

Hoover EmPower 4600 keeps blowing circuit breaker. The number of outlets in the house that will allow me to run the vacuum is dropping quickly. It is a 4 year old house and all the circuit breakers are 20 amps. The vacuum only has a 12 amp motor. I am at a loss to solve this problem.


Take it to a friends house and plug it in if it does the same thing then the problem is in the vacuum cleaner.check your cord and see if there are anny cuts in it.you can open the breaker box then plug in the vacuum and watch the breaker box.you migh ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My electrolux oxygen vacuum cleaner shut off and will not turn back on. It's less than a year old, but I bought it off Craig's list--they were the orginal owner and they said they bought it in May of 2008. I've only used it a few times and it worked fine except for the last time when it suddenly just shut off. I thought maybe it had come unplugged and I didn't really worry about it because I was finished vacuuming. But, I went to use it tonight and it would not turn on at all--no lights, nothing


No..Electrolux is really great about warranty service. They will help you even though you are not the original owner. ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

NOTHING WORKS Used the unit 3 1/2 weeks ago, now it will not do anything except turn on. The water and shampoo will not dispense and the brushes will not turn. Is there some type of reset button that can be utilized????????? Have had unit for several years with only one other problem, the soap dispenser had to be replaced because it leaked. Teresa


Check the foam filter on the underside of the recovery tank lid, make sure that it has at least a 1/4 in. gap from the top. There also is a filter, from the bottom, it has a red frame, pull out far enough to clean it.\015\012On the bottom of t ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Heater/fan issues I have a Honeywell - Year Round Fan with 1500W Heater that shuts off within five minutes if the fan is not running too. I don't have the oners manual and can't find one online. I have read several reviews that say the same thing. The heat does do much good when the fan above it is blowing cold air. Any ideas?


There is a safety switch which will shut the heater element off if the fan doesn't run. If the fan doesn't circulate air, the element would overheat and could possibly start a fire, so the switch will shut the element down. I'm not familiar with this ... Vacuums

I have a Hoover SteamVac LS (several years old). I turned it on today and heard slight pop and then an off smell, not a burning smell though. Then after a few more minutes of operation, the SteamVac lost power and now it will not work.


You should check the cord for any burnt marks or cuts, especially the plug, if you don't see any thing it is probably a bad motor. ... Hoover Vacuums

Service problem MY NAME IS AJAY GAUR AND I BELONG TO DEHRADUN.LAST DECEMBER 07,WHEN MY SERVICE REQUIRED FOR WATER PURIFIER THEN YOUR COMPANY TOLD ME THAT IF U CAN CONTRACT FOR TWO YEARS. WE WILL PROVIDE FREE SERVICE,THE FIRST SERVICE IS ON 15-06-08 MR.SANTOSH JOSHI MOB.NO.9760356529.THAT MAN COME AND CHANGE THE CANDLE AND CARBON.AFTER THAT MY WATER PURIFIER IS NOT WORKING. FROM26-06-08 NO WATER CAME THROUGH PURIFIER I HAD DO SO MANY COMPLAINT BUT NO RESULT CAME. PLEASE TELL ME WHAT CAN I DO.BECA


Remove the inlet pipe of u v chamber and pass the water for 10 mins. again reconnect and switch the machine on.......should work now :) ... Eureka 431A Optima Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0352 seconds