Having problems with your Bissell 1698-1 PowerSteamer ProHeat Plus Upright Vacuum ?
My bissel powersteamer does not pick the water up off the carpet afer I press the button to release it.
Repair Help & Product Troubleshooting for Bissell 1698-1 PowerSteamer ProHeat Plus Upright Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
My bissel powersteamer does not pick the water up off the carpet afer I press the button to release it.
... Bissell 1698-1 PowerSteamer ProHeat Plus Upright Vacuum
While using, steam stopped coming out in force at the port levels in the head. Suddenly started high pitch whining, pressed button just above connection site and end flew off with great force pouring water onto floor and carpet. Unplugged immediately for safety and unable to get it to deliver steam force again. Less than one year old and used only 8-10 times only in walk areas where there is no carpet with distilled water. Please, advise, cannot find booklet. Thanks So Much, Beverly Crumme
Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head...Euro ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum
I have bissell Model 1697 Powersteamer Pro. i filled bucket up with water and no water is releasing when I try to steam clean, carpet is dry.Am I filling it up correctly, manual lost. Is there a way to view the online manual.
The pump belt may be worn and that is why it is not dispensing water. Here is a link where you can get the belts and you can view the manual: ... Vacuums
My bissel proheat 2x pet cleaner is not releasing water It will **** up water but it won't come out while pressing the button or on it's own It has been taken apart and cleaned
... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
When button is pressed, water does not come out of the holding canister. still seems to have suction, but water doesn't come out to rinse/clean carpet.
Please check the following with liquid in both tanks.\012 \012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\012- Check for debris o ... Bissell 9200 Upright Vacuum
Bissell carpet shampooer, how do I use it there was no manualI just need bASIC INSTRUCTIONS I'm guessing push button to release shampoo, go over the whole area, scrub as necessary, then it will **** up drity water. Question there is a rinse button Does that mean that I have to go over it again 3x?
Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.B ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
It will not dispense water when you press the release button
I've had a problem with Bissells where the handle gets out of where it's supposed to be in the handle and causes the problem that you mention. If this is your problem, the handle will feel different and looser. Good luck! ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum
My carpet cleaner is not spraying out water or solution. motor is working, heater is working but nothing coming out when i press the button
Check if bottom of solution tank and/or lines are gummed up. Clean and blow out lines and inspect check ball assembly.\015\012Hope this helps. Could use more info.\015\012Bob ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
Steam not comming out when button is pressed. water boils steam builds and the only was to release is to unscrew cap slowley.
Corrosion prabably built up in the hose or end tip ... Dirt Devil PD20005 Handheld Steam Cleaner
I have a Bissell Proheat 2x cleaner which has worked perfectly on every occasion. Today I filled the machine as usual with water and formula and switched on, the motor ran, the lights were on and the brushes rotated but upon pressing the spray trigger no water or formula was released. I have cleaned the jets underneath and also followed instructions to release any airlock. It still wont release the water/formula. What else can I do? Thanks Charles
Please check the following with liquid in both tanks.\015\012 \015\012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\015\012- ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
Replaced the pump for a 9300 M Bissell Proheat 2x as the water solution was not releasing to the carpet. Once rehooked the lines the solution appears to be coming from the water tank and returning to the used tank and bypassing spraying on the carpet. How can I be sure the hoses are hooked up correctly?
Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
Hi, I've a Tefal Steam Generator Express Turbo 2910. It won't "steam". The solenoid works when the button is pressed. The pump works. I've cleaned the tank (with white vinegar as recommended on this site!) thoroughly. The water from the steam tank is only "hot" (not scalding as I'd expect it to be). When first switched on and hot enough there is the TINIEST whiff of steam when the button is pressed then nothing more. Do you think this could be the Thermostat Part CS00094126, or can you
My hoover steamvac powermax is releasing the water to clean the carpet but there's no suction power so the water is remaining in my carpet
... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum
Release button Where is the release button to adjust the vaccum from its upright position, so I could vaccum carpet?
There is no button. You are supposed to place your foot on the area above the rolling brush and hold the base down while pulling the handle back.There is a small metal clip under the vacuum that you should bend out a bit to make it easier to re ... Euro-Pro UV209 Upright Vacuum
Hello i can turn my steam buddy platinum 44G258 on, water boils, press hand gun get a buzzing noise like you do with a jet wash, but no steam comes out, it seams the water is not coming through, have check the cap on water container thats ok, its where it releases the water to is seams to be where the problem is, i think ! first time we have tried to use it many thanks steve.
How to release and withdraw water solution to clean carpet.
Problem resolved by contacting a local retailer who provided instructions. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum
The Lower body of the Bissell QuickSteamer, water pours out from the body. Solution: I took apart the machine and there is a spring loaded valve with a rubber washer at the bottom. Think of the letter T upside down with the rubber washer on it. The washer stretches over the bottom and the spring creates a leakproof plug and won't allow water to pass till the button on the handle is pressed. This old washer came partially off and allowed water to leak. I purchased from the plumbing dept. a mi
... Bissell Vacuums
I am using a hoover steam vac and the button keeps popping up to say that the water is full. That makes the thing stop sucking up water out of the carpet. Problem is, it has barely sucked up any water yet. Help!
Have u tried cleaning it out really good make sure any areas that water is **** up through are free of hair, lint ect. ... Hoover Vacuums
Water will not come out when i push on trigger button. So water does not come out. I have taken it apart and cleaned it. The problem seems to be in the triggerI push on the handle to release the water.
Order the part from bissel see if that fixes sound like you know what wrong just need get part number from bissell.Could be some kinda pump also thats bad not pushing out the water.I got bissle heated one black it only problem the seals r ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
I have an Electrolux Oxygen 3 Ultra Canister Model No Rel7020. I am having problems with the On/Off Button and the Bare floor/Carpet Brushroll On/off button. The Carpet On/Off will not work at all. In order to turn the vacuum on, I must press a combination of the first two buttons. Is this an electrical issue
You have a problem with the electrical switches. If you are comfortable with this, take apart and double check internal wiring to make sure nothing was frayed, or disconnected. Make sure it is unplugged. If you know how to operate a multimeter, yo ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum
Bissell pro heat steam carpet cleaner, not releasing water.
That means that you need to replace the pump belt. Here is the belt you \012need and a manual you can view:\012\012Bissell 7901 Belt and ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
My Steam Vac won't release any soap water mix
\015\012My model number Bissell is different than yours, but many models work similarly.\015\012 \015\012Capt. Obvious fixes: Water flow often stops unless b ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
Carpet Powersteam water tank no dirty water goes in
... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
I just bought a Bissell Proheat Plaitnum 2 powersteamer at a yard sale that looks like it has hardly been used. So far I'm only able to get the water onto the carpet by using the hand tools. When I put it on floor mode it will suck up the water but not dispense it.
Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum
I have a Model F7431-900 and is a SteamVac V2. When I press the trigger for water or cleaning solution, the water just runs right through it even after releasing the trigger. What kind of problem do I have? Is it most likely a valve problem? I'm handy at fixing things and want to avoid the large repair bill if I take it in.
This sounds like a stuck solenoid. The Dual V models use solenoids to contol soap and water flow to the floor, along with a pump unit. If your unit is 12 months or less it is under warranty. I am not sure about the cost of the solenoid. ... Hoover SteamVac V2 6-Brush Widepath F7426-900 Vacuum