Having problems with your Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum ?

My carpet cleaner will not spray. Maybe a little thru the tool but not enough pressure to SPRAY

\015 My carpet cleaner will not spray liquid out My Bissell Proheat has stopped spraying also. The tool will spray a little but doesn't seem to have enough pressure to really SPRAY.\015

Answers :

Thanks to many others who have posted on similar problems -- water\015\012and/or solution sprays through the handheld tools, but not through the\015\012main machine.

As others have suggested, I removed the water\015\012reservoir, which exposes the 2 main water sprays mounted above the\015\012rollers. Using, pliers, I carefully slid the clips back. Gently but\015\012firmly removed the two red nozzles.

Elsewhere I have read\015\012suggestions to just do one nozzle at a time. However, I found out that\015\012if you remove both red nozzles, you can then blow through one side and\015\012it will come out the other. In my case, that dislodged a nice\015\012collection of crystal-like chunks (guessing it may be crystallized\015\012residue from the cleaning solution).

There was also a bit of\015\012blockage in one of the red nozzles, which I cleaned out. Make sure you\015\012can blow through both of them with little resistance.

Reassemble:\015\012Push red nozzles back into hoses. Using pliers, reposition sprung clip\015\012back over the red nozzle. Snap nozzles back into place. Refill tanks\015\012and power it up.

In my case, that resolved the problem of no sprays from the main machine. Sprays like new now. Hope yours does too!!

p.s. Make sure you do give it about a minute after you turn it on before you try spraying. If the pump is not allowed sufficient time to prime, you may not get proper flow.
Remove the bottom in order to access the innards and clean out all teh gunk you will no doubt find gathered there. Unhook one end of each clear plastic hose. Obtain a very small test-tube brush (only slightly smaller than the opening in the plastic tubes, approx. 3mm) and carefull scrub out each tube, then use the crevice tool from a vacuum cleaner (Bissell, of course), tape closed all but a small operening with ubiquitous duck tape, **** out the dirty water and any debris. Then reassemble the unit (good luck on that deal if you do not first secure an exploded diagram. Do not fail to do this or your wonderful Bissell will be laid to rest in your garage or landfill!)\015\012Before using, run several cups of clear water and a strong detergent like TSP to be sure all the "pipes" are clear and you see spray.  Good luck, Bill
Repair Help & Product Troubleshooting for Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My carpet cleaner will not spray. Maybe a little thru the tool but not enough pressure to SPRAY


Thanks to many others who have posted on similar problems -- water\015\012and/or solution sprays through the handheld tools, but not through the\015\012main machine.As others have suggested, I removed the water\015\012reservoir, which exp ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

No suction thru the hose of proheat. Will spray cleaner but will not **** it back up with the tools


Hi,Here is a tip that I wrote about my Bissel but I bet you have the same problem and the hose is clogged...Bissell Bagless Upright Vacuum ... Bissell Vacuums

The tool attachment for the hose on my Bissell ProHeat 2X CleanShot won't spray soap or water. The bristles on the tool rotate without a problem and the suction is working fine, it just won't spray water when I pull the little gray trigger on the tool.


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I think the pump needs to be replaced in my Bissell little green machine. Some water/solution is being pushed through but not enough to spray only drip, if I hold the machine up high while using it (ie on a table) it will spray a little. Is the pump easy to replace? is there anywhere to get a parts diagram?


I got my Little Green ProHeat when the product was first unveiled\015\012several years ago. Shortly thereafter, the nozzle itself developed a\015\012clog in the spray jet. Remove the nozzle from the end of the hose, and\015\012with the machine runn ... Bissell 1400 Little Green Pro Canister Steam Vacuum

When using the floor configuration, I can't get the trigger to cause a spray of either water or cleaner. When using the tool configuration and the hand device with brushes etc, the spray works well with the hand trigger.


The trigger on the handle for tthe floor configuration has become loose or broken. When you squeeze it, the action pulls a rod that runs down the length of the shaft and goes into the base and allows the water to spray. You need to check and make sur ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

No Suction I have very little or no suction on the cleaner. It suctions o.k. with the hand tool, but not the upright cleaner.


Between the top edge of the clear noozle and the lip of the tank that sits on it, there should be a black oblong gasket, if missing, you will have no suction there. The other is the filter on the tank lid, is it clean? ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My bissell proheat cleaner is letting out little spray solution when on the floor cleaner setting. If I press the sprayer on the attachment solution comes out of it even when it is not set on the attachment setting what should I do to fix i. How do I clean the water nozzles under the machine?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

No spray My Bissell Pro Heat 7901 will not put out any spray. I Took the pump out so I could get at it and disconnected the hoses. I put the one on the input side and the other in a bottle of water. Put the belt on the pump and turned on the machine .Nothing at all coming out of the pump. Where can I get a new pump? Also the lever that goes to the little flapper at the top under the clear plastic piece on the front that connects to the knob that changes from tools to floor broke off. Where can I


Search for bissell pro heat pump. bissell.com will not have it ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My bissell 2x proheat cleaner is letting out little spray solution when on the floor cleaner setting. If I press the sprayer on the attachment solution comes out of it even when it is not set on the attachment setting what should I do to fix it


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My bissell proheat 2x carpet cleaner is not spraying from the bottom or sucking up when turned on. The hand tool works just fine. I have made sure it was on floor cleaning when I used it to try and clean my carpet. the busshes are working but nothing else is happening this cleaner is about 21/2 years old and has only been used maybe 5 times so it has not had alot of use.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell 9300-1 won't spray from tools - Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

No spray My Bissell Pro Heat 7901 will not put out any spray. I Took the pump out so I could get at it and disconnected the hoses. I put the one on the input side and the other in a bottle of water. Put the belt on the pump and turned on the machine .Nothing at all coming out of the pump. Where can I get a new pump? Also the lever that goes to the little flapper at the top under the clear plastic piece on the front that connects to the knob that changes from tools to floor broke off. Where can I


Pump part number is 2107181, the diverter valve # 2136988. You can Bissell and they can tell you who may have parts near you, or you maybe able to order thru Bissell.com. Before you took it apart, were you getting water to spray out of the hose. I ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Bissell prohead 2x model 8960 won't spray on the hose tool. also when I use the foor cleaner part it leaves hair ball on carpet. shouldn't it be sucking all of this up?


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a Hoover SteamVac Spot/Deep Cleaner, model F5515. I've had it a little over 1 year. It will not extract dirty water from the floor. I've made sure the recovery tank is attached correctly and also that the stair tool is connected. Is there something else I can try??


... Vacuums

My bissell vac cleaner does not spray water out from the bottom but does from the tool ends


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell little green will not spray water - Bissell 14005 Canister Steam Cleaner


... Bissell 14005 Canister Steam Cleaner

Hoover F5915905 wont spray tool attachment - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Bissell 1425 Little Green ProHeat Steam Cleaner - had a problem with leaking. I got replacement parts, installed in the water / soap tank, now it won't spray out any water or soap.


Did you do this work yourself?\015\012What parts were replaced in the unit?\015\012Sounds like the connection to the pump has come loose. ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

Hand tool not spraying - Hoover F7411-900 Handheld Steam Cleaner


... Hoover F7411-900 Handheld Steam Cleaner

My steam cleaner pro heat 2X will not spray water. we have even tried the tool attachment and still nothing


Sounds like you may have lost the pump prime turn the unit off and hold the trigger down the one on the handle for a full minute then turn the unit on if that does not do you might have a clogged pump hose or a bad pump hope this helps you out ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

It won't spray cleaner through the hand tools. It's a bissell proheat 2x or something like that. Thanks.


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Heats up, but very little steam or pressure - Scunci SS1000 Handheld Steam Cleaner


... Scunci SS1000 Handheld Steam Cleaner

Bissell Little Green Proheat Pet Cleaner won't spray


... Bissell THE BISSELL LITTLE GREEN MACHINE Vacuum

Will not spray - Bissell Little Green Compact Multipurpose Handheld Deep Cleaner - Green


Solution line could be blocked or there is a blockage within the solution tank ... Bissell Little Green Compact Multipurpose Handheld Deep Cleaner - Green

My hand tool won't spray water on my hoover steamvac dual v all terrain carpet and hard floor cleaner


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0645 seconds