Having problems with your Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum ?

Pro-Heat Facility Off

\015 I have a Bissell 1698-k which has the pro-heat facility, I need to claim a pursian rug and need it not to heat the solution, is this possible?\015

Answers :

The solution `wich comes out of the hose is unheated ,you could clean the rug with the machine set to the tools mode and use the hand tools .
\015\012The solution wich sprays out to the floor is heated ,you cannot turn the heater of.
Repair Help & Product Troubleshooting for Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Pro-Heat Facility Off


The solution `wich comes out of the hose is unheated ,you could clean the rug with the machine set to the tools mode and use the hand tools .\015\012The solution wich sprays out to the floor is heated ,you cannot turn the heater of. ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Bissell Pro Heat 8910 clogged?


Why the motor sounds muffled I am not sure. When the water is sucked up, it goes directly into the tank. The motor only creates the suction so it can do that. There should be a filter on the rim of the recovery tank lid, is it clean? Other then p ... Bissell 8910 ProHeat Clear View Upright Vacuum

I have a bissel pro heat carpet cleaner that doesn't spray cleaner solution, everything else works, but I don't know whether it's the pump or the heat unit.I'm assuming that the pump unit must be bad since all the connections are in place, but from the view of the pump I am not sure what drives it.


I have a bissell steam cleaner 1698. I have had it for a few years. First and last time I used it I was sorely disappointed. How was the word steam integrated into the name. I saw no steam. Ended up soaking my couch, soaked spots on my rug and n ... Bissell 1693 PowerSteamer Upright Vacuum

I Have a Euro Pro X, Model EP8020 it just heats up very low will not heat anywere near high


... Vacuums

Need a top cover for our Bissell Pro - Heat Pro-Tech 7901W as the spaces where the screws go through to the base have broke through. Where are the service or parts stores located?


You can go to bissell.com to get help. But you can also use a longer screw with a washer to use in the back 2 holes, that will tighten up the top to the base. Or you can order a replacement top. You can check with your local repair shops to see if ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

How to change pump belt on bissell pro heat - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


First take off the cover on the left side oif the top cover, then turn it over, remove the screw holding the red lock and pull the cap and brush roll out, remove the cap, remove the cogged belt, then you can put the new pump belt thru that slot, put ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My bissell pro heat 2x does not **** up the water from either the upholstery cleaner or carpet cleaner. Any thoughts as to why? The water and heat functions work it just does not pick up


First check the motor duct gasket. The motor duct gasket is visible once the tank is removed. It is located underneath the handle on the top of the base of the machine. It has a black rubber coating around it. If there is no suction there please let ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell pro heat not spraying water - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Truction for bissell pro heat turbo 2x - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My bissel pro heat cleane's brushes stoped. I checked the belts. They are okay. There is no sign of heat or problems around the motor. Is there a mercury switch some where in the handle so the brushes only turn when the handle is lowered?


Depending on which model you have, you did not say, if the cogged belt goes to the pump pulley, the cogs may be wore away or and won't turn the brush roll. On some other moels, there is a brush roll motor that may have gone bad. ... Vacuums

Bissell Pro-Heat Pro-Tech Carpet Cleaner


Put the piston on the bottom part of the knob, You want the the knob to be at the water only setting when it goes into the slot. After the top is pushed all of the way on, turn the auto-mix knob to see if it is turning easily. If it doesn't stop, ... Vacuums

Hello.....my Bissell pro heat pro tech does not disperse the water....would you know why


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Bissell pro heat steam carpet cleaner, not releasing water.


That means that you need to replace the pump belt. Here is the belt you \012need and a manual you can view:\012\012Bissell 7901 Belt and ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bissell Pro Heat 2x steam cleaner, problems!


Must likely the brush motor is bad. The top cover has to come off to check it, this is where the tank sits on. Part # 2036757 and is #35 in the pix.\015\012\015\012 ... Vacuums

Brush not moving in Bissell pro-heat


If the belt is more then 6 months old or more, then the belt will have to be replaced reguardless of the way it lookes. belts can stretch over time and when you put the machine on the carpet the friction causes the brush to stop because the belt has ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I have a Bissell pro heat water will not disperse from


If the red spray pieces are not clogged but the Bissell still will not dispense water, then I would say the next most likely causes of your issue was either no soap in the tank, or a burnt out water pump. But since you can get water through the tool ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Bissell Pro Heat 2X will not release water or


Its probably a solenoid that controls the flow to the floor, take it to a bissell repair center, because its not an easy fix. ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

Bissell pro heat 2 puts out too much soap


... Bissell 8910 ProHeat Clear View Upright Vacuum

Ididn't receive a manual with my 9300 pro heat cleaner


Http://www.bissell.com/images/UserGuides/9200_608spn.pdf\015\012\015\012\015\012hope this helps you ... Vacuums

Replacement electric motor for Bissell Pro Heat 2x Select carpet


Bissell proheat i can spray solution from the handle but it has no suction help ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My pro bissell heat leaks.


The pop sound was an electrical component blowing inside the vacuum, probably one of the capacitors on the motor control board.Water is not leaking from the tank, water is getting released because the motor is not generating enough power ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bisssell pro heat 2X


The hose should wrap around on the back by the cord. The holder is made to hold the hose as well as the cord. ... Vacuums

Bissell pro heat 2x multi surface carpet cleaner making spots


Maybe there's not enough vacuum or it hasn't been primed enough. I have a proheat that drove me crazy till I started leaving the heat switch on. I get wads of carpet fiber that mat around brush and spit out on the carpet, so I frequently remove them ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a bissell pro heat water wont come out


The pump may spin but the vanes inside could be broken or worn enough that they are unable to push water through the pump system. I am repairing a Bissell Model 8920 Pro-Heat 2X that has this very same problem.\015\012\015\012I tested all ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

How much soap and how much water do I put in the Bissell pro heat?


You are supposed to buy the Bissell soap. On the bottle depending which cleaner you need. The directions are on the bottle. Please do not use house hold cleaners because you can cause serious damage to the vacuum.\015\012Go here, this pg. shows ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0201 seconds