Having problems with your Bissell 3750 Lift Off Bagless Upright Vacuum ?

Electrical Connector for Bissell 3750M

\015 Electrical connector burned between lift-off vacuum and base cleaner \015\012where can we purchase this?\015

Answers :

Repair Help & Product Troubleshooting for Bissell 3750 Lift Off Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Electrical Connector for Bissell 3750M


... Bissell 3750 Lift Off Bagless Upright Vacuum

Bissell 6595-1 with broken electrical connector


YES! If you haven't contacted Bissell yet (or bought a new vacuum) do so. They sent me a nice refurbished machine for free. ... Bissell 6595 Lift Off Bagless Upright Vacuum

6595-1 electrical connectors melted down


... Bissell 6595 Lift Off Bagless Upright Vacuum

Replacement motor I purchase a replacement motor for a F5897-900 Hoover SteamVa Motor part # 43576197 or 27242051. The replacement motor has three electrical connectors + ground were as the orginal has two electrical connectors + ground. Do I ingnore the the thrid connector and hook up the wires to the same connectors as the orginal or do I have to do some rewiring.


The manual only show one wire from the motor going to the switch, the other going to the cord, then the ground wire. I would wire it the way your old motor was, could be that some models maybe were 2 speed and the other wire would be used for that. ... Vacuums

I have a Bissell 9200e that has only been used a few times. When I have gone to turn it on it made a loud crack and then tripped the electricity and everytime I turn it on it trips the electricity. Any ideas what may be wrong?


Check plug to exclude short there, if none its an internal short circuit and machine would need opened to find it so if only used a few time return for under warranty repair. ... Bissell 9200 Upright Vacuum

I have a kenmore 116.25615506 vac and I want to replace the connector on the power sweeper. I cannot figure out how to disassemble the "electric folding wand" to get the connector out


... Kenmore Vacuums

I have made electrical connention wrong -only power switch works but not the brush. I need electrical wire layout diagram for Bissel 3760-2


Send me your unit.. ... Bissell 37603 Upright Vacuum

I am looking for a electrical wiring diagram for my Bissell Proheat 4500 carpet cleaner so I can troubleshoot an electrical problem.


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Replacement electric motor for Bissell Pro Heat 2x Select carpet


Bissell proheat i can spray solution from the handle but it has no suction help ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell 6595-1 connector broken


... Bissell 6595 Lift Off Bagless Upright Vacuum

I have a Bissell 9400 E pro heat turbo. It's only been used 4 times, today it sounded like something blew. All my house electrics went off...( blew the main trip) I did read some place that the motor can short out and blow the PCB. Hubby and I just took it apart..( what a pain that was) We can't see a thing wrong with the board...( I expected to see something black, or damaged).... because when it blew today there was a weird smell... sort of like garlic. Question... how on this spinning earth


I have the exact same problem! Just occurred today. When I switch it on it fires for a couple of seconds then takes all the electrics in the house out again.\012\012\012Did ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Looking for the electrical schematic for a bissell proheat 2x 8920


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8920 ProHeat 2XTM Upright Vacuum

What is voltage needed to use BMS10? Does CONAIR sell the electric connector?


... Conair Vacuums

Hose has hole in it i cut it and now want to shove hose into the connector on a bissell


... Kirby G6 Bagged Upright Vacuum

My Bissell 5570 is not staying on. When I push the on botton it goes on but as soon as I remove my finger the machine turns off. The Vacuum is in the upright position and there are no cuts in the electric cord, the canister is properly attached. Please advise. Thank you


... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

Bissell PRO Heat Steam Cleaner is not dispensing the water. I took it apart and cannot find any obvious issue with it i.e loose tubes, connectors etc.


Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be o ... Vacuums

Need small hose and connector parts for a bissell steam vac. model 1690


Sorry but Bissell has obsoleted this model and all of its parts. About all you can do is call around and see if some one would happen to still have what you want in stock. Might be wiser to buy new. ... Vacuums

I am putting my bissel 8910 back together and behind the motor there is a black 3-way tubing connector. One side goes to the pump discharge, one side goes to a tubing going to the right rear wheel (facing the unit from the front) I don't know where the third side goes to. I do not seem to have another tubing for this one to go to? Maybe it is lost or ?


Hi, its hard to know what its for without seeing it. The best way to test this is to start the machine and vacuum a part of the carpet/ floor. Then let me know wht the vacuum is not doing. This will narrow it down. Please, get back to me. This sounds ... Bissell 8910 ProHeat Clear View Upright Vacuum

Bissell 1699 Can you tell me what port on the flow assembly,the tube from the T connector goes to ?


\015\012\015\012This ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Hi, I have a Kenmore vacuum cleaner model number 20712008. There seems to be a problem with power getting to the suction base. There may be an electrical problem with the connector between the metal tube and the base.


... Kenmore Vacuums

How to replace the white hose connector on the heater inside the Bissell Proheat cleaner?


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell 37603 Upright Vacuum smoking


You need to call Bissell, have your model and serial number handy. They may refer you to as warranty service shop to take it to, but it will be replaced with a new one, and under warranty. Call customer service at (1-800) 237-7691 ... Bissell 37603 Upright Vacuum

Solution supply hose, for a Bissel Power Steamer Deluxe 1631-1


... Bissell 1631 PowerSteamer ProHeat Canister Vacuum

Eureka electric hose


... Eureka Powerline 6852 Canister Vacuum

Rainbow D3C electric Hose is broke


NO NO NO NO you have to get a new hose in this situation there is no other way around it. If you screw up just the littlest bit reattaching that hose a vacuum that uses water will QUICKLY let you know. Do yourself, your family, and your life insuranc ... Rainbow Technologies D4 Bagless Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0375 seconds