Having problems with your Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum ?

My Bissell 25A3 ProHeat wont spray water - Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum


Answers :

I had two problems. No water was coming out of the main unit (it was working fine via the powerbrush) and the flow indicator wasn't spinning. Because I'm out of warranty, I did two things (after trying all the options that were posted).
\015\0121. Removed the top of the main unit. There are 4 screws on the top back lid. Once you remove those, lift the back up towards the front. The front is snapped under the bottom casing. It should come up with a little pressure, but don't force it. With the top lid removed, I had to clean several of the rubber hosing by removing them and running under warm water. I actually used a long wooden skewer to scrape the grime in the tube. Make sure you do one tube at a time and replace in as it was before moving to the next one. While you are at it, make sure the 2 sprayers on the front are clean as well. They are either orange or yellow and rubber tubes also feed into the sprayers. After I finished, I replaced the lid. It it still wasn't working, so I tried step 2.
\015\012
\015\0122. Remove the hose assembly from the main handle. 2 screws and 2 bolds (don't lose the nuts from the back). Once the hose assembly has been removed, then lift off the top part of the handle. Once the top is off you should be able to open the front lower part of the handle exposing the additional electrical and more rubber tubbing. In the middle is rectangular looking object. That is the water heater. If you just ran the vacuum, do NOT touch this as it will be hot. Wait for it to cool. check the connections of the rubber tubing and make sure they are clean. In my case the tube going in to the heater was all blocked up with cleaner solution. Once I cleaned that up an reassembled in reverse order, the unit worked fine.
\015\012Hope that helps you.
I have a Proheat 2X and had the same problem. I tried the Water Rinse setting and found water came out and was suctioned properly, but on the Light Clean, Normal Clean, and Heavy Traffic settings, the unit failed to do anything. Problem may be with leaving the soap dispenser in-place, which might scum up the tubing.

SO, an alternative to throwing out my unit and buying somethign else was to put one capful of the Bissell soap in the water resevoir and keep the unit on Water Rinse. IT WORKS BEAUTIFULLY NOW. Don't know if this will help, but at least I didn't have to buy a new unit. Rinse everything after using and there's been no problem.
Repair Help & Product Troubleshooting for Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Bissell 25A3 ProHeat wont spray water - Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum


I had two problems. No water was coming out of the main unit (it was working fine via the powerbrush) and the flow indicator wasn't spinning. Because I'm out of warranty, I did two things (after trying all the options that were posted).\015\012 ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

My bissell proheat wont disperse water - Bissell 1698-1 PowerSteamer ProHeat Plus Upright Vacuum


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.B ... Bissell 1698-1 PowerSteamer ProHeat Plus Upright Vacuum

My bissell wont spray water or suck up water - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissel pro heat 2x wont spray any water - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


I had the exact same problem with my ProHeat 2. It would spray only through the hose attachment but not on the floor. Cleaning of the spray endings on the floor unit fixed my problem. Either soap deposits or dirt was clogging the spray endings. Here ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Wont spray water bissell x2 - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


Does any water comes out maybe it is clagged ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Water wont spray out - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Sorry to hear you're having difficulty with the spray. Here's a quick link to troubleshooting. \015\012http://www.bissell.com/FAQDetail.aspx?id=1065& ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Water wont spray from fabrac cleaning hose - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


Roller wont turn ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Wont pick up water or solutuon from floor - Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

ProHeat Turbo Deep Cleaner Upright Steam Vacuum: Hello, My Bissell Proheat is not spraying water, ...


Most likely the pump belt is worn and needs to be replaced. Here is the belt you need: Bissell Proheat Pump Belt ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell proheat isn't spraying water out - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Hi,As the weather is getting warmer for many people their freezer and/or refrigerator do not work right because of a dirty condenser coil...there are also many other things that can go wrong. If you are hearing a clicking or buzzing ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell proheat 2x not spraying water - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


Please check the following with liquid in both tanks.\012 \012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\012- Check for debris o ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell 9500 ProHeat 2X does not spray water - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.B ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell preheat won't spray water - Bissell 7950 ProHeat Upright Wet/Dry Vacuum


... Bissell 7950 ProHeat Upright Wet/Dry Vacuum

Bissell pro heat x2 will not spray water - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell pro heat not spraying water - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My bissell 1694e wont spray water - Bissell 1697-7 Powersteamer Pro Deluxe Vacuum


... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

Bissell won't spray water - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be o ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Not letting water out of vacuum - Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum


If it is not pumping water out of the vacuum that means that the pump belt is worn. Here is a link to the belt you need and a manual you can view: ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

My bissell does not **** up water very well - Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

My bissell wont spray - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Depending on which bissell you have; I would check the heater. If it is a newer module I would check the solenoid switch. The heater heats the soap up so much that it clumps the soap up and clogs both of these parts. I would also check the tips thems ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

How to get water to spray on my bissell 8920 - Bissell 8920 ProHeat 2XTM Upright Vacuum


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8920 ProHeat 2XTM Upright Vacuum

My bissell 7950 proheat wont spray water - Bissell Vacuums


... Bissell Vacuums

Won't spray water or cleaning solution - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


I have had that happen also, I took the solution container off and pressed the part where the solution would be released into the machine.. worked fine after that ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Water is not getting through to carpet - Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum


Check all hoses and make sure the pump is working ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Wont pick up water - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


If it does not pick up water and the vacuum motor is running you have either a blocked hose or a bad gasket allowing vacuum pressure to escape. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1335 seconds