Having problems with your Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum ?

Leaking from left wheel when applying trigger onmodel 7901

\015 When we use the Bissell Pro Heat it leaks out of left wheel when applying the trigger. It sprays but also leaks out of left wheel. What is causing that???\015

Answers :

Sounds like a problem with the left spray nozzle, may be out of place. Either that or a line is loose and leaking. Either way you will have to pull the top housing off to check it over.
Repair Help & Product Troubleshooting for Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Leaking from left wheel when applying trigger onmodel 7901


Sounds like a problem with the left spray nozzle, may be out of place. Either that or a line is loose and leaking. Either way you will have to pull the top housing off to check it over. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

When squeezing trigger and Depressing Clean surge Button on Upper handle of the Hooover Steam Cleaner F5914-900 there is no "snap" indicating trigger rod is in place. Everything else went in as instructed. The screws and bolts were no problem this concerns me because the main complaint I read about this model was leaking from the trigger and clean surge and the problem was not getting the rod in place. No matter how many tries or people (three) it still doesn't occur.


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=552215\015\012Generic problem for all Vacuums\015\012When squeezing trigger and Depressing\015\012P ... Vacuums

Roomba left wheel too slow


... Roomba Pro Elite Bagless Robotic Vacuum

Water Leaking My CE6000 leaks water profusly (sp) thru the holes where the brush is in the front without me pulling the trigger. How can I stop this? It comes out rapidly and makes a huge mess. Thanks, Bridget


... Dirt Devil CE6000 Featherlite Wet/Dry Vacuum

Roomba circles My Roomba circles for a few minutes, then beeps 9 times and stops. A red exclamation mark appears on the left hand side of the controls. If you persist in restarting it, eventually I have been asked to clear Roombas wheels. As far as I can see, there isn't anything blocking the wheels.


Yes, this is known issue and if your bumper moves freely, you might be facing a sensor fault caused by poor quality of components.Here is a guide to fix ithttp://www.schneordesign.com/Avi/irobot/roomba_mod2.htmHave fun ... iRobot Roomba 560 Robotic Vacuum

My Bissell Proheat left wheel cracked and I have a replacement wheel but can't figure out how to take it off. There seems to be no way to unscrew the bolt that is holding it on. Can you advise?


I believe it just pops straight out. Carefully pry it straight out with a screwdriver. It should snap back in ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I have the Hoover max Extract 77 and when I'm cleaning the carpet, the clean water tank leaks on the floor, even if I'm not squeezing the trigger. The clean tank doesn't leak when I fill it, but once I place it where it fits and start using the vacuum, the clean water drains out on the floor. The dirty tank fills up, so the suction works, but, I don't know what is going on?


... Hoover Vacuums

I have a bissell proheat 2x and it leaks water around the wheel it holds dirty water but doesnt hold clean water.......and how do i remove the wheel on my bissell


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My bissell 1699 series will not spray water, the flow indicator barely moves, but when left tank on it leaked all over floor, so the water when left unattended came out. When I first hooked up the machine black stuff was on my carpet when I first sprayed.


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

How do I fix Bissell Quicksteamer leaking from water tank through wheels? After I place the filled Clean/Solution tank on the Lower body of the QuickSteamer, water pours out from the body of the machine through the wheels even before I turn the power switch on. I checked the tank and there are no holes in the plastic tank.


I have the same problem... seems to be because of a bad, or worn, rubber gasket. ... Bissell Vacuums

I am working on a u5290-900 hover vacuum ,when operating dust leaks out under dirt cup cover. i put a piece of card board on top of cover so extra presure would be applied to the top of cover. this seams to have stoped the leak , before adding the card board the cover seamed to lift at the back when cover was locked into place. what do you think?


Dear Sir:Will be better idea to replace the cup cover. The pice of card will not function for a long time. Proceed before another extra problem coming.God bless you ... Hoover U5290-900 Upright Vacuum

Vax rapide sping leaks. trigger loose


... Vacuums

Water leaks where the hose connects to the trigger handle.


Be sure to get a good washer on with the connection. They're easy to buy at any hardware store. You can also put white plumbing tape around the threads before screwing them in to make it really fit. ... Bissell 1631 PowerSteamer ProHeat Canister Vacuum

Front wheel problem


I would send it to protechrobotics. they will test all your components and let you know what needs to be done. if the repair is more than it's worth--they will help you out too.http://www.protechrobotics.com/ ... iRobot Roomba 4210 Bagless Robotic Vacuum

My steam vac leaks water quickly out of the tank all over the carpet even when the trigger isn't touched. I checked that all the hoses were properly seated. What do I do next?


Might have a problem with a faulty gasket or the inlet valve on tank ... Hoover Vacuums

Attachment problem used a new unit w/attachment for 5 minutes...dispensed solution in a powerful triangular fashion. Then the fluid quit dispensing out of the attachment nozle amost like the pump quit working. Primed the unit several times w/ no success. checked for clogs. can't tell if the floor portion is "pumping' or just dribbling solution onto the floor with the trigger. can see no leaks at this point. unit worked for about 5 minutes on apholstery


Make sure everything is filled and secured tightly, if this a new unit it should be something simple ok, also check where machine folds down that the solution hose is not being pinched its right behind the dirty water tank ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Bissell proheat 2x and it leaks water around the wheel area and drains the solution tank quickly.


Check to see if the seal came off the tank and stuck in the dock ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Water is not being discharged. I have filled the reservoir that holds the carpet cleaner fluid And I have filled the water container. I know how to use the cleaner, it has always worked, But now, no water is being discharged to the carpet. I turn it on, squeeze the trigger, but nothing comes out. The wheel that is suppose to spin (to indicate that water is being discharged) is not spinning. Everything else works. I.e. the suction works, and the hand held accessories work.


That means that the pump belt is worn and it needs to be replaced. You can get a replacement belt and view the manual here:Bissell Pump ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

My Hoover Whisper Cyclonic is collecting the dirt but not taking it into the cylinder. The brushes were at one point starting and stoping due to the belt periodically turning,now the brushes are turning and the dirt just collects and I'm starting to smell a an oder like rubber burning.I've taken it apart and tried to make sure the is no clog. The one hose that I can't check is in the back right base, above and left of the right back wheel.


... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Constsntly applys water even when shut off/ not running took apart handle I believe trigger is broken


Hi there SmartAlec from NelsonVacuums.com.au here. The trigger definately could be broken but before you take it to a repairer i would really thouroughly clean any little f ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hello I need a set of rear wheels to my TurboMaster Hoover. If you provide me an Email address, I can send you the drawing + picture. Is it possible to purchase it from you. (I'm living in Israel) Best Regards Zeev Priester 24 Beit Ha'Shita st' PO Box 698 Bat-Hefer 42842 Israel Mobile: +972-(0)52-4299716 Email: [email protected] [email protected] SKYPE: zeev.priester


... Hoover Vacuums

Where would OIL come from by the right side back wheel?I have a hoover wind tunnle model # u6425-920. Does the drive moter have oil in it if so and it is leaking should we replace the motor?


The motor does not have oil in it. The onnly thing I can think of is that if soemone had tried to free up something by using a spray lubricant, and not it is running out. I've never seen this issue. You would have to let a repair shop look at it. ... Vacuums

The trigger in the control housing doesn't work and leaks water/soap all over. I need to purchase a new one.


Hi there it's SmartAlec from NelsonVacuums.com.au here. If you are in australia i can help you out i am a rainbow dealer. send me a message through the website above or giv ... Rainbow E series Canister Wet/Dry Vacuum

My Discovery 4210 Roomba will run normally for about 20 minutes on a smooth, wooden floor. It then begins the following sequence: run forward a few inches, turn in a tight counter-clockwise circle a few revolutions, stop, power off a few seconds, power up, repeat cycle from forward run. The sequence can be repeated seemingly endlessly if I don't turn off the power manually. I've replaced the motor, and led revolution sensor system on the left drive wheel. I've blown the dust out of everywhere. A


This robot vacuum has a electronic micro processor that controls the unit and tells it how to operate and where to go based on programmed parameters. It's quite a technical marvel. I have dropped a link here for contacting the company tech support li ... iRobot Roomba 560 Robotic Vacuum

Vacuum leaking? on the lower left of the back of the machine, there is a molded round piece about the size of a half-dollar. when I tirn the machine on and cover this round extrusion, vacuum power increases. what is it?


I don't know your particular model but it sounds like this is either where the hose attaches or a spot to help clean out anthing that might get stuck in the hose while vacuuming. Hope this helps! ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0401 seconds