Having problems with your Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum ?

Shampoo not releasing

\015 When we first start we can smell the shampoo. Then we see the water go thru but shampoo level never drops\015

Answers :

I had this same problem. I fixed it by replacing the manifold (manual style) part number 2036806
Either the gasket is off of the bottle valve and sitting loose in the hole. If it is on, then replace the soap dispenser.
Repair Help & Product Troubleshooting for Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vax carpet shampooer wont release shampoo


If you unscrew a bit on the base that allows you to take off the brush, you will see a black plastic strip with very small holes in it. These are where your shampoo comes out of. Take a needle and re-pierce these holes and it should work again. I hav ... VAX Appliances Vacuums

Chassis hook broken to rod which controls release of liquid shampoo in Hoover steam cleaner. It is the back of the handle area that is snapped off, not the actual rod with "push on / release"


If it is part of the handle, it breaks inside alot, part number 39458006. #2 in the picture.\015\012 \015\012 ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Won't release shampoo


If your floor cleaner doesn't spray, chances are the heater unit is clogged. It is easy to fix if you have a few simple tools and are mechanically inclined.\015\012\015\012Steps to fix:\015\012\015\012- The heater unit is loca ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

No water or shampoo releasing


Take off the 2 spray nozzles and blow thru them, they may be clogged. You ay also try running a mix of water and vinegar thru it to help clean out the lines. May have a bad pump. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Shampoo not releasing


I had this same problem. I fixed it by replacing the manifold (manual style) part number 2036806 ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Wont release liquid or shampoo.


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=618960&thid=601973\015\012Won’t release liquid or shampoo.\015\012Posted by lilmrsmcd on May 16, 2008\015\012 ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Vax 6131 won't release the water for shampooing


... VAX Appliances V037 Stick Wet/Dry Vacuum

Wont release liquid or shampoo.


May be better to just replace it, \015\012\015\012\015\012\015\012\015\012CAP & INSERT ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Just got a bissell proheat clearview force cleaner, we press the trigger, no water sucking action or shampoo release going on .. what's wrong?


By the Floor Cleaning setting knob and Tools for PreHeat setting knob, there's a red x inside a clear circle cap. Is it spinning at all? If not...twist the cap off and remove the red x. Under the red x there is a tiny little filter. This might be plu ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Bissell carpet shampooer, how do I use it there was no manualI just need bASIC INSTRUCTIONS I'm guessing push button to release shampoo, go over the whole area, scrub as necessary, then it will **** up drity water. Question there is a rinse button Does that mean that I have to go over it again 3x?


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.B ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Bissell proheat shampooer releases the shampoo on the carpet but when I go to ****-up the dirty water into the plastic bucket to empty it there is no dirty water. Please advise or refer a repair place close to Pinellas Park, FL 33782. I have used this machine for about 2 years.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Model #73A5 is not release water or shampoo cleaner


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

NO WATER COMING OUT FOR SHAMPOOING /DUMPS WATER WHEN UPRIGHT


There is a belt inside that runs the pump to spray the water. I would take it in a have it replaced. Mine did the same exact thing. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Water and shampoo run out with the trigger in the off position


From your description, you have a problem with your one of the solenoids that may be stuck open. this would require a shop repair. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Bissell steam cleaner will not spray shampoo


My Bissell stops releasing shampoo when the handle is lacked upright, when there is no water in the tank (the most common cause of this issue), or when water is not flowing through the machine because the sprayers are clogged. \015\012\0 ... Bissell 7950 ProHeat Upright Wet/Dry Vacuum

Vax rapide 5000 not releasing water


... Vacuums

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not


Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Need a cheaper alternative shampoo for kirby vacuum system. Has to be an encapsulating shampoo. Kirby shampoo is too dear and only does one room per bottle. Need to know where to get some in australia as the postage from america is 3 times the price of the shampoo. thanks


Look up your local janitoral supply companies in the yellow pages. Encapsulation shampoo should be readily available in AU. \015\012\015\012Here is a list of websites to check out: \015\012\015\012 ... Kirby G4 Bagged Upright Vacuum

Bissell Quicksteamer Plus does not shut steam off when shampooing carpet


Here is a quick link to troubleshooting. http://www.bissell.com/FAQDetail.aspx?id=1093&cid-ccsocial\015\012 \015\0 ... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

Manual I realize it's probably something simple but how do I release the Cyclonic Chamber on top of the Dust Cup lid? I see the red 'open to clean' release button but how do I get down in there to push the release button? Thank you in advance for your help! Best, Christy


Manual > http://www.sharkclean.com/manual/NV22-NV22C-NV22P-NV22T-NV22Q_REV_1008.pdf ... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

I have a Bissell Proheat 2x cleaner which has worked perfectly on every occasion. Today I filled the machine as usual with water and formula and switched on, the motor ran, the lights were on and the brushes rotated but upon pressing the spray trigger no water or formula was released. I have cleaned the jets underneath and also followed instructions to release any airlock. It still wont release the water/formula. What else can I do? Thanks Charles


Please check the following with liquid in both tanks.\015\012 \015\012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\015\012- ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

On the DC07, the entire cyclone assembly must be removed to empty the dust, debris, etc. collected when vacuuming. On the top of the cyclone is a "trigger" that you lift with your finger to release the bottom catch, which allows a clear flap to open on the "clear bin," thus letting all the debris fall out. My problem is when you lift the finger trigger, it does not release the catch on the bottom. Since the catch won't release, I cannot remove the entire clear bin either from the cyclone.Any sug


Beofre you go to the extent of buying a replacement canister, you can remove the top and using a straightened coat hanger type thing open that bottom lid. Then maybe you can clean the rim and possibly add some silicone spry to loosen things up. Here' ... Dyson DC07 Bagless Upright Cyclonic Vacuum

DC17 wand release catch won't release. wand stuck


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Handle release has stuck down and want release handle


Http://canada.bissell.com/FAQs_and_Answers.aspx go to web and see all information, video, troubleshooting, questions, and fix it.God bless you ... Vacuums

I ran out of Kirby shampoo and need substitute shampoo


... Kirby Ultimate G Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0306 seconds