Having problems with your Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum ?

How do I replace the elevator lever arm on my bissell 7901-6 steam cleaner


Answers :

I have a bissell 7901 and i recently replaced the brush belt. now my problem is the brush while is working the brush is not making contact with the carpet. how can i adjust the brush?
Repair Help & Product Troubleshooting for Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I replace the elevator lever arm on my bissell 7901-6 steam cleaner


I have a bissell 7901 and i recently replaced the brush belt. now my problem is the brush while is working the brush is not making contact with the carpet. how can i adjust the brush? ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Replacement parts where can i find replacement steam pocket towels online for the shark ultra steam blaster hard surface cleaner? I went online to www.sharkcompany.com & www.sharkvac.com and when I enter my model number S3325 search comes back with 0. Thanks


You can found them on amazon, take a look here: Amazon com Euro Pro S3325. I hope this was helpful. Cheers ... Euro-Pro S3325 Handheld Steam Vacuum

I have a Bissell Model 8905 Carpet Cleaner. I was going to replace the belts because the pump belt broke, but when I turned the machine over, a small piece fell out. It looks like a tensioner arm because it has a small round part at each end on opposite sides of an arm that has an offset or "dogleg" in it. I am looking for an exploded parts diagram to determine what the part is and where it came from.


... Bissell 8910 ProHeat Clear View Upright Vacuum

My bissell proheat upright steam cleaner is spraying out through the attachments just fine, but will not spray to the floor when using upright. we've taken it apart to find that there is no water at all going through one of the hoses, but it appears the hose is connected behind the on/off and heat switches, we can't seem to figure out how to get in there to replace that hose....any suggestions on how to access this?? just curious how you would get in to replace the hose, we know it is the hose..


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Bissel steam cleaner and I had to replace the brush belt and I don't have a manual to replace it back on the machine.


Here is the manual for your model:User Guide (PDF) ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have Bissell Model 1699-R Proheat carpet steam cleaner one of the tubings that connects into spray got mixed with some tubings during tubing replacment to the point that tubing that is conected into flow indicator cap does not turn at all to show if the chemical is sprying or not.i am looking mainly for tubing water/chemical diagram in order to verify the right connection.please help if you can bissell user. thanks


... Vacuums

Replace bladder in bissell proheat steam cleaner


... Bissell Vacuums

Replacing the Brush and Pump belt on Bissel Steam Cleaner 1901


... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

How to replace water pump on Bissell 66Q4 steam cleaner?


... Bissell 66Q4 Stick Steam Cleaner

How do I replace the elevator levers on a bissell pro heat power steamer 7901


... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Bissell Powersteamer Pro 1697-m elevator lever replacement


... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bissell 1425 Little Green ProHeat Steam Cleaner - had a problem with leaking. I got replacement parts, installed in the water / soap tank, now it won't spray out any water or soap.


Did you do this work yourself?\015\012What parts were replaced in the unit?\015\012Sounds like the connection to the pump has come loose. ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

Need to replace elevator arms - Bissell 7950 ProHeat Upright Wet/Dry Vacuum


Try this linkhttp://www.vacsite.com/en/bissell-parts-1/bissell-parts/7950-upright-deep-cleaner.html ... Bissell 7950 ProHeat Upright Wet/Dry Vacuum

I have a Bissell 1623-1 Steam Cleaner. It will work good for about 2 minutes and then after that it will not dispense cleaning solution on floor or through the hand held wand.I have replaced both drive belts with no improvement. I have cleaned it and found no obstructions in hoses and spray nozzles, put back together and it still will not dispense. Is it possible the pump or solenoid is no working? Aaron


... Bissell 1623 Steam Cleaner

Where do the springs go when you replace elevator arms on Bissell Model 8910?


Based on what you've described, you may want to contact a BISSELL Authorized Service Center to have a qualified technician inspect your machine. Here's a quick link to locating one. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

How do I replace the roller? - Bissell 7350 PROdry Upright Steam Cleaner


Remove the six screws from the bottom of the machine, remove the belt cover, and slide the brush out.Here's a link to the downloading the user guide.\015\012 ... Bissell 7350 PROdry Upright Steam Cleaner

Replace belts on bissell proheat 2x complete pet steam cleaner model 8960-2


... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

HOW DO I CHANGE THE BELTS ON A BISSELL STEAM CLEANER


On your housing you will see a plastic cover adout 4 inches long remove this piece and you should see where your pump belt goes. flip your steamer over and remove the little red retainer that sits by the belt you have located. at this point you can t ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

HI, I'm looking to buy a Bissell 9500 steam cleaner. I was wondering can you use the steam cleaner as a regular vacuum? The store manager says yes But I'm unsure..


I agree its not wise to use machine as a standard hoover thus it can cause overheating and other problems. best stick to what its meant for :-) ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell steam mop not working - Bissell 1867-7 Steam Mop Chemical free hard floor cleaner-Green Cle


... Bissell 1867-7 Steam Mop Chemical free hard floor cleaner-Green Cle

Bissell carpet cleaner not dispensing water - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Brush will not spin on the steam cleaner - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have a steam cleaner and i can not get the black arm brush to keep one side up and when you trun on the steam cleaner the brush dose not spin when you start to clean the floor but it will spin when you have it siting up right


Sounds like you could have an elevator broken (part #2000010). You will have to take the top off to replace them or to check to see if one of them is broke. There is one on each side so when the handle is in the upright, they push againsy the brush ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bissell steam cleaner water leaking - Bissell 1699 ProHeat Clear View Upright Steam Vacuum


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

How do you install the 210-1128 Bissell carpet cleaner steamer brushroll on the Bissell ProHeat 8910? The prong on the replacement roller is larger in diameter than the one it is replacing. How do you open it up enough to remove the plastic piece that is attached to the steamer - the one with the belt??


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0824 seconds