Having problems with your Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum ?

Water/solution flow problem

\015 My bissell pro heat model 7920, stopped spraying, it is dry, but it still sucks in. nothing coming out... dry!... why?\015

Answers :

Check your belts. if your brush is not spinning when you have it on, it is a belt. goto bissell.com and there you will find on line videos to help you with this troubleshooting process, it will also tell you how to change it.
Repair Help & Product Troubleshooting for Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Saeco Odea Giro pumps the water but the internal spline or gear is not turning moving the ground coffee grinds to the point where the water can pump to the front exit lines so the water is pumped into the over flow resevoir. How do I replace the gear or check to make sure this is the problem. I want to replace this myself.. Also how do I get the unit apart it seems to be bullet proof. Is this a common problem.

It is a common problem if it is what I think it is. However your description is a little confusing. So the coffee does get ground up, but then has a hard time getting to the next stage of the process? Please clarify... And no water gets pumped th ... Vacuums

I have descaled my nespresso turmix tx 150 but still have a problem with the flow. The espresso button flows properly but the large cup starts and then stops after a few seconds.

... Vacuums

Hoover F7431-900 my carpet shampooer/steam vac was working fine until the brushes at the bottom of it just miraculously stopped working. they wont spin at all. Is this a motor problem? perhaps a water flow problem? please write back if you can be of any help. thanks

If the screen is not dirty, and the flapper valve to the turbine inlet is open, then the problem is mostly a stuck turbine impeller. The turbine impeller on my F7431-900 has seized TWICE!! The shaft for the turbine is not made of stainless steel, t ... Hoover F7431-900 SteamVac Vacuum

Hoover steam vac model 7210-900 problem: when i install canister of cleaning solution it immediately starts flowing out of the outlets where the brushes are located. any idea on solution to thisproblem?

Http://hoover.com/support/video-instruction-guides/ and see the video respectively according with your model, use the common sense for troubleshooting.God bles ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Rival Beverage Fountain does not flow. Could it be an internal motor problem? Lights work

... Vacuums

Bissell 7700 series, pro heat all rounder. Won't spray water. Have checked the line from the unit to the spray nozzel and all seems clear. Water doesn't seem to be flowing from the tank to the end of the unit where the hose connects into. What could be the problem? Any assistance would be greatly appreciated. Thank You. Steve

HelloGrasp the cleaning solution tank, and remove it from the machine. Reinsert the tank into the machine, making sure it fits snugly in the machine. If the tank is even slightly dislodged, water cannot get into the machine. Visually insp ... Vacuums

I have a Kenmore canister vacuum - model 25614506. Some time ago, I was not able to turn the vacuum off with the on/off switch, but could still use the vacuum. Turned if off/on by pulling the plug. The other day when I went to plug it in, I heard a pop. Now the sweeper runs but the vacuum cleaner does not **** - no air flow. What could be the problem. The cleaner is only 4 years old.

The motor has an inline fuse ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

Shark s3325 stopped working while steaming; thinking the unit had ran out of water I allowed unit to cool before refilling, however unit over flowed with only 700ml water added. When I plugged unit back into outlet it would not turn on (red light was not on) but I hear a click upon plugging in unit, when turning unit power button on and when turning on the handle switch. Please advise how to resolve this problem.

... Euro-Pro S3325 Handheld Steam Vacuum

I recently purchased a house with a Filter Queen Central cleaning system model FQ-7500. My problem is that instead of sucking air it blows the air out. How do I reverse the air flow?

Never seen this model but it is on of two things,the hose is hooked up wrong or the motor is either switched in reverse or the motor has been reversed with wire leads ... Filter Queen Majestic Canister Vacuum

My vacuum is not sucking theirs a yellow pellet that indicates the air flow. And when i turn it on it moves and i think thats part of the problem i don't know what to do i lost my manuel help.

Try emptying bag. then clean filter. then unblock hose using a broom handle. let us know how it goes. ... Hoover Vacuums

Water/solution flow problem

Check your belts. if your brush is not spinning when you have it on, it is a belt. goto bissell.com and there you will find on line videos to help you with this troubleshooting process, it will also tell you how to change it. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Suction Problem I took my unit to my work and used it, when I returned home it wouldn't suck up anything. I took the recovery take out and it has inward suction. Shouldn't that be outward, so it goes into the tank? It also blows out of the bottom by the brushes. I check the filter in the bottom and that is fine. Is it possible that it is somehow reversed the direction of the air flow (rotor running backwards)? I am perplexed. What am I missing?

There is a stand pipe seal where the bucket sits on, and if it isn't there or out of place could cause a suction problem like you said yours is doing. In the picture it is #10. The motor seal may have gone bad and is leaking # 15.\015\012 ... Hoover F7220900 SteamVac V2 Upright Vacuum

Flow Indicator Not Moving, Not Dispensing Anything

Does water squiret out of the hose, if it does, then check the heater inside the handle to see if it is clogged where the 2 water lines hook to it. The other reason, you may ghave a bad pump. But check the back edge to make sure the top isn't comin ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Permanant water flow

To check the water lines you have to take the top housing off, you may have a water line that came loose. It it is leaking from just under the water tank, there may be a line unhooked there. Check the seal that the tank sits on, it may have to repl ... Hoover F7431-900 SteamVac Vacuum

When i turn on my auxilliary pump, water still flows out.

Leaking from where? The jets up front? If so you need to replace the electrical water control valve. Visit http:www.Michco.com to get a new one or assistance. ... Minuteman C46000-00 Self Contained Carpet Extractor Vacuum

Bissell Proheat Problem

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

The problem is that the cleaner is heavy to use and does not pull itself forward as it should. It has been back to the supplier 3 times but they have not fixed the problem. The LED's on the front flicker and I think it may be a problem with the sensor. If you have any info. on how the sensor works and where it is located it would be useful as well as any other suggestions to fix the problem please.

If it heavy then do some muscle work and body building ... Vacuums

My Riccar 1700 will intermittently lose power while vacuuming. I have had the vacuum for 4 years and this is the second time that I have had this problem. The first time the authorized repairperson said the problem was a dirty hepa filter. The second time, the repairperson put on a "pig-tail"(?) and said that he did not have a shut-down problem when he tested the vacuum in the store. I just picked it up from the store today, brought it home and the same problem occurred within minutes.

... Riccar RC1100 Compact Vacuum

Kenmore intuition w/power flow direct drive beltless system

... Vacuums

Problem with hepa media filter 86889

... Kenmore Vacuums

No water or soap flow

Does liquid squirt out of the hose. If it does then probably the heater inside the handle asm. is clogged. Take out the two long screw that hold the top handle on and remove it, then near the bottom of the handle, near the bottom are 2 more screw t ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Oreck Vacuum Cleaner problem (upright)

The belt has stetched and needs changing. ... Oreck XL2200 Bagged Upright Vacuum

Power unit suction problem

Have you checked the filters? ... Electrolux Central Vacuum

Bissell big green clean machine trigger problems

... Bissell 1672 BIGgreen Wet/Dry Vacuum

The Shark floor stem cleaner Will not produce any steam. What is the problem? I have ahd the machine a year and never had any problem. the problem just started.

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0260 seconds