Having problems with your Bissell 16N5 Upright Vacuum ?

Reset button for bissell - Bissell 16N5 Upright Vacuum


Answers :

- Make sure the power cord is plugged into a functioning outlet to check for power.
- The handle may not be installed properly, causing a loss in the power connection. Remove the handle completely. Slide the handle back into place on the lower section of handle and tighten the screw.
- With the machine turned off and unplugged, check the pre-motor filter and the Airetight\342\204\242 HEPA filter for debris. Reduced air flow from dirty filters or clogs will put greater stress on the motor, increasing the possibility for overheating. The pre-motor filter is located underneath the canister of the vacuum in the pull out tray labeled "filter". This may be hand washed in cold water with mild detergent. Reinstall this filter when it is completely dry. The Airetight\342\204\242 HEPA filter cartridge needs to be replaced and cannot be washed. This is located on the side of the machine inside the filter grill.
\015\012


\015\012

CLEARING CLOGS
\015\012

NOTE: Ensure the machine is turned off and is unplugged before checking the following.
\015\012


\015\012

DIRT CUP AREA
- Empty the dirt cup. Remove the lower portion of the cup and clean the screen and check the center tubes for dirt accumulation.
- Check the dirt inlet. This is the opening located behind the canister and is only visible once the canister is taken off the machine.
\015\012


\015\012

UPPER HOSE
- Detach the hose from the machine by twisting the hose collar counterclockwise. Push a broomstick into the hose to push any obstruction to the end of the hose where it can be removed.
- Check the clear diverter area at the back of the machine. When the hose wand is removed from the base, the diverter should be in the up position. If a clog is visible near the diverter, remove the divertor cover by removing 7 screws and clear the obstruction.
NOTE: Be careful not to dislodge the gasket.
\015\012


\015\012

LOWER HOSE
- Recline the machine back and roll it over so the backside is facing up. Remove the bottom 4 screws from the diverter cover to loosen, and straighten the foot hose. Look through the hose for obstructions. Push a broomstick through the lower hose to unclog this. (Any obstruction should exit through the suction path at the brush roller).
\015\012


\015\012

NOTE: The Healthy Home Vacuum is equipped with a Thermal Protector feature to prevent the motor from overheating. If the motor becomes too warm, the thermal Protectors will activate and the machine will shut off automatically. If the Thermal Protectors activate, please do the following:
\015\012


- Turn off and unplug the vacuum. Thermal Protectors will reset automatically in approximately 30 minutes.
- Clear any clogs.
\015\012


\015\012

If you continue to experience no power, please take your machine to a local BISSELL Authorized Service Center. BISSELL supports your machine with a five year warranty.
\015\012


\015\012

To locate your nearest BISSELL Authorized Service Center, please go to www.bissell.com. Click on the Customer Support tab near the top of the homepage and enter your zip code in the Service Center locator box to perform your search.

Repair Help & Product Troubleshooting for Bissell 16N5 Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Reset button for bissell - Bissell 16N5 Upright Vacuum


- Make sure the power cord is plugged into a functioning outlet to check for power.- The handle may not be installed properly, causing a loss in the power connection. Remove the handle completely. Slide the handle back into place on the lowe ... Bissell 16N5 Upright Vacuum

Bissell healthy home reset button - Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue


... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

Is there a reset button on bissell 12 amp - Bissell 3750 Lift Off Bagless Upright Vacuum


... Bissell 3750 Lift Off Bagless Upright Vacuum

Cant find reset button - Bissell PowerForce Turbo Helix Bagless Upright Vacuum, Black/Red, 68C7


Hey Troy, the PowerForce Turbo Helix doesn't have a reset button. You may want to have a Qualified Technician at at BISSELL Authorized Service Center inspect your vacuum. Here's a quick link to assist you in locating one in your area.\015\012 ... Bissell PowerForce Turbo Helix Bagless Upright Vacuum, Black/Red, 68C7

I have a kenmore progressive direct drive handi mate jr. upright vacuum. My daughter used it last night to vacuum up some cat litter that had spilled on the floor. I went to use it today and it turned on for a second and then stopped working. I have hit the reset button but it will not turn on. Help this vacuum is only 2 years old Is there anything that I need to reset or do so that the vacuum will work again?


Its probably clogged up with cat litter.might have gotten into the motor.your motor has a motor guard inside if it. when it overheats it will shut down till it cools off.you need to clean all th cat liter out of it.and clean the filters.with a direct ... Kenmore Vacuums

Now that I just fixed my Lux Legacy canister vacuum, I need help on my other Electrolux Regency Series upright! The vacuum works fine but the rotating brush does not work and the brush motor does not turn on. Tried cleaning the brush and hitting hte reset button to no avail. This upright has a triple setting switch and I checked the each of the wires seem to be attached. Tried rotating the brush by hand and it would not budge. Was going to "encourage" the brush to turn with a set of articula


There are a couple rectangular holes on the bottom of the power nozzle, beside the wheels. These have tabs in them that need released with a standard screwdriver. \015\012 ... Vacuums

Reset button on riccar upright vacuum


I CANT SEEN TO GET THE TOP TANK TO SNAP BACK IN, IT KEEPS SPILLING THE WATER AND SOLUTION ... Riccar 8955 Upright Vacuum

Is there a reset button for the bissell healthy home vacuum cleaner? I was vacuuming and sucked up a door mat and it turned off and will not turn back on


... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

IS THER A RESET BUTTON ON THE VACUUM - Dyson DC28 Animal Bagless Upright Vacuum


No there is no reset button it's got built in auto reset thermal resets after 30 minutes if it overheat one of the mane causes is blockages and dirty filters, the link below is for the manual if you need it ... Dyson DC28 Animal Bagless Upright Vacuum

Bissell 6594 power button stuck - Bissell 6594 PowerForce Bagless Upright Vacuum


... Bissell 6594 PowerForce Bagless Upright Vacuum

Brand new bissell #6583 upright vacuum worked for 15 min


The belt may be broken. The following link is to the User's Guide which explains how to check and replace the belt if needed.\012 ... Bissell 6594 PowerForce Bagless Upright Vacuum

Where is the reset button on the Riccar 8995 - Riccar 8955 Upright Vacuum


The reset button on the Riccar 8955 is located on the back of the vacuum cleaner, at the very bottom, right above the rear wheels. You can push the reset button with a ball point pen or something similar. ... Riccar 8955 Upright Vacuum

Is there a reset button on the dyson - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


The short answer: No.\015\012The longer answer begins with a question: why do you need to know, what's happened to make you ask?\015\012Most Dysons have a built in cut-out system that stops the machine if it gets too hot. This usua ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

It wont turn on...is there a reset button? - Hoover U5134-900 Bagged Upright Vacuum


... Hoover U5134-900 Bagged Upright Vacuum

Where is riccar reset button> - Riccar 8955 Upright Vacuum


The reset button on your model 8955 is in the back, on the left side at the bottom. It is a white button ... Riccar 8955 Upright Vacuum

Picture of reset button on dyson ball - Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum


Hi there,The advice on resetting your machine will depend on which model of Dyson Ball you own. If you have a DC15, you can reset the machine by following the steps shown in our online support guide: ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

Does it have a reset button - Hoover U5399-900 WindTunnel Lite Upright Vacuum


... Hoover U5399-900 WindTunnel Lite Upright Vacuum

The brush on my bissell prolite multicyclonic vacuum won't turn. It seems like it is jammed, but I checked for anything that might be stuck in it and don't see anything. Is there a reset button?


I had the same problem with my old Bissell sweeper ( I bought a new rotating brush each time this happened then I bought a new sweeper the next time it happened -last Dec. 2009.) Unfortumately I bought a new Bissell and now it is happening again to ... Bissell 17G5 PROlite MultiCyclonic Bagless Upright Vacuum Cleaner

Where is the reset button on a dc14? - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum


There isn't one. If the motor is not running you might have a bad on off switch or this model does have a heat sensor that shuts down the motor that may be faulty. You will need to send it back to dyson. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Where is the reset button for my upright dyson vacuum cleaner brush? Model DC17 Animal


Hi \015\012\015\012There is a switch for the brush bar. It's on the handle right beside the main on/off switch. There is no "reset button". The motor has an automatic cut-out, which will operate if the motor gets too hot and will reset it ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

DOES THE DYSON ANIMAL HAVE A RESET BUTTON. - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum


Normal\012 0\012 \012 \012 false\012 false\012 false\012 \012 \012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012 \012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-s ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Does it have a reset button? - Hoover U5172900 Fold Away Widepath Bagless Upright Vacuum


There is no reset button on this model. If the motor shut off it is due to the motor getting too hot. This can be caused by poor aire flow, usually afull bag or clogged filters. The vac is designed this way for safety. ... Hoover U5172900 Fold Away Widepath Bagless Upright Vacuum

I have an Electrolux Commercial Upright vacuum Model U129C. It has a device which turns off the motor driving the beater bar if something gets stuck in it. There is a simple reset button to restart the beater after clearing the obstruction. Just recently on flat dense low pile surfaces the switch cuts in after just a few seconds and turns the beater bar off. This doesn't happen on high pile carpet but the motor doesn't quite sound normal. There is no obstruction - the beater bar can spin freely


The motor is having a problem.There might be two reasons...either the coils inside it got heated up which will be needing rewinding or you can buy a new motor or there r capacitors attached sometimes u can make a check on that also if that's gone Kap ... Vacuums

Where is the reset button on a Kirby G4D upright vacuum cleaner?


Hello, justincI was trying to help you out here. Maybe this will help some? I was going backto some customers that asked questions in the recent past and even fartherback. It appeared that no one answeredsome of them, So, I thought I would ... Kirby G4 Bagged Upright Vacuum

My question earlier today referred to a Kenmore Progressive upright vacuum. Your answer suggested that I change a belt, if the reset button did not work. Does a direct drive really have a belt? Regards, Jim Buckley


Direct drive does not have a belt. It is a shaft with gears. What is wrong with your vaccum? Maby i can help. ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1212 seconds