Having problems with your Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum ?

How do you replace the pump on the bissell 7920 proheat pro-tech

\015 I have had my bissell for several years. then on day it just would not release the water to clean. i have checked everything and was told it might be the pump. were does one start? thank you\015

Answers :

It could be the pump, but try these othere things first, to replace the pump, you have to take the top cover off to get to it.
\015\012
Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be on the tank, not in the hole, this is for the soap bottle, there is a seal on the bottom of it as well. The flow indictor cap is leaking air or maybe is too tight. If you had the top cover off, make sure that the tubes are routed right so as not to get pinched when the cover is put back on, the smart mix knob should be in the water setting and that the piston is on the bottom of the smart mix knob. Pump is bad. Try running a mix of vinegar and water to see if that unclogs the lines. Is the top cover and the base tight together in the back, sometimes the top breaks loose and it will raise up and it can't spray, just refasten it down.
Repair Help & Product Troubleshooting for Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you replace the pump on the bissell 7920 proheat pro-tech


It could be the pump, but try these othere things first, to replace the pump, you have to take the top cover off to get to it.\015\012Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Replace pump in model 7920 - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


You're better off letting a small appliance store service dept handle repairs on this unit. They require tools to dismantle them. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

How to change pump belt on bissell pro heat - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


First take off the cover on the left side oif the top cover, then turn it over, remove the screw holding the red lock and pull the cap and brush roll out, remove the cap, remove the cogged belt, then you can put the new pump belt thru that slot, put ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

New replacement pump on Bissell ProHeat Protech not working


Made a mistake, my model # is bissel 7901. Won't spray water.\015\012When you turn the machine on, it sprays for a minute or so then stops. All belts are in place..water tanks and spray bottle positioned correctly. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Bissell Proheat Pro-Tech #7901 will not spray any liquid to the carpet and red cross indicator is not turning,but comes out of attactments


The 7920 is a 220 volt version of the 7901. I found a shop in New Zealand of all places that has service manuals on line. They are sort of picture books, but using them has saved me a lot of money as it makes repairing much easier. Here's the link yo ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bissell Proheat Clearview 8905 pump replacement


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Changing the belt on a bissell proheat 9200 - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


Hi,\012\012Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.\012\012 ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Bissell pro heat not spraying water - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Truction for bissell pro heat turbo 2x - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

How do I take apart my Bissell 7920 ProHeat Pro-Tech


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Bissell Pro Tech Pro Steam Cleaner - no suction @ pump


Take a look at the Service Center Repair Manual (courtesy of Bissell New Zealand):http://newzealand.bissell.com/images/IncludeContent/Service_Center_Help/Upright_Deep_Cleaner_Repair_Guide.pdfThere's a (basic) diagnostic routine for ... Vacuums

Bissell Proheat Pro-Tech #7901 will not spray any liquid to the carpet and red cross indicator is not turning,but comes out of attactments


Thanks to many others who have posted on similar problems -- water\015\012and/or solution sprays through the handheld tools, but not through the\015\012main machine.As others have suggested, I removed the water\015\012reservoir, which exp ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Need a user manual for a bissell proheat pro-tech 7920


Go to bissell.com type in the model number 7920 then go to user guide and you can print it. ... Bissell 9200 Upright Vacuum

Hi my proheat bissell 7901 stopped pumping water to the floor, but it pumps water from the hand hose. I read the manual and followed how to check belt and the flat belt on right side of shampooer is fine and I turned on and it turns and so do the brushes at the bottom of the machine. I was reading online and I guess there's two belts on this machine? where can I find the other belt to see if it needs replacing. I guess it's a ribbed belt? that is the water pump belt?


Just taken ours apart with the same problem... found it was caused by the 2 halves of the main casing coming apart in the area where the upright pedal release is. I found this to be due to the upper casing having broken in 2 places - the bottom of th ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Hi I own a Bissell Proheat Powersteamer pro-tech with a turbobrush. I have been using "bissell multi-allergen removal formula for carpets and upholstery." I ran out of that last night. Today I went to walmart looking for more. Everything I found said "2x Ultra Concentrated Bissell multi-allergen." I'm confused on where to add the cleaner. I have a water tank and a separate soap tank. The instructions on this new cleaner bottle say to add 4 capfuls for the formula tank and dilute with hot tap wat


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

Bissell proheat 7920 replacement pump


Part number is 2107181, it will cost around $30. Most local shops shoul have this part or can order it for you. You could try bissell.com. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Bissell heavy duty 9326 lost manual - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


Go here > http://uk.bissell.com/images/UserGuides/7920K_405.pdf ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Service store to buy parts for proheat 7920 - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My Bissel proheat carpet cleaner wont spray out of the bottom or the spray handle. I took of the scrub brushes and off and cleaned out the bottom of the machine including popping out the two spray heads to make sure they were not clogged. Put it back together. Still no spray! I also did the turn off, remove fluid containers, replace, turn on for one minute to prime the pump, and still so spray...does this mean my pump is not working?


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

The water pump on my bissell pro heat 2x does not seem to stay primed , the water does not flo continually when trigger is pressed. should i replace the pump or the fittings?


... Bissell 8920 ProHeat 2XTM Upright Vacuum

Bissell won't spray water - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be o ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Bissell rug cleaner does not spray - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


It could actually be something else entirely. Notice the person telling you to replace the belt is a company that sells vacuum belts. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

How do i use my bissell 7920 - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


The 7920 is a great little carpet shampooing vacuum. Look up manual information for detailed assembly and starting/breakdown procedures. Make certain that the carpet/floor has been vacuumed previous to cleaning with the shampooer! The small nozzle op ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Fit a pump to Bissell proheat 7920e


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Water Leakage We have a Bissell Proheat (Pro Tech). I don't think it is the 2X model. When releasing the water with the knob on the handle, water comes out the side of the housing at the lower part of the unit. Is their a seal that my be worn out or broken. Can you give us some ideas before we take it to an expensive repair man to fix


Check the water bottle. Ours has been doing the same but putting a bit of j cloth between what they call the o ring and the cap fixed it. Really you need a new bottle assembly ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0669 seconds