Having problems with your Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum ?

How to release and withdraw water solution to clean carpet.

\015 I have a Bissell ProHeat Carpet Cleaner -- but no manual...once I have filled the tank and turned on the machine, what is the procedure to follow for drag and drop? do I run the carpet cleaner like the vacuum? When do I push the yellow lever to release the water solution? \015\012\015\012I am never sure of the proper motion of running the machine across the carpet to properly clean. What's the correct steps to follow?\015

Answers :

Problem resolved by contacting a local retailer who provided instructions.
Repair Help & Product Troubleshooting for Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to release and withdraw water solution to clean carpet.


Problem resolved by contacting a local retailer who provided instructions. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My hoover max extract carpet cleaner won't release the cleaning solution. It's just spraying out the clean water and not mixing with the cleaning solution.


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

Cleaning I cannot get the cleaner to release solution on carpet. have lost manual. is there a trick to this? I have tried squeezing trigger handle to dispense solution with no luck. have followed instructions (2 capfuls cleaner, fill with hot water to fill line) on filling tank.


Either you have a pinched or clogged water line, or the rod in the handle is pushing down like it should. The drw back is Bissell has deemed this unit and its parts obsolete. So any parts are hard to find.\015\012\015\012 ... Bissell 1950-3 Quicksteamer Plus Vacuum

My Bissell proheat 2x model 9200 is not dispensing cleaning solution. I hold the trigger and the carpet doesnt get wet at all. i poured water on the carpet and it sucks it up. the cleaning solution does mix with the water but it not being dispensed on the floor.


Hi, \015\012when last did you service the machine?\015\012\015\012i believe should service the machine.\015\012try to open the machine.\015\012\015\012when opening make sure you notice where the part you are remov ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My bissell proheat carpet cleaner wont dump water or solution. It will however **** up water and solution if dumped on the carpet. Help I cant clean up doggie pee and it smells in this heat!


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

Replaced the pump for a 9300 M Bissell Proheat 2x as the water solution was not releasing to the carpet. Once rehooked the lines the solution appears to be coming from the water tank and returning to the used tank and bypassing spraying on the carpet. How can I be sure the hoses are hooked up correctly?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

The cleaner/water solution dispenses into the carpet, cleans it, pulls out the pet hair, but no dirty water goes into the dirty water reservoir! is all this dirty water going into my carpet?


The pet hair may be clogging the water return inlet I suugest you clean the bushes and inlet as well ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have the Bissell 2x proheat. There is no water being sucked up from the bladder and the cleaning solution is not being sucked in either in order to get to the carpet. On water rinse the carpet gets wet but I'm not seeing any water going through the clear front piece. I live in Harvest Alabama. Where can I take it to get fixed if it needs it?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I HAVE A BISSELL PROHEAT CARPET CLEANER I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I HAVE A BISSELL PROHEAT CARPET CLEANER 7920 I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Pressing the handle to release cleaning solution does nothing. The cleaning solution does not come out. Carpet is dry.


Check to ensure there is liquid in the water tank and the formula bottle.\015\012\015\012Note: This machine will spray with liquid in the Water tank only if the machine is set to the Water Rinse setting. On any other setting, you need to have l ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My hoover steamvac powermax is releasing the water to clean the carpet but there's no suction power so the water is remaining in my carpet


... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

Carpet Cleaner i was cleaning my carpet and it stopped putting out water. I changed the water tank and checked the solution everyhting was fine. what chould I do


Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be o ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Picture you sent for me is not the same model as I have mine is a dual vac v carpet cleaner with the solution tank on the side of clean water tank so I need to know how much solution to put in solution resevoir.


The solution tank injects the cleaner depending on the selection you have make such as light or heavy. You fill the tank with cleaning solution. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Bissell carpet cleaner does not spray water only cleaning solution. Water does not leave bladder.


... Bissell 8910 ProHeat Clear View Upright Vacuum

I have bissell Model 1697 Powersteamer Pro. i filled bucket up with water and no water is releasing when I try to steam clean, carpet is dry.Am I filling it up correctly, manual lost. Is there a way to view the online manual.


The pump belt may be worn and that is why it is not dispensing water. Here is a link where you can get the belts and you can view the manual: ... Vacuums

Suction button Although my Hoover Spin scrub is working perfecting dispensing the solution, when I go to suck up the solution from the carpet--I am having problems with the RED suction button that keeps popping up. I have to stop the cleaner and lift up the dirty water container to break the suction. Ive tried cleaning the netting that is encased around it, but still no luck. Any help would be appreciated! Thanks


This happens when the filter on the inside of the lid for the dirty water tank is pushed all of the way up. You need to leave a 1/4 in. gap from the top to the top of the filter ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Kirby sentria Im cleaning my carpets and its not sucking the water up off the floor. and do you have to use kirby cleaning solution????


Vac want pick up water out of carpet hoover steam vac delux ... Vacuums

I have a Model F7431-900 and is a SteamVac V2. When I press the trigger for water or cleaning solution, the water just runs right through it even after releasing the trigger. What kind of problem do I have? Is it most likely a valve problem? I'm handy at fixing things and want to avoid the large repair bill if I take it in.


This sounds like a stuck solenoid. The Dual V models use solenoids to contol soap and water flow to the floor, along with a pump unit. If your unit is 12 months or less it is under warranty. I am not sure about the cost of the solenoid. ... Hoover SteamVac V2 6-Brush Widepath F7426-900 Vacuum

My Bissell carpet cleaner model #1697-W will not dispense the cleaning solution and will not **** the water back up--also need to know how you get to the belt on the machine?


The drive belt for the pump is located under a cover on the front right side as you look for the front of the machine. Just lift it up and the belt will be obvious. If it is not sucking then make sure that the dirty water tank is empty and that ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

DOES NOT **** WATER FROM CARPET OR RELEASE THE SOLUTION IT IS A BISSELL 9500 PROHEAT 2X


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

MY CARPET CLEANER WILL NOT RELEASE THE WATER AND SOLUTION. I CAN'T FIND MY MANUAL.


Click HERE for a copy of the User's Guide. ... Bissell 8910 ProHeat Clear View Upright Vacuum

The carpet cleaner comes on and the heat source is working in it, but the machine is not dispensing the water and cleaning solution. It does have consistant suction. What could cause this type of problem?


Most likely a bad belt you might think it looks good but i'd say thats your prob after you replace it you should be fine if not we can go deeper ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

No water or solution will come out of my Bissell when trying to clean the carpet


Make sure there is water in the tank and that the autoload assy is not blocked. Is the pump belt still connected? There may be a blockage at the heater or finally a new pump may be needed. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Bissell ProHeat I really loved this carpet cleaner and it seemed to work extremely well.  However, now it won't dispense either the water or the cleaning solution.  What's up with that?


The first thing to check is the belt: if the rubber belt from the motor to the pump is stretched or missing, the pump will not operate. If the belt seems fine, either your pump has gone bad or you have a clog somewhere in the lines. \015\012 ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0838 seconds