Having problems with your Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum ?

The water sprayes out but will not pick up and go into the tank. It leaves the carpet soaked.


Answers :

When such a problem occurs there are a couple of things which should be checked.
Generally the vacuum does not pick up water as a result of low pressure in the suction. The suction hose should be checked for holes and proper connectivity. The seals which are used to connect the suction hose to the tank should also be examined and if possible replaced.
Thirdly the vacuum should be serviced and the fan oiled as this could also bring about low pressure in the suction.
Hope this solution has been helpful?
Repair Help & Product Troubleshooting for Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The water sprayes out but will not pick up and go into the tank. It leaves the carpet soaked.


When such a problem occurs there are a couple of things which should be checked.Generally the vacuum does not pick up water as a result of low pressure in the suction. The suction hose should be checked for holes and proper connectivity. The se ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Why wont my kirby carpet cleaner pick the foam and water off the carpet leaving my carpet soaking wet?


Is the carpet washer attached to unit is the belt hooked up? don't use the vacum head you well get shocked.be careful ... Kirby G6 Bagged Upright Vacuum

My shampooer only sprays a single stream of shampoo and water whenever I use it on the carpet... That and I can't get it to lay a nice even layer of shampoo to soak in and then pick it up...it always does a single heavy stream and tries sucking it up immediately after it's sprayed out?


You are probably missing the foam screen on the tank outlet. There should be a plastic disk with a fine screen in it on the tank outlet. If the screen is missing, foam will not be produced; and just soap water will be sprayed out. Sometimes the scree ... Kirby Shampooer Shampoo Hose G3 Ultimate Diamond Vacuum

Hoover Steamvac F5892-900 leaving lines on carpet, does not seem to spray


Is the cleaner sucking up the water like it should? If not , check that the filter on the inside of the lid has a 1/4 in. gap between the filter and the top of the lid. Either that or the water isn't completely being shut off when you release the t ... Hoover F5892-900 SteamVac Upright Vacuum

My Bissell Proheat Turbo has poor suction and leaves the carpet too wet. Is there a way to improve the suction so the carpet will be left just damp not soaking wet?


Flip the unit over you will see a grey panel that looks like a V with 6 or 8 screws remove it and you will find a black cover I think it has 2 screws remove it and you will see a gasket seal for the bottom for the motor mine was white some times ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My carpet cleaner won't pick up the dirty water... it works fine to spray out, but not to pick up


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My Bissell Pro Heat Pet will spray water but not pick it up when cleaning the carpet. Is there anything I can do to fix it? The furniture attachment hose picks up water well. It seems like it could be a bit more powerful of a draw on water. I don't know it that has something to do with why the floor cleaning sucktion doesn't work. Thank you for your time. Jenn


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bissell Vacuums

IRobot stopped picking up larger bits from the carpet. It picks up the dust, but anything larger, it leaves behind. Have changed the filter/brushes. Is there anything else I need to do


Its sounds like the brushes aren't turning. Pull the vacuum and bin off the back and start it and look to see if the brushes are turning. ... iRobot Roomba 560 Robotic Vacuum

Spray does not soak the carpet like it used to.


You probally have a clogged line. Either take it apart yourself and manually unclogg each line (requires a compressor) or take it to a local vac shop and have them do it. ... Bissell SpotBot Hands-Free Compact Deep Cleaner - Silver

My steamvac will not **** in it just blows air out and does not pick up the water solution once it has been sprayed on the carpet.


I finally remedied this "no suction" problem with mine. At front of recovery tank is a plastic panel that can slide up and down. Make sure that front panel is pushed COMPLETELY down when cleaning floors. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Bissell prohead 2x model 8960 won't spray on the hose tool. also when I use the foor cleaner part it leaves hair ball on carpet. shouldn't it be sucking all of this up?


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

The suction on my Hoover Spin Scrub 50 is suddenly not working. This is the 2nd or 3rd time I've used it and until now it has done a great job. But now it leaves my carpets soaking wet with no hope of drying and no dirty water is being suctioned into the dirty water tank. Help!


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My vax rapide has lost suction unless you press down on the front.It worked fine the first few times I used it but now it leaves the carpet soaking!


I fixed mine by taking the spongey filter out and washing it through. Then, important step, dry it with a hairdryer and test the direction of air flow by putting the dryer up close to it and feeling if it comes out the bottom. For me, only one way wo ... Vacuums

When I was using my Bissell ProHeat 7901, I smelled something hot (almost burnt) and turned off the vaccum. When I turned it back on, everything seemed to be working, but the vaccum part was not making the same sound. The bristles are still turning, but it isn't picking up as much and is leaving quite a bit of lint on the carpet. Could the belts be worn? How do I tell? Thanks!


Ya that is probably the issue. Here is a link to the belts you need and to the manual which has instructions:Bissell ProHeat Belts and M ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I have a dirt devil ce6600. Sometimes when I spray the solution it leaves streaks on my carpet that won't come out. What's the problem?


... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

Does not do a good job picking up the shampoo water. Leaves the carpet streaked and wet! Audrey


Similar experience I had with this product and all I did was take it back to store for a trade-in and make do with another (morphyrichards.)Try this too in your location, it will do you a lot of good.Cheers. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I want to brush the pile up on my carpet do I need a special attachment to do this??. I have shampood it and it still seems a bit flat. When I shampood no water/foam filled up in the front tray???I am sure I had attached everything correctly. The only thing I can think of is when I attach the brush and tray to the front of the machine, do I turn the handle back to the right way up, or do I leave it upside down, this is the one that picks up the belt.


Here's my online guide for using the Kirby shampooer....\015\012\015\012 ... Kirby Ultimate G Bagged Upright Vacuum

My machine wont pick up the dirty water. If I take the cover off the recovery tank there is a lot of suction but it wont **** up the water. my carpet is soaked. What can I do


At power head clean out area before power head also look for small hose and clean out and look at rollers,i hope this works if you have directions still they should be able to help you out some more.thanks ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

The vacuum has started leaving what its picking up all over the carpet can only use the nozzle whats up with it


The dirt path is clogged ... you will have to remove the clog. ... Bissell 3750 Lift Off Bagless Upright Vacuum

I have a 1697 powersteamer and it will not pick up the water after its been sprayed on the carpet--------Suckers Broke!


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Bissell carpet cleaner does not spray water only cleaning solution. Water does not leave bladder.


... Bissell 8910 ProHeat Clear View Upright Vacuum

I own a hoover steam vac model f5915-900 and i currently have two problems. 1. the brushes are spinning at a much slower speed. 2. the steam vac is not picking up the water it leaves on the carpet. Please help Josie


The reason the brushes are not spinning is because the belt is slipping, the belt is the bad that connects to the brush to a shaft that makes it spin. Next problam is it is probobly clogged. so water is not going through all the way ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Not picking up no suction leaving black marks on carpet


... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

My filter queen just had the motor rebuilt last year and was basically a brand new unit when I got it back. It is not picking anything up now when I vacuum. The beater bar on the carpet attachment is turning fine and when I take all the attachments off the hose I can feel the suction being created like it should be picking up debris just fine. I have emptied the canister even when it did not have much in it; however, it still will not pick anything up off the carpet. It picks up debris tempo


It sounds as if you have a clog inside the "Power Nozzel". They mention that there are "no user serviceable parts within the Majestic® Power Nozzle" My advice would be to see if you can see a clog with in reachable distance and try to remove the ... Filter Queen Vacuums

My Kirby Heritage II vacuum is not picking up dirt up out of the carpet like usual, and I have to keep setting it lower to pick anything up. I finally get it to such a low setting that it starts sucking the carpet up and makes a whirring noise, and starts smelling. Every time this happens, we find the belt has been burned. We are wondering if the brush roll inside with the brushes that pick up dirt are worn out and too short?


... Kirby Heritage II Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0505 seconds