Having problems with your Bissell 6594 PowerForce Bagless Upright Vacuum ?

No sucking the dust

\015 Still very new i cleaned the filter twice and it does not vacuum well help\015

Answers :

Check the pipe up from the brush to the pump that it has not been blocked by an item too big to go through to the catcher
Hi my Bissell 3750e has started making a loud rumbling noise when I push it. I've cleaned all of the filters the belt is fine and the suction is spot on. When I push it I can also smell a burning smell any ideas?
Repair Help & Product Troubleshooting for Bissell 6594 PowerForce Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Unbeknownst to me, someone took the bag out of my Kenmore Progressive vacuum and failed to replace it. I have been vacuuming without a bag for months, and today the vacuum stopped sucking. When I opened up the front to replace the bag, tons of dirt and dust came pouring out. I thoroughly cleaned the vacuum, put in a new bag, but still no sucking power. Just dust coming from the rear vents where one of the filters is. Is the vacuum ruined, or is it a simple solution of buying a new filter?


Sounds like you need to buy a new motor. All that grit and dust will ruin a motor and I'm surprised it lasted as long as it did.\015\012This is where a vacuum that won't run without a bag would have been nice. (Aerus for one) ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Not sucking We have an Oreck XL and today it is blowing out dust instead of sucking it up. I just replaced the belt and about 6 months ago, we took it to our Oreck dealer and had it rehauled. I opened it up to check all and it all looked fine. Then I tuned on the machine while unzipped and noticed that the bad does not inflate as it used to. What can I do? Thanks, Connie [email protected]


You probable have a clog in the handle tube, or at the bottom, either by the brush or in the neck where the handle goes into. Unscrew that big black nut and pull the handle off of the bootom asm, then you can check it out and see where the clog is. ... Vacuums

We have a beam Serenity plus home vacuum system and there is no longer sucks. I removed the dirt from the bottom plastic container, but I also notice a sack or bag connected to the unit when I removed the bottom container and inside that sack there appears to be lots of dust. How do I access that and remove that dust without damaging the unit. I don't know how to do that


Hello. Let's begin by getting that dust and dirt out of your permanent filter. To do this, get a big clear plastic bag and pull it up aroung your canister, with the dirt receptacle removed. Then Grasp the sewn in weight inside of the filter and sh ... Beam Industries 2900 Serenity Plus Central System Vacuum

My Oreck XL is blowing air and dust out instead if sucking.


... Oreck XL Ultra Bagged Upright Vacuum

My sanyo power brush is spitting out dust instad of sucking it in


Check for a plugged hose or wand, this is a classic sign of a plug some where between the power head and canister.\015\012\015\012Tom ... Sanyo SC-X1000P Canister Vacuum

Hi good day, I have a Kenmore Grab n Go 12.0AMPS Vacuum cleaner, Model# 116.34722402 & serial#T53601507. The vacuum is now having a problem whereby the rolling brush underneath is not spinning when the vac is on. This has caused it to stop sucking up dust. Could you please advise as to what might be the problem. Thanks in advance for your kind assistance. regards, Clarance


... Kenmore 34722 Grab-N-Go Upright Vacuum

My nilfisk action sucks for a few minutes then over heats and sometimes blows dust out and the bag explodes. The pipe is not blocked and I have cleaned filters and put a new bag in but still thesame thing is happening


Their has to be an obstruction in the system causing this issue ... Vacuums

Miele S318i worked ok till I took it apart to blow really fine ceiling "popcorn" dust that got sucked by the filters. When I plugged back in started for a milli second and quit. At this point I believe the circuit board might be the fault, but I want to test motor before I go and buy the part. Can I simply run 110 to the two moter contacts to bench test? Steve


Yes, you can. ... Miele S318 Bagged Canister Vacuum

I have a Eureka Altima vacuum. The model number is 2996. I don't think my vacumm is sucking any dust. Plus, it smells like a burning leather. What should I do? I have tried to get help from others and they tell me that I should change the belt. But, I don't know where it is. Please help.


Sounds like the belt for sure. Here is a link with the owners manual. It shows how to get to and change the belt. http://www.eureka.com/index.php?option=com_productdisplay&view=productdisplay&task=getproducts&productid=2&produ ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

No sucking the dust


Check the pipe up from the brush to the pump that it has not been blocked by an item too big to go through to the catcher ... Bissell 6594 PowerForce Bagless Upright Vacuum

I have a Eureka SurfaceMax 300 yellow one and its not sucking up very well at all, and its blowing dirt and dust out the back?? my ol man checked tonight and said the roller isnt spinning, so if i jus


Here is the manual , check belt is not broke, and the pipe behind the brushbar is't blocked up,http://www.eureka.com/FileLibrary ... Vacuums

Vorwerk ET 340 - been great but now noticing strong burning smell after vacuuming some hair from the bathroom. Bag is nearly empty. Gave it a rest then unscrewed the cover housing the motor and all looks clean (dust is sucked up the pipe and doesn't appear to get near the motor). When I restarted it, burning smell still there. Are there any filters that might need changing? What could be causing the smell? Could the hair have gotten caught somewhere? Thanks.


Jessica,\015\012\015\012Try changing the dirt bag.\015\012Check if the motor gets hot after operation. You can come to check it by touching outside the motor housing. If it is hot or just warm.\015\012Is the smell of burning hair or something e ... Vacuums

Notices some problem with suction on my Karcher RC3000. Much of the dust remains on the brush and doesn't get sucked in. Service couldn't advise anything. Any ideas?


The air passages through the machine may be plugged, or the impeller (fan) on the motor is slipping on the shaft so that no vacuum is produced. Remove the brush assembly to check the air passage behind it and inspect the brush bearings for collection ... Karcher RC3000 Bagless Robotic Vacuum

MY DIRT DEVIL IS NOT SUCKING THE DUST AND IT IS NOT HROWING INTO THE CONTAINER.


Check the hose and make sure that the hose is not plugged. sometimes the hose that is on the bottom from the beater bar to the hose behind the vacum where it disconnects to use attachments gets plugged where it turns to come up. disconnect the hose a ... Dirt Devil M086700 Vision Bagless Upright Vacuum

I'm having trouble getting the cup to remove. Once we did get it to come out and we put it back in. When we turned it on dust blew out of the vacuum where it should have been sucking in.


The dark gray plastic slide is separate from the Easy Empty Cup. Just slide the release tab all the way to open position, and then pull the Easy Empty Cup straight up.\012With a little effort, the cup will dislodge from the dark gray plastic platter. ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Doesn't work Our home was built and finished in August 07.  The central vac doesn't work.  There is supposed to be a slot that opens in the kitchen where you sweep the dust and it sucks it up.  Also, the mounted unit on the garage wall has a hose that goes up into the house but there is a hole open at the bottom of the unit.  Where can I get someone to help us?  Or, is there an installation manual I can download to see if the builder did it properly.  He stole our solar heater for our pool and s


Has the slot in the kitchen (VacPan) been installed? Or is it just not working? There should be tubing coming into the unit in the garage, and possibly another piece to exhaust the unit to the outdoors, although this isn't always necessary. The intak ... Electrolux Centralux Vacuum

Shop vac My shop vac sucks dust in and instead of staying in the tank most of it blows out the blower hole. Ellen


Is the filter in place and in good condition. To find the filter just unhook the top and lift it off. ... Shop Vac (464-38-10) Canister Wet/Dry Vacuum

My bissell cleanview II bagless is spitting dust and dirt out and not sucking things up. We've had it for only 2 years.


... Bissell 3576 CleanView II Bagless Upright Vacuum

DYson DC07 not sucking properly when in upright mode. I have tried cleaning out pipes etc and even tried an old motor section I had in garage (replaced once under warranty as kept cutting out and they left old motor section here). Even the old motor section had same prob so this suggests its something in the rest of the vacuum cleaner (whats left after you have lifted off the green motor section and dust collection area if you see what I mean? Any advice weclome please.


Blocked filters ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My canister kenmore progressive is not sucking and is sptitting carpet powder dust all over the place. could it be it needs a new hpa filter? if so where on the vacuum would it be located?


Remove the hose from the canister, and turn on the vacuum. Does it produce good air flow into the hose port?. If ok, remove the hose from the sweeper unit and plug the end into the canister. If ok, check the bottom of the sweeper head for plugging of ... Kenmore 25512/ 25513 Progressive Canister Vacuum

The vacuum voice changes after turning on and it is not sucking any dust. When it happened before I pulled a pen out of the sucksion line but this time I can't find anything thats hindering the path.


Take the hose off and use a long wooden handle like a broom handle see if they is a clog in the hose by putting the handle into the hose ... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

Sucks up hair and dust but it all collects on the brushes


It has a obstruction somewhere in the plastic pipe. You are going to have to get your hands dirty and tear it apart. Dont be affraid, its easier than it looks, just take it apart slowly and take pictures as you go. When you get the bott exposed you w ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I got some dust or debris possibly sucked into moter from a broken bag. Now moter spins and whines at a loud pitch. What would be the best approach to take if it can be fixed by myself? Is there a downloadable schematic avialable for free on the web?


... Lindhaus HF6 Bagged Canister Vacuum

My vax power 8, 2200 watts 300 air watts 4L capacity upright Hoover is brand new, I emptied out the dust/dirt collecter and cleaned the motor filter yesterday for the first time, i switched it on and all fine, the brush is spinning and the hose is sucking, put the Hoover to work it's fine for about 30 seconds then then suction stops and its dead it won't collect no more, so switched off taken apart again and the motor filter is blocked and full of dust, so I unblocked it, do the same process aga


I had the same problem. It looks like the seal on the lid on the bottom of the cylinder has fallen out when it was emptied. There is no longer a proper vacuum being created so you don't get the cyclone effect and the dirt doesn't collect where its su ... Vacuums

I have a dirt devil ultra vision turbo that is sucking up properly but it is blowing dust out instead of clean air. Is this a problem with my filter? Somehow it is bypassing it.


... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1253 seconds