Having problems with your Bissell 7700 Big Green Complete Vacuum, Carpet Cleaner & Hard Wood ?

Where to fix float in collection tank

\015 Manual says for wet cleaning make sure float is installed in collection tank. Cannot see where this fits. It is part no 23 in manual\015

Answers :

Hey Val, inserting the float is quite easy. Turn the tank so the flat side of the tank is facing you. Where it says, "Fill with Clean Water to here", there is a groove on the inside of the tank just behind the writing. Slide the rattle sounding weighted end of the float vertically into the groove. The float will only fit in one way.
Repair Help & Product Troubleshooting for Bissell 7700 Big Green Complete Vacuum, Carpet Cleaner & Hard Wood

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where to fix float in collection tank

Hey Val, inserting the float is quite easy. Turn the tank so the flat side of the tank is facing you. Where it says, "Fill with Clean Water to here", there is a groove on the inside of the tank just behind the writing. Slide the rattle sounding weigh ... Bissell 7700 Big Green Complete Vacuum, Carpet Cleaner & Hard Wood

My recovery tank is not collecting dirty water need answer on how to fix it? Thanks

Hoover carpet cleaner does not pick up water ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Little green machine pro heat pet the collection tank wasn't collection and dirty water was coming out of the bottom. i took it apart, cleaned it up and put a new "duckbill" gasket in. then it quit spraying, but i think i got that working again. now after i spray and get a good foam on the carpet, i switch to suction and it seems very weak. i can see the water moving (trickling) from the head into the hose but it is not reaching the collection tank -- actually, i am not sure where its goin


Recovery Tank red float disk rising to top when no water is in recovery tank

When you put the filter back on, you must have put it all of the way to the top. There needs to be about a 1/4 in. gap from the top of the filter to the top of the lid. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How do I fix Bissell Quicksteamer leaking from water tank through wheels? After I place the filled Clean/Solution tank on the Lower body of the QuickSteamer, water pours out from the body of the machine through the wheels even before I turn the power switch on. I checked the tank and there are no holes in the plastic tank.

I have the same problem... seems to be because of a bad, or worn, rubber gasket. ... Bissell Vacuums

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl

There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

Vax is dispensing from clean water tank but dirty water tank is not collecting anything

... Vacuums

I have a dirt devil platinum force carpet shampooer,bought it at the beginning of august this year. The sprayer seems to have stopped spraying from the main tank. The shampoo tank is letting the soap out but the main tank isnt emptying at all Can you help me fix this problem?

... Dirt Devil M091400 Platinum Force Wet/Dry Vacuum

Cant locate owners manuel for bissell proheat complete pet 2x does solution go in small tank and hot water in bottom tank ?????where does dirty water collect ??

... Vacuums

One side of my floormate H3000 dispenses more liquid than the other. How do I fix that? How do I clean the tank from the upper tank to the dispenser on the bottom? I do not have a manual and do not know how the liquid is routed from top to bottom. Thanks

... Hoover Floormate H3000 Upright Wet/Dry Vacuum

I own an Essick Air humidefier Model D46-720 and it leaks. When I fill both tanks and put them in place they continue to fill the bottom untill it overflows onto the floor and continues to do this until the tanks are emptied. I cleaned it and checked the float which was fine and it still overflows.

... Vacuums

I have a bissell proheat 8910 steamer and my red float fell out of the tank-in-tank. i need to know where it goes please. thanks!

The rounded part of the red float goes inside the bottom part of the tank in tank. If you push the bladder down with your hand you can see grooves on the inside of the bottom tank intnak. This is where the rounded part goes. the longer more straight ... Bissell 8910 ProHeat Clear View Upright Vacuum

Lost Part I have a 6.5 hp 18 gallon shop vac ultra pro. There is a part that goes into the inside of the tank and screws into the collection hose that attaches it to the tank. This part accidentally got thrown away when someone dumped it and now I cannot attach the hose to use the vacuum. Can this part be purchased separately?

I found a manual online for the shop vac and found the part number. Did locate part online.\015\012Thanks, ... Shop Vac Vacuums

We have a series 90S, 2.5 gallon Shop Vac. We used it for the first time to try and **** up water in the basement. Each time we turned it on, it would shut down after collecting less than 1" of water. We had to remove and squeeze out the foam sleeve each time, before it would work again (nowhere near 2.5 gallons!). Any ideas? Is the plastic sleeve that can move up and down inside, the float (poorest manual I've ever seen!)? Should there be a ball float that we're missing? Thanks for any s

Remove the foam sleeve when using the unit to pick up water.\015\012The float is in there to indicate when the unit has "enough" water in it. The float rises with the amount of water and when the water reaches a certain height the float is "pulled" ... Shop Vac Vacuums

Dirt al collects on filter not in the tank

... Bissell 5200 Upright Wet/Dry Vacuum

My collection tank broke, where do I find a new one?

You can get spares off the link belowhttp://www.vacsite.com/en/bissell-parts-1/bissell-parts/7700-big-green-complete-cleaner.htm ... Bissell 7700 Big Green Complete Vacuum, Carpet Cleaner & Hard Wood

Can't clean little green collection tank

There's really nothing you can do to clean it once the stuff has dried up inside. After using the machine, clean it every time! I put hot water in a sink and **** it up into the collection tank, repeat this three or four times. Every now and again ... Bissell 1400 Little Green Pro Canister Steam Vacuum

Tank filter and Float door: are they to snap into each other or is the door to flap freely

Click on the link below for the users manualhttp://canada.bissell.com/images/UserGuides/9500_107.pdf ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Tank not collecting dirty water

You most likely have a break in your suction hose. check at the base where it attaches. When you bring back the handle release, you can see lt. If you have the type that has the external plug in for the water, then you probably don't have the hose ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

How to fix the seals on my hoover cleaner/model#F7441-980 on my fresh wayer tank

... Vacuums

I fixed my scooba's check tank problem, now it has the service light on and keeps beeping 4 times

Amber it might be a valve stuck get a straw and blow air into the solution valve under tank on right or try droping scooba 2 inches from ground as this might reset the ball valve . ... iRobot 5800 Scooba Vacuum

We have a Hoover F7222900 and need a waste water tank latch that broke. I think the item number is 39457068, but not positive as no photograph was available in parts manual. Can this part be purchased or fixed. Causes a lack of vacuum. John

Http://www.usavacuum.com/Hoover-Steamvac-s/291.htm ... Hoover F7222-900 SteamVac Upright Vacuum

My old bissell 3510 upright vacuum seems to have no suction into the bag...I replaced a broken belt several days ago, and now the vacuum picks up debris, but seems to just collect it behind a wheel..The bag does not "puff out" like it used to...How can I fix this??

... Bissell 3510 PowerPartner Upright Vacuum

My Bissell steam cleaner appears to have suction at the connecting point for the receiving tank but it does not collect the disbursed liquid and cleaner either on the floor mode or the handle tool. The floor is soaking wet!

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Isn't picking up lint. Will pick up other things like flecks of paper but will not get any fuzz or fibrous material off any rug no matter what the setting. This is a recent problem. Have owned the vacuum for awhile and never seen this issue before. Is it an easy fix? I've cleaned the brush, cleaned out the filters, cleaned the dirt tank. Nothing changed.

Is the brush turning on the bottom of the machine ? If not It could be clogedup with stuff or the belt could be worn on it and it will turn but as soon as it contacts the floor it will stop turning. The belt is easy to replace by removing screw ... Bissell 3576 CleanView II Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0278 seconds