Having problems with your Bissell 3522 PowerForce Bagged Upright Vacuum ?

I cannot figure out how to put the bag in

\015 Does the bag go in facing me or what? the bag has a little rubber band around the opening, where does it go? how do i put it on?\015

Answers :

Theres a slot on the front stick your 2 fingers in there and pull ,its right above the front cover,then just pull the old bag out and push in the new bag.please leave feedback
Repair Help & Product Troubleshooting for Bissell 3522 PowerForce Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I cannot figure out how to put the bag in


Theres a slot on the front stick your 2 fingers in there and pull ,its right above the front cover,then just pull the old bag out and push in the new bag.please leave feedback ... Bissell 3522 PowerForce Bagged Upright Vacuum

The tension knob came off of the front of my sewing machine while I was sewing. I cannot figure out how to put it back on. I have the metal rod that fits into the back of the tension knob, but cannot figure out how to put it back into place. Keeps falling off


It sounds like your machine is the kind that has a knob with a 'set screw', a teeny tiny screw that tightens and holds the thing in place on the rod. Look for a small hole, probably on the bottom and look for a very small screw near the machine. ... Vacuums

My Windsor Sensor XP12 says the bag is full when it's not. I have removed the hose, brush, and filter and cleaned everything. I can put a bag on without the cover and it works great. However, when I add the bag to the front cover and close the latch the right way, it does not work. I'm thinking that the cover is not seating the bag correctly over the hole, but I can't figure out how to fix it. Any suggestions?


... Windsor SR12 Sensor Bagged Upright Vacuum

Cannot figure out how to change Hoover duros canister vac bag. Have Hoover SR bags for model #401010SR. Please help! Thank you.


... Maytag Hoover Duros S3590 Vacuum (Canister)

I can't figure out how to put the bag on.


I had a terrible time trying to install a bag, too! The hinged piece must be closed. Hook the cardboard backing on the opening and \015\012line up the pieces sticking out on either side of the hinged piece with the openings in the cardboard o ... Oreck XL2600 Vacuum

I have a bagless cyclonic shark stick vac. I cannot figure out where to put the hose to use the attachments.


... Euro-Pro V1828 Shark Stick Vac Bagless Vacuum

How do I change the outer bag clip? Can't figure out how to get the top apart to put in the new clip. The clip that goes to the handle.


I had a Kirby Classic and I had to slide off the clip.Don't rate me if this doesn't work. ... Kirby Generation 3 Bagged Upright Vacuum

I have a bissell powersteamer I cannot figure out how to put the belt on


How to put pump belt on ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

Cleaning rollers and belt come off on one side, cannot figure out how to put back.


Hello,For wonderful step-by-step instructions on how to replace the rollers and belt, please refer to pages 17-19 of the user manual located here: ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have an older hoover vacuum and cannot figure out how to put the belt on?


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=542813\015\012Generic problem for all Vacuums\015\012I have an older Hoover\015\012Posted by rrunne ... Vacuums

Model UH70120 Hoover Wind Tunnel T Series Rewind Model UH70120 purchased at Target - bagless How can I put on the new Belt? I have taken it apart but cannot figure out how to change the belt. How?


... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner

I've misplaced the manual and cannot figure out to how to open it so I can change the bag.


... Dirt Devil CE6100 Featherlite Upright Vacuum

I am trying to take my philips vision 8731 vacuum cleaner apart because a heap of c*** got sucked into the motor when the bag was not put in correctly. I have removed all visible screws but cannot for the life of me find how the wheel end comes apart. any tips?


Generic problem for all Vacuums\015\012I am trying to take\015\012I am trying to take my Philips vision 8731 vacuum cleaner apart because a heap of c*** got sucked into the motor when the bag ... Vacuums

Sounds dumb but have my grand-daughters laptop and cannot figure how to put dvd in it to watch,. do not know how to open and close tray. please help. laptop is a dell studio


Hi, Switch on Laptop. \012On the side of the laptop is a compartment. Place on table, look both sides, on one of the sides there will be a small push button, slight pressure, remove finger, and drive will "POP" out. ... Vacuums

I cant figure out how to put the type Z bag into my canister model Jill


You need to place it in the bag holder. It either slides or clips into the bag holder.If you need any help feel free to contact me.TimTheVacCenter.com ... Simplicity Vacuums

I have the electrolux guardian-My full bag light indicater is coming on even with a new bag. It gets worst-the machine will cut off when I insert the hose or put my hand over the hole where the hose goes. I changed the filter on the back and put in a new bag. Help please :)


Hi,\015\012Check your hose you have something stuck in the hose...stretch it out straight and run something through it to push out whatever is stuck in there...\015\012\015\012heatman101 ... Electrolux Guardian Bagged Canister Vacuum

I have a Kirby G4. I have noticed the last few days when trying to vacuum that it is blowing more than it is sucking up. I put on a new bag to make sure it wasn't too full. I also put on the hose and noticed it's not sucking as well as normal. I unzipped the back of the bag holder and noticed the bag isn't inflating as it should be as well. I appreciate any advice. Thank you.


Take the mini emptor off(plastic piece on bottom of cloth bag) this is done by rotating it away from the body of the machine. There is most likely a clog there. Also take the brush head off and inspect fan for chips or cracks this will also reduce su ... Kirby G4 Bagged Upright Vacuum

I have the Aerus Lux7000-My full bag light indicater is coming on even with a new bag. It gets worst-the machine will cut off when I insert the hose or put my hand over the hole where the hose goes. I changed the filter on the back and put in a new bag. Help please :)


Hi, you very likely have a defective control valve under the dial on top of\015\012the vac , or a kink or blockage in the tiny pressure hose that feeds\015\012the air from the throat of the vac or the back of the bag chamber\015\012against the two si ... Electrolux Guardian Bagged Canister Vacuum

Cannot figure out how to install brush belt on a bissell proheat


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

I just bought a Tfal Ultimate Autoclean iron FV 9450. I am reading through the manual and trying to figure out all the parts and functions. I cannot figure out how to remove the anti calc valve. I see it is part # 12 on the drawing but that piece on my iron (the bit with the little circles on it where it says, " anti calc plus') seems to be a flat piece of integrated plastic with no give or slide to it. .I cannot see how I'd possibly remove it. What do you do - push up? push down? The i


Anti-calc valve wings (grip) located at #3 of the 1-15 labeled description diagram that is part of the instruction manual. The wings are on either side of the dry/steam control #4. Lift up on the wings (grips) and the dry/steam control will accompan ... Vacuums

How to put the bag on a windtunnel canister s 3630 ?


On the bags there is an arrow to show the direction to install on the bag holder. ... Hoover S3630 WindTunnel Bagged Canister Vacuum

How do I clean the bag? I loaned it to someone that had 4 dogs! Needless to say the bag was very dirty, full of dog hair and smells really bad. I emptied the bag out but still cannot get all the hair out and wondered about how to clean the bag. Can I wash it? Thanks so much, Cindy


Yes you can wash it if it is from textile material, hand wash it i recomand, but not to sure if u can get all the hair out, but at least it will smell nice.\015\012\015\012A new bag isnt't to expensive either, depends on the model.\015\012\015\ ... Vacuums

When removing the canister bag, the plate and spring that it slides into popped out. When I put them back in, the bag full indicator is completely red. It is a new bag and filters. I think I am not getting the plate and spring back in the canister correctly. Any instructions or pictures showing proper insertion and configuration of these? I looked in the manual and the part is only shown while bag being inserted.


... Miele S514 Solaris Bagged Canister Vacuum

Unbeknownst to me, someone took the bag out of my Kenmore Progressive vacuum and failed to replace it. I have been vacuuming without a bag for months, and today the vacuum stopped sucking. When I opened up the front to replace the bag, tons of dirt and dust came pouring out. I thoroughly cleaned the vacuum, put in a new bag, but still no sucking power. Just dust coming from the rear vents where one of the filters is. Is the vacuum ruined, or is it a simple solution of buying a new filter?


Sounds like you need to buy a new motor. All that grit and dust will ruin a motor and I'm surprised it lasted as long as it did.\015\012This is where a vacuum that won't run without a bag would have been nice. (Aerus for one) ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I had a real heck of a time with the bag installation, because after the pop i zipped it up and started to use it and then the bag of the vac, not the replaceable bag fell off and i kept putting it back on but it kept falling off and when i looked inside the bag to reattach it to the vac cleaner i noticed that the dust was all inside. i haven't even used it that much as i keep it to do the upstairs bedroom only. i love that it is so lightweight and easy to use and i hope that someone can co


Mary, I have some wonderful news for you and your Oreck XL2600 Vacuum, I called 1 800 989 3535 customer service and inquired about your bag attach problem, it seems to be a docking station problem that "may" be warranteed, however if it is missing ... Oreck XL2600 Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0423 seconds