Having problems with your Bissell 3522 PowerForce Bagged Upright Vacuum ?

Blowing out? I have checked all hoses for clogs, I have even taken it all apart, but it seems to be blowing out? The bag inside the canister is sucked in? Can the motor reverse on itself, I'm baffled!!

Answers :

Did you check the inlet down by the brush roll?
Repair Help & Product Troubleshooting for Bissell 3522 PowerForce Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Blowing out? I have checked all hoses for clogs, I have even taken it all apart, but it seems to be blowing out? The bag inside the canister is sucked in? Can the motor reverse on itself, I'm baffled!!

Did you check the inlet down by the brush roll? ... Bissell 3522 PowerForce Bagged Upright Vacuum

I have an Electrolux Lux 7000. My son sucked a small towel into the hose, which is stuck inside the hose close to the attachment end. Can this model blow expel air so I can blow the towel out?

If it does, it should have a door on the top near the back. But if not then something like a plumbers snake or long needle nose plyers may help get it out. ... Vacuums

My Hoover s5620 central vacuum is not sucking. I cleaned out the canister and vacuumed the inside bag in the canister. The hose is clear as is the central vacuums tubing. Any suggestions ?

Try getting some compressed air source and blow back whatever is stuck in the hose. ... Vacuums

Not sucking from bottom into bag, but blows out the side filter,..yet it DOES **** FROM HOSE ATTACHMENT. How can this be?...the.belt is fine recently replace, the rollers clean..I can feel anything i

Here is a diagram ,it's probably the hose behind the brush bar thats blocked.http://www.vacsite.com/en/bissell-parts-1/bissell-parts/3522-powerf ... Bissell 3522 PowerForce Bagged Upright Vacuum

Bissell Powerforce Turbo is blowing dirt instead of sucking it up! Canister and filters are clean. Help???

There might be a clog down in the nozzle hose or in your main attachment hose. check for suction. ... Vacuums

Dyson Animal motor is running, beater bar is turning but very little if any suction. No suction from hose either. The inside canister is filling and moving, so there is some dirt being sucked in there. I have thoroughly cleaned all filters but not sure what is causing the problem. Any ideas?

Obstruction in the hose?\015\012Your vac has developed a hairball possibly.... when a piece of flexible media ie.... cardboard, plastic etc... gets lodged in the hose, and begins collecting hair & dust to the point it no longer has enough d ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

The roller turns strong and the belt is new,but the dirt accu-mulates and doesnt get sucked up! there no observable clogs and the filter side vent blows strong.......ive removed beater,belt and am assuming there may be a problem inside the motor housing as all else appears normal..i was an aviation mech in the military and the above is my assessment........

Are you sure you have the belt on correctly?\015\012If it is not, the beater brush will push the dirt, etc, in front of itself and not back to the suction port. ... Hoover Tempo Widepath Upright Vacuum - Blue

My Electrolux Guardian canister vacuum is not sucking it is blowing out. What can I do?

The vacuum won't blow out unless the hose is connected to the exhaust port on top of the canister.\015\012Your problem is most likely due to the brushes running and kicking debris back out. \015\012Loss of suction can be the result of se ... Electrolux Vacuums

Seals leaking Where the canister meets the machine, the seals are leaking, blowing whatever manages to get sucked up right back into the air. I can't see anywhere to buy new seals. What to do?

Hi.\015\012\015\012If you live in the UK I can help you.\015\012\015\012http://dysonmanuals.inc.io/\015\012\015\012Chris. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My electrolux ambassador power wand quit working. I replaced the switch that shuts it off when the roller stops, but it wasn't the problem. The on/off switch is fine, the motor is fine. We have traced the problem to the wires inside the canister by opening the inside cover to the bag container. We see the power cords going into the canister but we're not able to get to anything. We can't find any screws to undo that would open it up in order to follow the wires deep into the canister. We've bypa

... Electrolux Vacuums

I have an older kenmore canister powermate 3.9 and the vacuum itself works fine but the powermate isn't sucking after a toy was sucked up last week. The toy is out but the powermate doesn't work. I assuming that is what it is called. The big long part that hooks to the canister that actually cleans the carpet. I would appreciate any help.

... Kenmore 25512/ 25513 Progressive Canister Vacuum

Canister doesn't rotate; debris blows back out.

Check for clogs. That could be the problem with the mess getting spread around and not being sucked up.Here's a fix that could ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Dirt Devil Vision and when I put a clean canister back in place the suction at the bottom of the filter clogs up and very rarely go into the canister. Also where the air blows out of the motor, I will get particals that will blow out. I have checked where the belt is and also the suction tube. Do you have any ideas how to fix this problem?

Yes your intake hose is clogged thats the clear hose you can see it on the bottom from the back.disconnect the upper hose from your intake hose and try to push a coat hanger through with the end of the coat hangers end bent till its rounded so you do ... Dirt Devil M086700 Vision Bagless Upright Vacuum

My shop vac blows and doesn't ****! I put the hose on either hole and it blows dirt all in my house. I'm trying to vacuum. I can't find a switch to change it from blowing to sucking and if I put the hose in either hole it just blows.

... Eureka 2812 Wet/Dry Vacuum

When we turn on the vacuum, the canister falls open. The clips holding the canister in place do not seem to hold the canister tightly which I'm sure that it did in the past. The clips do not look bent, but every time we turn on the vacuum the intense pressure blows the canister open only remaining attached the the rest of the vacuum by one clip

Check filter and make sure it is kept clean at regular intervals. Possibly worn out clip retainers on cannister side due to excessive pressure build up. Do not force closure unless pressure is back to normal. May crack cannister or damage unit beyond ... Hayden Industries SuperVac 6000 Central System Vacuum

I cleaned out my brush in the bottom front, cleaned out the small tubing going into the canister, and the canister itself. I also changed the filter.I snapped everything back into place, but Since then, it doesn't seem to have any suction and there seems to be a space between the canister and the bottom of the vacumm where the canister sits. At that area, you can feel air coming out when trying to vacumm and it just doesn't pick up, it seems to be just blowing stuff around.

You need to really look at it some thing is out of line you shooed not have\015\012any spaces in the top or bottom\015\012pull the canister back out and look at the pins that you lined up with the\015\012to ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a shopvac 5 gallon model 86m200 without blowing outlet, it is blowing and not sucking

... Shop Vac Shop-Vac& Mini Hang Up Wet/Dry Vac Vacuum

Dysin vacuum blows air instead of sucking it!

If it is blowing air, then it is still clogged up somewhere, you didn't give your model number, but some of these have removable covers on each side and on the back. Also make sure that all covers are back on securely. ... Vacuums

My bissell carpet cleaner is blowing air and not sucking

... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Not sucking We have an Oreck XL and today it is blowing out dust instead of sucking it up. I just replaced the belt and about 6 months ago, we took it to our Oreck dealer and had it rehauled. I opened it up to check all and it all looked fine. Then I tuned on the machine while unzipped and noticed that the bad does not inflate as it used to. What can I do? Thanks, Connie [email protected]

You probable have a clog in the handle tube, or at the bottom, either by the brush or in the neck where the handle goes into. Unscrew that big black nut and pull the handle off of the bootom asm, then you can check it out and see where the clog is. ... Vacuums

Modeol116.30012000, changed hepa filter, bag. vacuum seems to be blowing air instead of sucking dirt up. The bag collapses when turned on instead of blowing up with air. any ideas as to what is wrong? Thank you

... Kenmore Vacuums

Our plug got pulled out (by driving away while the canister was still plugged-in after a vacuuming the car). How can we open up the unit to reattach the wires? We accessed two sets of screws (2pairs) toward the bag-end (not the motor-end) of the canister, but we can't locate any access for the two other apparent screws inside the body.

Remove all visible screws. Top and bottom, then once they are all removed, take a flat-head screwdriver and slowly pry around the canister until it comes completely loose and can be removed. Then you should have access to the wires which can then be ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Am attempting to get 'inside' the vacuum to troubleshoot why it suddenly stopped running. Suspect it may electrical, and have already checked the obvious (visible cord and plug.) However, there doesn't seem to be an obvious way to get inside the canister without destroying something. Thanks!

Hi There,\015\012\015\012Here's a link to a repair solution that I've done explaining how to diagnosis the cord reel, and open up the machine. The model this is done on is not the same exact model as yours, but the repair will be almost ... Miele S251 Flamenco II Bagged Canister Vacuum

My vacuum blows air instead of sucking air. I have a dirt devil swivel guide. I got something stuck in the brush spinner, got it out...but now the vacuum doesnt suck stuff up anymore.

Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=571660\015\012Generic problem for all Vacuums\015\012My vacuum blows air instead\015\012Posted by katweaver3 on ... Vacuums

Not sucking thru the brushes and not sucking thur the hose! But amazingly if the filter canister is off the machine has plenty of vacuum. what gives?

Your cyclones are clogged, probably with pet hair. Dyson recommends replacing the dirt bin and cyclone ... Dyson Ball DC24 Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0344 seconds