Having problems with your Bissell 1720-1 Little Green Wet/Dry Vacuum ?

The clip that secures the Solution/Clean water tank on my Bissell Little Green Model #1720-W is broken so that the tank does not stay in place on the machine

\015 Is there any way to replace this clip and if so how.\015

Answers :

Repair Help & Product Troubleshooting for Bissell 1720-1 Little Green Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The clip that secures the Solution/Clean water tank on my Bissell Little Green Model #1720-W is broken so that the tank does not stay in place on the machine


... Bissell 1720-1 Little Green Wet/Dry Vacuum

I have a Bissell Little Green Scruber Model #1720-W that has a broken clip which secures the solution/clean water tank to the front of the machine. Where can I purchase the clip to repair this machine


... Vacuums

How do I fix Bissell Quicksteamer leaking from water tank through wheels? After I place the filled Clean/Solution tank on the Lower body of the QuickSteamer, water pours out from the body of the machine through the wheels even before I turn the power switch on. I checked the tank and there are no holes in the plastic tank.


I have the same problem... seems to be because of a bad, or worn, rubber gasket. ... Bissell Vacuums

Have a spin scrub a couple of years old. Have used it maybe 5-6 times and the green brushes only spin if you take the tanks off and set the machine upside down and push the brushes toward the machine... the second you stand the machine up they quit spinning.


Repace the belt ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Broken Elevator? One side of my brush will not stay up. Could this be a broken elevator? I think the elevator (black piece) has fallen into the machine. How do I get into the bottom to get the piece out and repair/replace it?


Asdasd ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I HAVE LOST MY INSTRUCTION BOOK FOR THE STEAM VAC SPIN AND SCRUB. I WANT TO USE THE STAIR ATTACHMENT, BUT I CAN'T FIGURE OUT HOW TO HOOK IT UP, OR OPERATE IT. I SEE WHERE THE PLUG IN PART GOES IN THE FRONT OF THE MACHINE, BUT I CAN'T GET THE OTHER PART TO SLIDE INTO PLACE ON THE FRONT OF THE RESOVIOR TANK AFTER I REMOVE THE FRONT PANEL, AS THE DIRECTIONS ON THE FRONT OF THE RECOVERY TANK SAY TO DO. THE FIT IS JUST TOO TIGHT. WHAT AM I DON'T WRONG- OR HOW COULD I GET A REPLACEMENT INSTRUCTION BOO


You can download a PDF version of the manual at the link below. I believe you can contact Hoover as well and they might mail you one.http://www.hoover.com/CustomerService/Manuals/Default.aspxGood Luck! ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Broken piece The black plastic octagonal end of the brushroll has broken off the brushroll, so the brushroll won't stay in place. Can I get another little piece to attach onto the brushroll? Or do I have to get an entire new brushroll? And if so, do they sell replacement brushrolls? CP


You will have to replace the brush roll, part #60844-5, belt # 61120B. You should be able to get them from a repair shop, get the right one or it won't work right. You maybe able to go eureka.com and order direct. ... Eureka 4700A Maxima Bagless Upright Vacuum

Bissell Big Green Machine just stopped working in mid-clean. Have emptied tank, rinsed tank, checked belt, checked brush and still nothing. Have even changed outlets. Suggestions?


The motor could have fried or the wires have been shaken off the motor terminals. ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

I have a proheat carpet cleaner model 3 7901. the problem is the brush on the bottom of the machine plus the two end parts and the belt came out. i put everything back but they popped out, they are not staying in place. what am i doing wrong or what do i have to take out to get everything in place correctly?


Hi\015\012\015\0121. You’ll need to follow this procedure to assemble your unit back together.\015\0122. Make sure the foot pedal is in the proper position.\015\0123. The SmartMix should be properly loaded into the main ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Little green machine pro heat pet the collection tank wasn't collection and dirty water was coming out of the bottom. i took it apart, cleaned it up and put a new "duckbill" gasket in. then it quit spraying, but i think i got that working again. now after i spray and get a good foam on the carpet, i switch to suction and it seems very weak. i can see the water moving (trickling) from the head into the hose but it is not reaching the collection tank -- actually, i am not sure where its goin


... Bissell THE BISSELL LITTLE GREEN MACHINE Vacuum

Vacuum will not stay on, new bag in place and power to machine.


It sounds like you have a bad control valve. Take it to you nearest Aerus (formerly Electrolux) dealer and have them change it for you. It shouldn't be too expensive. Good Luck!! ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Does the Big Green Clean Machine have a seperate water tank? I got one for free from somebody with no instruction manual and want to wash carpets. Please help?


No, it has an inner wall. Here is a link to the user's guide on bissell.com: http://www.bissell.com/downloadfile.aspx?id=544&cid=ccsocialAddit ... Vacuums

MODEL F7226-900 ON THE SMALL TANK THAT THE CLEANING SOLUTION IS IN THE SPRING WILL NOT STAY IN PLACE WITH THE OTHER PEACE WHAT DO IDO BILL . THANK-YOU


... Hoover F7205900 SteamVac V2 Wet/Dry Vacuum

My 9 year old Sebo X4 will not stay in the upright position. The foot pedal no longer springs back to hold the machine in the upright position. Has a spring broken? Which part needs replacing?


... Sebo X4 Bagged Upright Vacuum

The cantister on my DC04 no longer stays secure when in position. It does not snap and lock into place as before. I found a small plastic tab about 1/4 inch deep and less than an inch wide on the floor. Looks like it has broken off the lockin mechanism any suggestions?


Check your warranty. If it's still good read to find out if this part is covered (probably not) and where to take it for repair or replacement of the tank. \015\012Unfortunately, it may turn out you'll need to buy a new vacuum. ... Dyson DC04 HEPA Bagless Upright Cyclonic Vacuum

My Shark 3501 has a broken handle above the resevoir. Called Euro pro and stayed on hold for 25 min with no answer. I am looking for a handle from top down to tank. Can you help?


Hi,No, you need to call them... check the manuals link...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My Little Green Machine has stopped sucking (second one with this problem!) I have removed the bottom plate and cannot find how to get to the hose to determine if there is a blockage. How do I do this? There is a screw that seems to hold a piece in place but it does not come out to get access to the hose.


Remanufacturing is a big problem since we don't know what was changed and how. ... Bissell Vacuums

I have a Polti leco aspira 710. The water in the tank is heating but when the trigger is activated no steam comes through. The machine is showing one green light and is emitting a continuous beep. The vacuum cleaner is working fine - but no steam at all


... Polti Vacuums

When I try to turn my clean solution tank upside down to put it on machine solution pours out the cap through a pin hole in spout cover that goes over the place where you screw it on.


... Vacuums

Sew- Prow Sewing machine Model ZZ- 401 need diagram to order part and manual. Has broken missing parts in spool area spool wont stay in under needle Davy B


Hi!!\015\012\015\012Try this sites\015\012Hi!\015\012\015\012It seems that this is a common problem for this machine. I think you will be better off getting a new machine for $50 at this site\015\012 ... Vacuums

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl


There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

Bissell big green clean machine trigger problems


... Bissell 1672 BIGgreen Wet/Dry Vacuum

I have a new scoba (irobot) the battery is charged the tanks were fillied and every time i hit the power button and then clean the machines "check the tank" light came on. i have done all the proper instruction checks an i have done all the trouble shooting section. the machine will only work (and that is for 5 minutes drying its head) when i hit power and the clean button twice. so obviously the machine is somewhat working


We had to prime the sensor. irobot suggested a turkey baster, but we didn't have oneso we used an empty visine bottle with the end snipped off and rinsed completely. this worked after the first try. thank you for your interest ... iRobot 5800 Scooba Vacuum

My little green machine won't spray the solution but it will pick


We had the same problem. After dissassembling the whole machine we could not find a clog or any other obvious problem. The manual suggests priming the pump by putting the solution reservoir in and out a few times. This did not help much. What did ... Bissell LITTLE green Compact Multi-Purpose Cleaner Vacuum

I have an older model F6056-900 Hoover steamvac Spin Scrub Cleaner. My first problem was that I loaned it out to a friend. Anyway she ran over the hose (used for attachments) with her car. I tried using the cleaner for carpet cleaning this morning but when I tried to put the solution tank into place...its loose...won't snap back in like it used to. When I can get it somewhat in place the solution just complete drains out through the bottom fo the tank. The leak is where the small hole on the bot


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0675 seconds