Having problems with your Bissell 1770 Quicksteamer II Upright Vacuum ?


Answers :

Remove the dirty water tank and see if the front nozzle is fitted correctly, also see if the filter is clean on the dirty water tank
Repair Help & Product Troubleshooting for Bissell 1770 Quicksteamer II Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :


Remove the dirty water tank and see if the front nozzle is fitted correctly, also see if the filter is clean on the dirty water tank ... Bissell 1770 Quicksteamer II Upright Vacuum

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!

Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

The cleaner/water solution dispenses into the carpet, cleans it, pulls out the pet hair, but no dirty water goes into the dirty water reservoir! is all this dirty water going into my carpet?

The pet hair may be clogging the water return inlet I suugest you clean the bushes and inlet as well ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Solution will not exit fresh water tank

The early models of this machine had a pretty ugly defect in the clean water tank. They had all kinds of problems with them and now have a completely different tank to replace the old style. It sounds like you have a defective tank. When the tank sit ... Hoover F7220900 SteamVac V2 Upright Vacuum

My bissell steam cleaner Model #9200P purchased 12/12/12 and only used once does not soak up the dirty water from the carpet. The bladder dispenses water and the solution is dispensed but the dirty w

Hi Barbara. I understand how frustrating no suction can be when you're trying to clean. Here's a quick link to troubleshooting steps to assist you: \015\012 ... Bissell 2X Proheat 9200 rug cleaner

I own a Bissell Proheat Pet Model 8910. After just a few uses and changing both the brush and pump belts (trying to resolve problem) carpet doesn't get wet any longer. Carpet solution comes out normally but the water barly leaves the section of the tank I fill water into, resulting in carpet recieving to much solution and not enough water. Any advice?

... Bissell 8910 ProHeat Clear View Upright Vacuum

Bissell Powerease Lighweight Deep Cleaner. (Shampooer) After I fill the solution tank with the solution and water, I put it in it's slot, but all of the contents just come flowing out. I have only used this machine twice and it worked ok. You are supposed to press the trigger and the solution sprays out and then release the trigger when you want it to stop. But like I said, now I just put the tank on and all the contents come flowing out. I don't know what's wrong or how to stop it.

... Vacuums

Replaced the pump for a 9300 M Bissell Proheat 2x as the water solution was not releasing to the carpet. Once rehooked the lines the solution appears to be coming from the water tank and returning to the used tank and bypassing spraying on the carpet. How can I be sure the hoses are hooked up correctly?

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Is this free? i have a bissell carpet cleaner and i cannot get the soap and water to come out. it will **** up the dirty water however. i just found the belt is broken but i can see no way of how to put a new one in. is a broken belt the reason no soap is coming out?

If it is the flat belt that broke, that is the pump belt, the pump can't work without it. To replace the belts, turn the unit over, remove the red holder, has one screw, pull it out, then the brush roll will come loose. You can replace the belts th ... Bissell Powersteamer 1694 Upright Vacuum

When button is pressed, water does not come out of the holding canister. still seems to have suction, but water doesn't come out to rinse/clean carpet.

Please check the following with liquid in both tanks.\012 \012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\012- Check for debris o ... Bissell 9200 Upright Vacuum

I have a hoover steamvac dual v and is leaking, bristels not working very food only two are speaning and is not sucking any water Very little solution comes out, or comes out in streaks when pressing the solution dispenser button on the handle. I think the lines may be stopped upped.

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=41020&thid=634728\015\012I have a Hoover SteamVac\015\012Posted by albazo on May 30, 2008\015\012I have a Hoover ... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

Water will not come out of cleaner, solution will but water won't

If you emove the solution tank youy will see a connector where the tank meets the connector.that is what lets the solution through ,its most likele cloggedlook and see if there are some holes in the connector and poke them with a paper clip.same goe ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Water comes out when trigger is squeeze but wont **** up dirty water

A. Is your floor/hose knob in the correct position?\015\012B. Do you have suction at the hose end, when in that position?\015\012C. If you answered yes, no in that order then either your motor (provides the suction) is going bad, or it si ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My bissell proheat is not sucking up water, the solution comes out but when I went to empty the water holder I only had about one fourth of the water that I had in their and the carpets feel very wet.

This is easy. remove the plastic top that snaps to the part that holds the water bladder. Instide that top piece is a red door... and behind that flapping door is an air filter.... remove all the crud stuck to it and you should be good to go. No t ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My Bissell Quicksteamer Model 1960-R won't spray cleaning solution. I have cleaned it and taken apart the whole thing. I can't find any problems. The holes are not cloged where the water comes out as I disconnected it and blew through it to be sure. The lines show water trying to go through. It is as if it doesn't have enough power to pump the water out when I squeeze the trigger. I am thinking it is the pump thing but can't find a replacement part for it.

... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

No water I have a Bissell 1694 and it is not ejecting the water cleaner solution out of the front of the machine. The belts are ok. The two nozzels and hoses are not clogged and do not have any holes. I think the pump still works because water still comes out of the brush tool.

It is easy to take the top off. Mine has just 6 screws. Then you can see all the tubing and parts. For example, you can unclip the nozzles and see if water flows. Try blowing through the nozzle to see if it is plugged.\015\012\015\012Some people s ... Bissell Powersteamer 1694 Upright Vacuum

Hoover aquamaster recently purchased hoover aquamaster, trying to shampoo carpet, can't get water to come down tubes, water keeps going into dirty water tank.help!!!!!!!!!!!!!!!

Sounds like you need to attach the air hose\015\012\015\012with reservoir in place you clip on the lid with tubes attached, one of them goes down to the floor cleaning nozzle, the other tube should be about 20cm long with an end piece, ... Vacuums

Dirty water comes out when I stop scrubbing. Floors remain wet.

Try one thing... the filter cover must be clicked into place. I thought it just sat on top, but it has to be pushed into place.\015\012\015\012FWIW ... Hoover H3030 FloorMate SpinScrub 500 Upright Wet/Dry Vacuum

No solution or water coming out...

The water out let are pluged the machine sits dormant with soap in gravity pulls it down and the heat drys it. thus on h2o now to fix it turn up side down remove screws from bottem plate and belt assembly turn back over lay handle on floor remove s ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

When on water comes out between canister and place that hold water

Tank seal bad or over loaded capacity ... Rainbow E series Canister Wet/Dry Vacuum

I am using my Hoover Steamvac FH5001 for the first time. It worked great until I had to empty the dirty water tank and refill the solution tank. Now it will not spray solution. I have double checked to make sure both tanks are inserted correctly, but to no avail.

Check all o rings to see if they are seated correctl= on the hoses that were disconnected. If not you will not receive suction to spray ... Vacuums

II have the kirby sentria, i have it in canister mode with blower attachment on the hose is on with the hand sprayer attachment the problem is the foam is not coming out the sprayer used it just fine all day went to refill w/ water and cleaner now the foam wont come out whats wrong with it?

Make sure the "straw" is in.See if dust coming out of the hose did not clog the air passages. ... Kirby Heritage II Vacuum

Used the Bissell Pro-dry 7350. Turned it off emptied dirty water and re-filled hot water & cleaning solution. Wouldn't turn back on. Have only used 3 times.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Suction button Although my Hoover Spin scrub is working perfecting dispensing the solution, when I go to suck up the solution from the carpet--I am having problems with the RED suction button that keeps popping up. I have to stop the cleaner and lift up the dirty water container to break the suction. Ive tried cleaning the netting that is encased around it, but still no luck. Any help would be appreciated! Thanks

This happens when the filter on the inside of the lid for the dirty water tank is pushed all of the way up. You need to leave a 1/4 in. gap from the top to the top of the filter ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I get no water coming through my bissell pro heat cleaner. thried all the listed solutions-still no water- help!

Advanced formula ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0796 seconds