Having problems with your Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum ?

Bissell 5770 vacuum power won't stay on. The power will only stay on if you hold down the button the whole time.


Answers :

I just had this happen to me. I took the top part of the vacuum off, unscrewed all of the screws from the top piece and opened it just enough to pop off the plastic red power button. Then I pressed the switch mechanism up and down a few times to reset it and put it back together. Turns out it didn't actually go bad.
It sounds like the power switch went bad mechanically (won't lock on)
Repair Help & Product Troubleshooting for Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bissell 5770 vacuum power won't stay on. The power will only stay on if you hold down the button the whole time.


I just had this happen to me. I took the top part of the vacuum off, unscrewed all of the screws from the top piece and opened it just enough to pop off the plastic red power button. Then I pressed the switch mechanism up and down a few times to rese ... Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum

My dyson won't stay on. I push the red power button and it begins to start but as soon as I stop pushing it, it stops. It will only work if I keep pushing down the start button the whole time I'm using it. HELP!!! I love my vacuum!


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Power Problem Whenver I push the power button on the handle the vacuum stays on for a few seconds then turns off. I have to push the button on the handle all the time to keep the vacuum working.


Hi There,\015\012\015\012Unfortunately this is being caused by static electricity building up in the electronic controls in the handle of the hose. I've seen this problem on numerious occasions, and in fact I have the twin brother of t ... Miele Blue Moon Bagged Canister Vacuum

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

When I try to turn on my DC14 vacuum, it won't stay started. I have to hold down the power button while I vacuum. I have checked for clogs and cleaned the filters, still no luck. Any suggestions?


It just needs a new switch under the "on" button...take it in for service it's worth it! ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Vacuum won't stay powered without holding the button down.


This is over a year too late, but perhaps this will help other people in your situation. Here is how the switch assembly should go together: ... Dyson Vacuums

My Error light will not go off. I just bought new batterie, as I thought that was the problem. If I hold down the power button and the play button on the vacuum it will run. When released it stops. The remote will work for the unit if I am holding down the power button on the vacuum.


... Infinuvo QQ1 CleanMate 365 Robotic Vacuum

My vacuum power button will not stay on unless I hold it in.


Most likely the ratchet mechanism on the switch is faulty.\015\012\015\012Switches are available if you search on eBay for a few pounds, and if you've reasonable DIY skills and tools, it's fairly easy to do.\015\012\015\012Hav ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Vacuum will not stay on unless I hold down the power button.


Sounds like your switch has gone.Its simple to replace, only 1 "specialist" tool is needed, but you can substitute for a small screwdriver.If you visit\012http://www.sparesaver.com/help-and-support/dyson-section/dyson-technica ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Power button not engaging...vacuum will not stay


The power button is worn out and needs to be replaced. That vacuum is pretty simple. So even if you don't know how to take it apart it shouldn't cost much to have it repaired. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

When i hit the power button on my miele carina, it doesnt lock and stay on. i have to hold down the power button for the power to stay on. Please advise


Try a little WD-40 sprayed sparingly on the button. work the button a few times- may be sticky spring or contact. if that doesn't work, check with retailer where you purchased it- see if you can get a replacement switch! if you're handy, or have a ha ... Miele Carina Vacuum Vacuum

Power button wont stay on. have to hold the power button manually for it to stay on.


Most likely you have to replace ON/OFF switch. look at detail instructions how to do it on our website:http://www.goodvac.com/kb_results.asp?ID=18 ... Kirby Ultimate G Bagged Upright Vacuum

I have a miele S712 (2 yrs old worked fine yesterday) - I had been doing some diy work inside and had the vac on just to reduce some of the dust in the air - after a while the vacuum fizzled out. I guessed it had overheated and took it outside to cool down - when I tried to turn it back on pressing the power button gives it power and it starts to **** but it won't STAY on, soon as you release the power button it stops, and the orange bag indicator is showing full. As I have a compressor I took


You have got dust in the micro switch and it is not latching on, if you look at this and clean it, that will solve your problem, however blowing the motir has probably wrecked the motor bearings. ... Miele Vacuums

We all of the sudden have to hold the power button down to turn it on. As soon as we let go of the power button, the vacuum shuts off.


It sounds like the actual switch in the unit has failed. The switch has a spring in it that keeps it in the on position then pushes it to the off position when it is hit again. If you can get to it, you'll be able to check it out yourself and Bisse ... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

My dyson animal vacuum (~9 years old) will not stay on. I press the on/off button and it will only stay on as long as I am holding the button down. Help please!


Hi it sounds like you need a new switch ... Vacuums

Err5 When charging the battery, it starts out flashing amber, but after several minutes it turns red and the err button flashes five times. The troubleshooting says to hold the buttons above and below the power button for ten seconds and this may resolve some software issues. I tried that but it goes back to the amber light then red again. I replaced the battery hoping that was the issue, but it still does the same thing.


... iRobot Roomba 530 Robotic Vacuum

Electrolux "The Boss" 4110 Vacuum - Have to hold power button?


It sounds like the on off Switch is broken.\015\012you need to replace it or tape/glue it down and use the plug as on of switch. ... Electrolux Boss Smart 12A Vacuum Vacuum

Dyson vaccum, it will not stay on, it turns itself off and I have to hold down the start button to continue vacuuming.


... Dyson DC07 Bagless Upright Cyclonic Vacuum

Vacuum will not stay on without holding down the start button


The start button is broken. Needs replacing.\015\012\015\012Charlie ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Power button won't stay on. If I hold it down, it sucks fine, but it won't stay pushed down.


Bad switch ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Power won't stay on when power button pushed - Dyson Vacuums


... Dyson Vacuums

While vacuuming the beater bar shuts off all by itself, the main power source stays on. I touch the power button on the beater bar to start it again and it shortly after shuts off again. why is this happening?


... Dyson Stowaway DC23 Bagless Canister Cyclonic Vacuum

The power button does not work 80% on the time. I have to keep flicking it on and off until it turns on. The battery is fully charged, so that is not the reason. Once power is on, no issues staying on.


... Oreck TEK100 Handheld Vacuum

I just got a Shark Bagless Upright Pet Pro V1310PT-FS and the power switch will not stay on. If you hold it down, it will turn on and the vacuum will pick up but the switch doesn't seem to stay in the "On position". Any ideas how to quick fix this?


... Vacuums

Power switch does not work. Vacuum only runs while holding down the power button.


Greetings,Most likely your switch has gone bad, and you'll need to replace the on/off switch on your Dyson DC07. If you have to hold down the switch in order to keep the ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0967 seconds