Having problems with your Bissell 1960-3 QuickSteamer Plus Upright Vacuum ?

My cleaner will no loinger spray out water when the trigger is pushed in. Why not?


Answers :

The feeder tube is blocked, probably by some congealed cleaning solution, just shoot some compressed air into the tube and blow out the clog, but don't just open it up to full pressure as you may blow a hole in the tube making it so you have to replace the tube. If that your unsure of that way disconnect the feeder hose from the steamer and see if you can feel the blockage in the line, if not try submerging the entire tube in warm water, it may loosen up the clog to the point where all you have to do is blow into the tube
Repair Help & Product Troubleshooting for Bissell 1960-3 QuickSteamer Plus Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My cleaner will no loinger spray out water when the trigger is pushed in. Why not?


The feeder tube is blocked, probably by some congealed cleaning solution, just shoot some compressed air into the tube and blow out the clog, but don't just open it up to full pressure as you may blow a hole in the tube making it so you have to repla ... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

When using the floor configuration, I can't get the trigger to cause a spray of either water or cleaner. When using the tool configuration and the hand device with brushes etc, the spray works well with the hand trigger.


The trigger on the handle for tthe floor configuration has become loose or broken. When you squeeze it, the action pulls a rod that runs down the length of the shaft and goes into the base and allows the water to spray. You need to check and make sur ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a powersteamer and it does not spray water when I squeeze the trigger. The clean water tank is full, the cleaning solution is full and this is the same problem I had with my last Bissell steam cleaner, which I assumed was just that I had it for a few years, but this cleaner is only over a year old.


Every line has an O Ring at each end. inspect each one by removing the O Ring for nicks and cracks. Lubricate the with Vaseline and reinstall if ok so they will hold the prime to pump and vacuum up Your leaking O rings will draw air causing your p ... Bissell Vacuums

How do you unclog heater so water will spray. will not spray water/soap when trigger is pushed. Red spinning indicator will spin for a second then stop.


You can use either high pressure air or pin to clean out the jets. Then you can also spary off or rinse the screen filter ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell Powerease Lighweight Deep Cleaner. (Shampooer) After I fill the solution tank with the solution and water, I put it in it's slot, but all of the contents just come flowing out. I have only used this machine twice and it worked ok. You are supposed to press the trigger and the solution sprays out and then release the trigger when you want it to stop. But like I said, now I just put the tank on and all the contents come flowing out. I don't know what's wrong or how to stop it.


... Vacuums

I have a Bissell Proheat 2x cleaner which has worked perfectly on every occasion. Today I filled the machine as usual with water and formula and switched on, the motor ran, the lights were on and the brushes rotated but upon pressing the spray trigger no water or formula was released. I have cleaned the jets underneath and also followed instructions to release any airlock. It still wont release the water/formula. What else can I do? Thanks Charles


Please check the following with liquid in both tanks.\015\012 \015\012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\015\012- ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My karcher puzzi carpet cleaner has just stopped working, when I press the trigger the water does not spray through


... Vacuums

My Bissell ProHeat Upright Carpet Cleaner will not spray water or solution. I have filled the bladder; I have filled the formula tank; I have reseated the tank; and I have turned the unit off and then on again to reprime the trigger. Nothing has worked. Any suggestions?


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

The trigger on My Monster 1200W is not working. I poured the water in the canister and it sounds like it is steaming but when i go to push the button it doesnt spray.


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Bissell carpet cleaner won't spray water on floor setting


I have the same problem, can someone help.\015\012\015\012Thanks ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Water will not spray out of vax carpet cleaner


... Vacuums

When you push sprayer the water keeps spraying till tank is empty


Manual is here: http://www.bissell.com/images/UserGuides/7901_1008.pdf ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

Bissell 9400 2xproheat carpet cleaner won't **** up water. Sprays fine


... Bissell 9400 ProHeat Upright Wet/Dry Vacuum

Water is not being discharged. I have filled the reservoir that holds the carpet cleaner fluid And I have filled the water container. I know how to use the cleaner, it has always worked, But now, no water is being discharged to the carpet. I turn it on, squeeze the trigger, but nothing comes out. The wheel that is suppose to spin (to indicate that water is being discharged) is not spinning. Everything else works. I.e. the suction works, and the hand held accessories work.


That means that the pump belt is worn and it needs to be replaced. You can get a replacement belt and view the manual here:Bissell Pump ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Water will not come out when i push on trigger button. So water does not come out. I have taken it apart and cleaned it. The problem seems to be in the triggerI push on the handle to release the water.


Order the part from bissel see if that fixes sound like you know what wrong just need get part number from bissell.Could be some kinda pump also thats bad not pushing out the water.I got bissle heated one black it only problem the seals r ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Have a bissell pro steam cleaner the suction is great but the water leaks out the bottom I think it should spray from the front and the soap cleaner won't dispense from the bottle so I have to mix the soap cleaner in with the water Any solutions


Use this guide!\015\012http://newzealand.bissell.com/images/IncludeContent/Service_Center_Help ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Hoover Steamvac Upholstery Cleaner will not spray water.


In my case when I pulled the trigger on the upholstery hose I barely got a drizzle of water. After looking at the parts online I realized the valve assembly on the spray end of the hose consisted of a black valve housing, with an inner spring and a w ... Hoover F5832-910 SteamVac Supreme Vacuum

Bissell carpet cleaner won't spray water or cleaner


If I may! In most cases the heater is clogged. It might be clogged with soap that has harden over time. You need to take the handle apart. You will see a metal box(thats the heater) besides the wires there are two tubes connected to the heater. remov ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

The tool attachment for the hose on my Bissell ProHeat 2X CleanShot won't spray soap or water. The bristles on the tool rotate without a problem and the suction is working fine, it just won't spray water when I pull the little gray trigger on the tool.


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Bissell carpet cleaner will not spray water out the bottom but will spray water out of the hand held thing. What could be the problem and how do I fix it


Hey here is a guide on how to fix your problem.\015\012http://newzealand.bissell.com/images/In ... Vacuums

Water spray The water from the bottom of my carpet cleaner is not spraying. It comes out in lines and this doesn't clean the carpet evenly.


Are the brushes turning while you are shampooing? If not then this could be the problem. The turbine is what turns the brushes, it may have gone bad. ... Hoover V1 SteamVac SpinScrub Vacuum

Bissel cleaner won't stop spraying water


\015\012\015\012Remove the handle and check for continuous spray. \015\012After handle is removed, check to make sure the valve is not stuck in the down position. If the valve is stuck in the down position, push on it man ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!


Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My hover extract deep cleaner won't spray water or cleaning solution


... Hoover F7431-900 SteamVac Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0775 seconds