Having problems with your Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum ?

How do I fix the dirt fan on a bissell style 2 model # 3512-R? It broke in half and fell off.


Answers :

I also have the same problem with my 3912-9 model. The fan is broken and I cannot find another one. I have looked all over but the ilustrated parts breakdowns that I have found only shows the motor and not the fan that is attached to the motor. All I need is the fan. Can anyone help?
THERE IS NO DIRT FAN!!! i have no clue what your talking about!!!
Repair Help & Product Troubleshooting for Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I fix the dirt fan on a bissell style 2 model # 3512-R? It broke in half and fell off.


I also have the same problem with my 3912-9 model. The fan is broken and I cannot find another one. I have looked all over but the ilustrated parts breakdowns that I have found only shows the motor and not the fan that is attached to the motor. All I ... Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum

I have Bissell 8910 Proheat. The clear view window (half moon shaped) fell off & broke. I tried to place it back under but it would not stay. It is now not sucking up water. how come? I also am having a hard time finding a part to buy for it.


... Bissell 8910 ProHeat Clear View Upright Vacuum

I have a Bissell Model 8905 Carpet Cleaner. I was going to replace the belts because the pump belt broke, but when I turned the machine over, a small piece fell out. It looks like a tensioner arm because it has a small round part at each end on opposite sides of an arm that has an offset or "dogleg" in it. I am looking for an exploded parts diagram to determine what the part is and where it came from.


... Bissell 8910 ProHeat Clear View Upright Vacuum

The fan on my Dirt Devil model 103 hand held vac cracked. I bought what was designated as the correct replacement fan but the hole in the center of the fan is a lot smaller than the shaft that it has


... Vacuums

Bissell Model 3593-2 Upright purchased 3 years ago not drawing up dirt as it use to


Check where there is suction...is there good suction at the hose...at the back of the vacuum. Knowing where there is good suction will help you know where there might be a clog or any resistance. Bissell also has a fairly good customer support line ... Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum

Need instruction/care booklet for my Bissell powerforce vaccum model #3522-5. Bacfk of vaccum hose is filled with dirt and when attachment is used, dust & dirt fly everywhere. I don't have the care booklet for the vaccum and need to figure out how to fix the problem. Thanks


... Bissell 3522 PowerForce Bagged Upright Vacuum

Bissell proheat 2X, model 8960. The shampoo tank does not seem to work, all I get is the water when cleaning. Also the first time I used my shampoer one of the belts broke. This is the 2nd cleaner I have bought. Was hoping this one would last longer. Cleaning this model is a real pain, surely there is a better why.


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Bissell cleanview 11 bagless special edition model 3576-2 I took apart to clean the filters and don't remember howto put the bottom of the dirt container back. I thought I put the empty container back in place correctly but the dirt when vacuuming is flowing through another part of the vacuum.


... Bissell Vacuums

Can i get a manual for my bissell healthy home vaccum model#5770 my belt broke and i can't find my manual to replace the belt


Yes, goto cnet.com and search for manual and download the pdf file ... Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum

Not sucking i have a KIRBY G3 that was working great. One day there was a strong smell and the brush roller belt broke so I replaced it. The fan looks good. Now the vacuum does not **** up dirt but instead seems to very gently blow air forward. I took the (new) bag off and it is blowing hard int the bag. I am stumped!


Belt is not connect to the drive pulley, see manual for fitting or see utube for video ... Kirby Generation 3 Bagged Upright Vacuum

How to unclog Bissell model 71y7? When I vacuum it picks up dirt ,but shoots it back out. What .can I do to stop this from happening.


... Bissell Vacuums

Bissell model 6594 drive belt #32074 does not fit style 10


... Bissell 6594 PowerForce Bagless Upright Vacuum

Have a Bissell Power Steamer Upright Deep Cleaner - Dirt Livter PowerBrush. Model 1895 The water tank 'must' have been dropped and is cracked too much to use. Can I get a replacement?


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

My Bissell upright CLeanview (model 53F8)is constantly getting clogged up. I have to reach up into the upper filter chamber and pull down all the yuck that I have vacuumed up. It does not even make it to the dirt container. Gross!


The red light indicating dirty surfaces does not come on. The vacume cleaner seem to work but i get no or very little suction from the flexible tube ... Bissell CleanView 3596 Bagless Upright Vacuum

Belt I have a bissell pro heat model number7901-1 and i dont know how to put the belt back on. The old one broke and i cant find my book.


First take off the cover on the left side of the top cover, then turn it over, remove the screw holding the red lock and pull the cap and brush roll out, remove the cap, remove the cogged belt, then you can put the new pump belt thru that slot, put o ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I have the original Fantom, no extra name with it, and need a fan belt...which kind of Fantom do I buy from. Also need a manual for that model # F11062 00 style # GF7-1


... Fantom Vacums Cyclone XT Upright Vacuum

Vaccum dirt devil Model M086365 sucktion not good fan motor woking good filter new bag new just sopped suck good has some but not like it did.


Check the hose for a clog, also check the dirt inlet down by the brush roll for a clog. If bagless, the filter inside the tank may look good, but if it is old then you may want to replace it. ... Vacuums

The dirt cup clip broke and can't find the part!! Eureka whirlwind lite model#4388


Try going to my cleaning supply.com ... Eureka Whirlwind 4388 Bagless Upright Cyclonic Vacuum

I have a bissell proheat x2 complete model 8960 where do i get parts for this. the cover over the brushes broke and i glued it but it keeps falling off.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Hampton Bay ceiling fan model #EC2T-36 HPF. We broke the globe that covers the light bulb when we were changing the bulb. Just wondering if you could tell me where I can buy a new globe cover?


... Vacuums

Replacement wheel I broke the wheel on my bissell upright model 3760 and need a replacement wheel and possibly an associated side molding. I can't seem to find replacement parts such as these- any suggestions?


The rear number is 2036627, there is no side casing, you would have to replace the whole back, which Bissell isn't making avaiable. But o get the wheel, you might try bissell.com and see if you can order direct, or try a local repair shop to see if ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

How to replace the belt on my bissell model 3512-9 vacuum


Tehre are tabs on the bottom. Push them in the direction of the arrow (one at a time) and lift with some force on the cage thingy that partially covers the sweeper. Do the same for the other side. It doesn't matter which side you do first. ... Vacuums

We are unable to find a replacement part that the filter attaches to in the dirt cup on our Eureka Boss Pro Model 411. This part seals the top of the dirt cup and holds the filter in place. What is the part name or model number for the replacement?


I just called Eureka (1-800-282-2886) and asked for the dust cover lid. It was part number 61538-1. They said they could ship it to me or I could call one of the authorized service centers nearby to see if they had one. I wasn't in a hurry and the ... Eureka 411A Upright Vacuum

Bissel model 6579-3 powerforce


Well, i just took the whole machine apart only to realize that there was no internal clog or faulty motor parts. It was just simply the filters. the two sponge like pieces needed rinsing and the main filter had obstructions to remove. on the brigh ... Bissell 6594 PowerForce Bagless Upright Vacuum

I have an older model Bissell rug shampoo machine, model # 1631. I have several bottles of Bissell 5 One carpet formula to use in this machine, however I have lost the measuring bottle that tells me the amount of soap solution to use per 64 oz. bottle of water. I sure would appreciate if you could help me.


I have a older mod. Bissell carpet machine plus mod. 1630-5 and need a floor nozzle part num.013-6194 and grip tube w/button part num.014-4181 and trigger part num.010-9406 and tube ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1105 seconds