Having problems with your Bissell 6596 Bagless Upright Vacuum ?
Actually have model 6594. no suction. any suggestions?
If you hear the motor running and the vacuum is not sucking up debris, I would believe you have a problem with the beater brush.\015\012Problems with this brush are usually caused by 1 or 2 if not both of these problems:\015\0121- The drive belt for the brush is broken.\015\0122- The brush itself is frozen due to debris. Remove brush and clean all debris off. Pay special attention to end pieces of the brush that hold it in the vacuum. The brush should rotate around these two pieces. Clean ends and spray on a little WD40 and turn to work it so that the brush turns freely.\015\012If you find the brush is frozen and needs to be cleaned, probably a good idea to put a new belt on at the same time.\015\012Be sure the belt is put on correctly so the brush turns in the proper direction.\015\012Feel free to contact me if you have questions.
Repair Help & Product Troubleshooting for Bissell 6596 Bagless Upright Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Actually have model 6594. no suction. any suggestions?
If you hear the motor running and the vacuum is not sucking up debris, I would believe you have a problem with the beater brush.\015\012Problems with this brush are usually caused by 1 or 2 if not both of these problems:\015\0121- The drive belt for ... Bissell 6596 Bagless Upright Vacuum
My whirlwind Eureka model 5197 is making a very loud noise yet the suction is still okay. Any suggestions? Could it be the belt slipping? It's a self propelled model.
... Eureka Whirlwind 4496 Bagless Upright Cyclonic Vacuum
Kirby My Kirby is less than a year old. It's suction is no longer strong. I tried cleaning the hose and even replacing the bag. Do you have any other suggestions. By the way, I have the Sentera model. Thank You
Here is a link to my online troubleshooting guide. Hope it helps...\015\012\015\012http://r ... Kirby Generation 3 Bagged Upright Vacuum
Fantom Canister The vacuum head light keeps going on and off as well as the suction. I actually purchased a new head, at the recommendation of their service dept., and the problem is still happening w/the new head. Any suggestions.
It sounds like you have a hose problem. You should be aware that the Fantom company went bankrupt many years ago. I know that the Fantom name was bought by another company and there may be Chinese units sold under that name, but service and parts ava ... Fantom Vacums Lighting Canister Vacuum
HELP!!dyson vacuum only 2 years old model DC18 runs but has lost suction on the wand side of the vacuum does anyone have any suggestions for us??
Its the ball cradle assembly. There is a little clip that changes the direction of the suction. that clip breaks all the time and causes the internal direction valve to stay in one position. unfortunately dyson doesnt sell these parts separate, you w ... Dyson Vacuums
Hi. I have a Kirby from back in the early 90s (model G3D). Never had major issues with it. Can't remember the last time I had maintenance/tune up done. It's just sounding different when I run it the last few times...almost like it's louder and kind of echo-ey. Still suctioning well, but something's not right and I don't want to run it until I know if anything's up. Any suggestions? I'd like to try and figure this one out on my own with your help. Thanks in advance for your help. Marci
Check the belt. this is a strong vaccume and even without the belt it will still have a decent amount of suction. If the belt is not tight or intact it can let the motor turn faster which will sound louder. other than that check all the hoses for hol ... Kirby Ultimate G Bagged Upright Vacuum
I HAVE A KENMORE PROGRESSIVE CANISTER VACUUM CLEANER (MODEL 116.25812500) THAT LATELY HAS VERY LOW SUCTION. ANY SUGGESTIONS ON HOW TO BRINGIT BACK UP?
Hi,Here is a tip that I wrote about my Bissel but I bet you have the same problem and the hose is clogged...Bissell Bagless Upright Vacuum not ... Kenmore Vacuums
I havethe first generation purple Dyson Animal model. The brush rotates fine, but doesn't make sufficient contact with the floor/carpet, therefore does not pick up most items on carpets (suction still works however). If I put my foot on it and push down a little, it works. However, since I'm not an accomplished acrobat, this is not easy to do. :-) Any suggestions on whether this is fixable? Or should I just save up to buy a new one?
... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
I was vacuuming the vent in the bottom of the fridge. I must have picked something because the motor got wildly noisey. I cleaned out hoses, etc. There is no suction. I can see the blades of the motor and they are not turning around. Model U4269-930 Series B.72. Can I get at the motor to see if something is keeping the blades from turning? What would be your suggestion. Many thanks. Pat Sauerman
Hi Pat, my name is John I will do my best to assist you.\015\012\015\012You certainly can get at the motor, with simple hand tools. \015\012\015\012Referring to this ... Hoover Vacuums
Dyson DC 14 hose has no suction, with or without brush attachments. Hot air shoots out from the base of the canister when I try to use the hose. I cleaned the top filter, but can't figure out how to remove the hepa filter to clean it without destroying the case. It looks like it might take three hands to insert pennies and "flip" the case open as is suggested on a youtube video for a different model. Would this even help, assuming I could get the thing open?
... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
We have a cannister model 116.23613300......all of a sudden there is no suctiion....it will only blow.....no suction at all.....plz update with any suggestions....thx
... Kenmore Vacuums
I have a model DC3 rainbow thar has lost suction. what can i do to fix it
Check suction at intake without any hose connected. If that is good, then connect hose and check suction again. If that is poor, then you have a clog. If still good, then check power nozzle by getting into the belt area.RainVac ... Rainbow E series Canister Wet/Dry Vacuum
No suction I just replaced the bag, and normally after this I have a lot of suction. Now that I have changed the bag I have less suction that I had before. Not even enough to picj up dog hair. I snaked he hose and checked all of the connections. It seems to have an air leak but no amount of tape will fix this. I cleaned the filer as well with warm water and dried it and re installed but still absolutely no suction. I am ready to throw it out! Any suggestions would be appreciated
1, Does the blower (discharge) side blow bunches of air??Yes: Something is clogged from the bag to the hose end. Try blowing out the hose from the discharge side.Or: The bag is not properly seated. Make sure that the plastic piece is ... Kenmore 23313 Whispertone Bagged Canister Vacuum
Hoover Model# U8185-900 Problem: No suction, not engaging Vacuum cleaner roller spins as usual, but there's no suction when trying to vacuum the carpet. Can anyone point me in the right direction? Tha
... Hoover U8185-900 Upright Vacuum
Decreased suction was using to vaccuum carpet and suction decreased..nothing plugging hose....suction remain at unit canister and exhaust is fine....suggestions??
You might have a clog, to try and unclog the lines, you need to unplug the unit, and remove the bag compartment. Then take a shop vac using the hose attachment hold it into the attachment door where there is low suction and try to draw the clog out t ... Broan-NuTone CV353 Central Vacuum
Poor suction I have weak suction at all ports and no suction at the canister. It is a Nutone model CV-350. This unit came with the purchase of our home, so we don't know much about it. thank you for your help.
Either you have clogged filters, or the motor is weak, you could check the carbon brushes, otherwise replace the motor. ... Vacuums
Where can I get a replacement glass lid for Rival crock pot model #3100/2? The one listed below is out of stock, but, even if it were, it will not fit my model. Any suggestions? "Buy-it-now-store.com" lists: CURRENTLY OUT OF STOCK, NO ETA. # Rival Crock Pot Lid Replacement Glass for 3.5 Quart Rival Slow Cookers - $5.99 Rival Crock Pot Slow Cooker Replacement Round Glass Lid Cover # Works with Rival Crock Pot Models: 3100, 3101, 3102, 3103, 3130, 3133, 3120, 3250 # Approximate total
No suction My Hoover Wind Tunnel vacuum runs but there is no suction. The last two or three times I used it, it shut itself off after having a burning smell. When I unplug it for the suggested 30 minutes, the motor will run again but no suction. What is wrong?? Should I just buy a nve one? This one is 8 years old.
Sounds like your motor bearings are going bad. This is generally indicated by the motor overheating, and the heat transferring out through the motor pulley, which is where the belt attaches. So, your machine is overheating, melting the belt, and then ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
I have a Eureka Mega Boss Central Vac Model # CV1801P. The suction works when the handle button is pushed left (floor mode) but no suction happens when the button is pushed right. When the floor attachment is hooked up and the button is pushed right, the brush rotates, but there is no suction.
... Eureka Vacuums
No suction I've only had my vacuum for a couple of months and it seem I have a similar problem but there is no clear blockage. It seems like I don't have adequate suction that reaches the accessory hoses nor the main one. I'm not sure where to start. I've taken the darn thing apart but I can't see any obvious malfunction. Any suggestions?
If you have low suction at the end of the hose, then you either have a clog in the hose or a clogged filter. Take the hose off and drop something in it to see if it comes out the other end. If you have suction at the end of the hose, then the dirt ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum
NO SUCTION HOOVER U8143-900 UPRIGHT HAS LITTLE SUCTION ALL BRUSHES ROTATE SO I'M SURE THE BELT IS OKAY. DO YOU ANY SUGGESTIONS????
I took mine apart, cleaned otherwise inaccessible pipes, and assembled\015\012it back (that went well, huh!). The clog was made of human hair and and\015\012other long fibers (carpet pieces, etc). ... Hoover U8143-900 Upright Vacuum
Hello - I have a Model 90 and it does NOT have any suction at all. It turns on and runs but with little suction
Its the filter problem it needs cleaning.\015\012First unplug the unit. Under the dirt collection cup, there should be a little "drawer" that houses a sponge filter. Pull that little drawer all the way out. Might as well wash the filter with ho ... Vacuums
Lost suction I've only used this vacuum a few times, it's practically brand new. Now, one I turn it on, it sounds fine, and the hose feels as if it's getting some suction, but it's not strong enough to actually **** things up from the carpet into the canister. I have completely emptied the canister and bought a new filter. Nothing seems to help.
TOSS IT and forget it! I have never used a hand vac that worked that was worth the effort of turning it on .... I suggest they are all junk ... I found very few vacuum cleaners ... actually **** especially anything made by dirt devil ... I do have a ... Dirt Devil Vibe AllPurpose Hand Vacuum Bagless Vacuum
My eureka vacuum model 4341 has no suction. The belt still turns the beater bar and the power still turns on but there is no suction both underneath and when using the attachment.
... Eureka 4341 Vacuum
Poor suction We bought a model home about 11 years ago and it had the Cental M&S Cyclonic Cleaning system. The suction has steadily been weakening. Now it is almost non-existant. I clean the filter bag in the main unit, but how clean does it need to be. Could there be a clog in the wall lines. If yes, how does one unclogg them. Thank you. I liked the system and would hate to just give up on it. Jean
This page has useful tips for unclogging a central vac. https://www.centralvacuumstores.com/cvs/trouble_help.php ... M&S Systems FX-3000 Bagged Central System Vacuum