Having problems with your Bissell 52889 Flip-Ease All-in-One Vacuum and Mop Vacuum ?

We have no instructions for using this Bissell. It is new and has been in the box about two or three years. We have no instruction booklet. Model numbers are 5288 HAY06271 9.6V DC


Answers :

Follow the link below to download your manual:
\015\012http://www.bissell.com/searchresults.aspx?searchtext=5288&mode=userguides
Repair Help & Product Troubleshooting for Bissell 52889 Flip-Ease All-in-One Vacuum and Mop Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We have no instructions for using this Bissell. It is new and has been in the box about two or three years. We have no instruction booklet. Model numbers are 5288 HAY06271 9.6V DC


Follow the link below to download your manual:\015\012http://www.bissell.com/searchresults.aspx?searchtext=5288&mode=use ... Bissell 52889 Flip-Ease All-in-One Vacuum and Mop Vacuum

I have a Bissell PowerSteamer, Clearview approximately six years old. My son borrowed it two years ago and lost the instructions. I can't find a model number on it and need the instruction book. Thanks


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Model number U5763900 Serial Number 090400013588 Handle broke off just above the four screws that attach it ti the boby of the vac. Hoover does not list parts for models that are more than two years old. The vac operates perfectly but without a handle my wife cannot use it, where can I find a part replacement. easy to remove four screws and replace. dont want to drive 100 or more miles to find a authorized repair shop. Oh yes, this is a Hoover Preferred Wind Tnnel Bagless


Get over it and buy a new one!!! ... Vacuums

UPM Model ET170 Electronic Timer Programming: A. Is it required to associate one program number with each day of the week? B. Can two programs run during the same day? C. Can each week day run a different program number? D. What is the shortest ON time one must program for the RANDOM function to provide two ON-OFF cycles? E. How do I end the programming mode and start the timing sequence. The instructions with the timer are not clear to me. Thanks for your help.


A. It is required to program each day of the week.B. No. Either it is programmed to be on or off.C. Yes. Each day can run a different program.D.Short random is for 1-2 hours. Long Random is 2-3 hours.E. Once you are done progr ... Vacuums

I bought a Philips Senseo Coffee Maker Model 7824 from Geant in Carcassonne, Aude, France (where I live) two years ago and it works well as a coffee maker. However, I recently bought a packet of Chocobreak which included a holder for the Senseo coffee maker. The instructions gave a list of machines that could not be used with that holder, however, Model No.7824 was not included in that list. When I tried to use the holder provided with my machine it would not fit with either of the handles a


... Vacuums

Hi I have an electrolux "The Boss" hand held vaccum cleaner. I cannot find the instructions and am having problems changing the belt. It is model number Z57A. Product Number 900-250-006. It is the first time I have had a problem. I only use it occasionally for my caravan. So cant find the instructions and cant remember how to change the belt. Please help


You need top lace belt on brush roller and re[-assemble by putting plastic cover on which is retained by 2 recessed philips screws.. Prize off triangular coverat fornt.behing that you should see the belt lying loose.You need to get a blunt object to ... Electrolux Vacuums

I've lost the instructions to my new Powerwash/Powerbrush Select. Have entered Model number 25M1-E but no results found. Why as it's a new model. Please can someone help.


... Vacuums

I have a Piranha mega steamer Model ms 312, about 6 years old. I have lost the instructions and haven't used it for a while. Can someone please let me know if there are instructions someone online i can access or let me know the main instructions. Thanks


If google and manufacturer website are of no help then ask a search agency like http://manualfox.com - They do a great job. The service is not for free, but often worthy (you only pay if they find what you are asking for). ... Vacuums

The Panasonic MC-V7515 has two belts. The local vacuum repair guy says he only has a part number for the drive belt, which is UB-9. How do I find a replacement for the other belt, the one which directly drives the beater bars? By the way, this vacuum has great suction, but otherwise is far inferior to my previous Panasonic vacuums. The cheaper models aren't a good buy--stick with the more expensive models.


... Panasonic MC-V7515 Bagged Upright Vacuum

I have a Fridgidaire Window Air Conditioner, Model Number #FAC127P1AZ, Serial Number UL-KC35/Y-G5, 12,000 BTU's, Year 2004. The unit worked fine, and then was accidently plugged into a 220 volt recepticle. Is there a fuse on this unit that I can replace?? If so, where is the location of the fuse?? Thank you for your assistance.


... Vacuums

I have bought a shark cordless vacuum sv779z 14 from walmart, at first it worked well, but lately the suction is ok when i switch it on, and them immediately decrease until there is almost no suction. I don't know if its the battery or what i need to replace. When i call the customer care number listed on the instruction manual, they say that they don't have the model number on file and that i should call back in 7 days, which i have done several times, what should i do?


... Vacuums

I boubght one of your track lights a few years back and cannot find the instructions. the actual name and number on the item is hampton bay halogen tracklight 724491. All I'm asking is for somewhere online to locate the instructions. thank you


Sorry, can not help you in the vacuum forum. ... Vacuums

I have a Craftman 5hp snowthrower model 53688501 that will not start. It will fire with gas down sparkplug hole, but runs only untill that gas is burned up. Fuel is present at carb, but I noticed that there are two brass fittings on each side of the carb for vacume lines or something, and they have no lines connected to them. Did I lose the lines that should be connected? Or do I have some other problem. The unit is 4 years old and has the Briggs and Stratton eng model 9A413-0202-E1


This sounds like the carburetor needs disassembled and cleaned. This happens over time and the tiny orifices plug up. Usually from letting gas set in them for extended periods of time and it gums up. If you are not familiar with them, I would take ... Craftsman Vacuums

I have a Gemmy light show strand of bulbs, model 19611. I bought 4 strands last year the day after Christmas and used them for the first time this year. After two days use one of the strands went out. I have replaced the fuses in the strand and it is still not working. Any ideas?


... Vacuums

I just purchased a westclox tech model 70014 yesterday. I read the instructions and set the time. About an hour later, the time reverted back two hours. I read the instructions again and repeated setting the correct time. I assumed it was working. However, I woke up by myself today at 5:30am, but the clock read 1:14. Is there any way I can fix this or is it a manufacturing defect?


... Vacuums

I have a grafter safe model no AA/R06/1.5V - GT24 batch number 0171-2C and have lost the instructions and the key. I have put in a wrong pin number and now I am getting the message 'error' flashing across the safe and don't know how to get into the sate.


... Vacuums

My wife has a Revlon Rv051 curling iron .. has worked fine for several years but now it has stopped working. No response to pushing the ON switch (normally turns on a red LED). I've opened the unit and verified the integrity of the cord and swivel contact between the cord and the PC card. Unfortunately w/o any documentation of the PC card, I'm at a loss as to what to try next. My wife has had this unit for several years ... liked it well enough that she now has two more of the same model but


Is power making it to the switch? Sometimes the plug of the unit with pushbuttons has issues and fails. Maybe you can switch a plug from 1 of the other ones you have to test. ... Vacuums

My Oregon Scientific BAR888 has 5 windows, 1. temperature, 2. humidity, 3. mb/hPa or inHg (switch at the back), 4. bars showing pressure changes over 24 hours, and 5. time/date. Window 3 gives an option to set something between 0 and 2500. Oregon say they only have one set of instructions for the BAR888 but they do not match my instrument as there is nothing included for my window 3. Trouble is I don't know what the 0 to 2500 relates to and therefore don't know what to set it at.(My model does n


... Vacuums

My sister misplaced the instruction manual to her emerson microwave and I would like to replace the instruction manual. I do not have the model number available and only know she bought it at Walmart for around $60. I would appreciate any help. Thank you.


Hi,\015\012\015\012Since you do not have the model number of the Microwave, kindly view and identify the model from the complete list on the Emerson website by clicking this ... Emerson Vacuums

I got this sewing machine , can anyone tell me what this control box is used for ?. It is mounted under the table in front of the motor,It says Control Box on the front and two push button number settings with can be adjusted up or down from ( 0 to 9 ) ,Next to these settings are two toggle switches. One is marked start with on and off and the other switch is marked end with on and off. Above these switches it it says Back Track . The tag on the box says ( Type LE -BB -24 - 110 - 220, 2


Still struggling with your model number. I understand from the added comment this is a Brother sewing machine. I was hoping to find a manual that would be of assistance. Here is a couple of websites that lists available manuals for Brother sewing ... Vacuums

Warranty information I am trying to find the warranty info on a vacuum i purchased...there was neither a phone number or website included with the instruction booklet


If you let me know the manufacturer and model I may be able to track this info down for you. \015\012\015\012-R ... Vacuums

Model 52148 Scunci sweeper.Handheld grip will not insert & lock. This is a new sweeper, even though we purched it about two years ago.


... Scunci 52004 Bagless Canister Vacuum

Belt installin you gave me instruction for another style my vaccum has only 1 belt model number isu4537-910 belt # 38528-027


Take off the bottom plate, then look to see if there 2 screws holding the top cover on, there is a slot on each side of the top cover (from the bottom). Using a flat bladed screwdriver, put the belt in the slot and pry up to release the locking tabs ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Have a Centralux Aerus about 5 years old. Don't see a model number. There is suction but beater brush quit working. Was using for a few minutes, shut it off for a few minutes, turned it back on and suction only. Tried the reset button also. Tried the sidekick attachment and it works fine. There was no smell like something was hot. Belt is fine. Are there any fuses or anything else to try? This vacuum cleaner has not really been used that much, it is hard to believe the motor would need replaced


There probably is a loose wire in the handle near the switch or a wire off near the swivel elbow near the vac power head. With the right fastener tool to remove some screws you can fix it yourself ... Electrolux Centralux Vacuum

Kenmore YM-40-35 R Sewing Machine Manual (or copy) wanted. If a manual is not available, I'd be OK with instructions for threading the needle and bobbin and any additional details that an expert may have. I think the machine may be a Canadian model number, it looks old, made of metal with screwed in presser foot. Thanks v. much. Elizabeth, [email protected]


Hello,please kindly visit the site below to see the comprehensive instruction with video on how to thread and bobbin your sewing machine.http://www.wonderhowto.com/how-to-thread-mechanical-singer-sewing-machine-224245/wish you ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0609 seconds