Having problems with your Bissell 8910 ProHeat Clear View Upright Vacuum ?

Carpet not getting moist

\015 We have a Bissell Proheat 2x Model 8920. We have only used it two times and now the water is not getting to the carpet. Seems like pump is not working. When you clean the carpet and pull the trigger handle nothing happens - no water comes out.\015

Answers :

Huh I had this issue. It was killing me only used it like six times then no water. I took this apart four times man. They told me it was the pump. I finally ripped it all the way down. It was the pump. But it was the black connector on the main motor. Which runs the pump it came loose. I pressed it back on problem solved. Make sure you crimp it a bit. so it does not vibrate off again. Hope this helps.

Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

Repair Help & Product Troubleshooting for Bissell 8910 ProHeat Clear View Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Carpet not getting moist

Huh I had this issue. It was killing me only used it like six times then no water. I took this apart four times man. They told me it was the pump. I finally ripped it all the way down. It was the pump. But it was the black connector on the main motor ... Bissell 8910 ProHeat Clear View Upright Vacuum

I can not get it to switch from floor to carpet. in other words i can not get the brush to spin plus i can not get the carpet riser to go down or up

You must release the handle and allow it to go down before you can use the carpet adjuster. This is to prevent you form burning a whole in carpet. You may also need to change the belt in your vacuum. Check belt and area for wear and other possible ob ... Dirt Devil M089900 Upright Vacuum

Suction problem I have a Hoover Widepath Fold Away, 12 amp motor vacuum cleaner and the problem I am having is every time I vacuum, the vacuum gets clogged up with carpet. I am probably only able to do one stroke then it gets clogged and I have to stop and unclog it or it spits it out on the carpet. This is very frustrating and I don't get much vacuuming done. Please can you help me. Thank you. Gwen email is [email protected]

Get rid of the carpet its shredding and falling apart.no sence in vacuuming old rotten carpet.or try using a vacuum without a brush roller and just suction ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

I have the Bissell 2x proheat. There is no water being sucked up from the bladder and the cleaning solution is not being sucked in either in order to get to the carpet. On water rinse the carpet gets wet but I'm not seeing any water going through the clear front piece. I live in Harvest Alabama. Where can I take it to get fixed if it needs it?

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Hoover Elite Rewind vacuum. Actually,this is my second one. However, after about 4 months of use, it emits a "sour" smell when I'm using it. I empty the cannister before each use and clean out the filter monthly. My house has mainly hardwood floors, so I typically only use it on area rugs and 2 small carpeted rooms. Is there any way that I can get rid of the smell? I've tried putting a dryer sheet in the cannister, but this gets stuck in the filter mechanism. Also, carpet fresh clogs th

Does it smell like an electrical burning odor? could very possibly be the motor going bad already. ive seen it happen. but if not try freshwave odor absorbing pearls. i carry it in my store and we do have shipping. Truly the only thing you should use ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

I have a Bissel 9300-C 0714 BC Carpet Shampooer. It was working great and all of a sudden it stopped working. It still sucks up dirty water but it does not spray water onto the carpet. I can get it to spray water through the smallest hand attatchment but not through the large hand held piece on the base of the machine. I really hope you can help me, I am a dog groomer and I really need my machine to work properly. I can get it to spray water out of the smallest hand attatchment but that's all t

The spray jet has become clogged from the soap.... just clean it out. same thing happened to my attachment. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Hello, I have a wonderful Dirt Devil vac for my carpets, model 140000, love how it works to get doggy hair off my carpet! But, I have a cute cannister model for my laminate floors and it uses the Q bags, but they are no where insight to get or order. Can you help me with this dilema?? Anna

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=821035\015\012Generic problem for all Vacuums\015\012Hello, I have a wonderful\015\012Posted by dutchtr ... Vacuums

Belts breaking/melting The original belt broke at almost 1 year so I replaced it. I changed the carpet setting to shag even though my carpet is very low pile to make it easier on the vacuum. I didn't get to use it but just a couple minutes and could already start smelling the new belt getting hot. I checked the roller and it is easy to spin. Not clogged with hair or dirt. Now the inside of the new belt has small pieces of rolled rubber instead of being smooth. The metal shaft that goes into the

... Dirt Devil M088905 Vision Bagless Upright Vacuum

I don't feel that the vac is close enough to the carpet anymore .. it's almost like I have to push the head down so it reached the carpet to roll the brush through it ... I've tried a friends vac and it shows nicely that you've just vacuumed the carpet .. heavy traffic areas are not getting pulled back up .. I have the short shag type carpet .. Thanks

Consider disassembling and cleaning your unit. Sometimes dirt and grit will build up, and when wiped away allow the moving parts to function better. Dysons are made to be broken down by the homeowner. A manual can be obtained here: http://www.manual ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

The hoover shampooer will not extract the water from carpet, is it because the carpet is so low ?? the carpet is cleaning fine there is VERY poor underlay and then wood under that, worried about the wood getting wet and not drying out HELP

Do you have suction at the front of the base,if you don't then look at the plastic cover on the base,you should be able to see through the plastic.the suction slot on the bottom front of the base is very narrow.i don't know if you have pets but most ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I own a Bissell Proheat Pet Model 8910. After just a few uses and changing both the brush and pump belts (trying to resolve problem) carpet doesn't get wet any longer. Carpet solution comes out normally but the water barly leaves the section of the tank I fill water into, resulting in carpet recieving to much solution and not enough water. Any advice?

... Bissell 8910 ProHeat Clear View Upright Vacuum

Cover knobs How do you remove the two plastic knobs on the cover for bare or carpet and carpet heighth to get the cover off?

You don't have to remove those knobs to get the cover off. Just 2 screws from the bottom, then on each side you will notice a slot from the bottom, use a screwdriver, insert in the slot, and pry out to release the catches and the top cover will come ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

SHARK CORDLESS SWEEPER 3 SPEED CONTROL FLOOR, CARPET, TURBO BATTERY EURO-PRO 8.4V - 1.3 Ah SB617U 3305 BELT Turned on and almost immediately turned off At least four years old - not used all the time - not used in six months Checked belt - seems O.K. Do I need a new battery, if so, where do I get one? Or should I just get a new sweeper? Cost?

... Vacuums

The carpet beater bar does not get close enough to the carpet - it works only if I press weight on the front of the bar area?

... Dyson DC14 Low Reach Bagless Upright Cyclonic Vacuum

My Bissell proheat 2x model 9200 is not dispensing cleaning solution. I hold the trigger and the carpet doesnt get wet at all. i poured water on the carpet and it sucks it up. the cleaning solution does mix with the water but it not being dispensed on the floor.

Hi, \015\012when last did you service the machine?\015\012\015\012i believe should service the machine.\015\012try to open the machine.\015\012\015\012when opening make sure you notice where the part you are remov ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My carpet cleaning brush does not turn on. The vacuum cleaner works fine but the the carpet cleaning attachment does not get any power so the light does not come on & the brush does not spin

... Kenmore 25512/ 25513 Progressive Canister Vacuum

LlllSteam vac ws working very well--shilfted to using hand vac on furniture--when I shiftead back to wanting to use the floor vacuum using the 6 brushes and the floor vac system, the r6 rotaty brushes will not turn or function. What do IO havae to do to get them to turn and function? The lever on the side ils set for carpet terrain. What do I do now to get brushed to turn and scrub as they should and did previously. James Yerges 1'630-232-2798 JMYerges&comcast.net

What is the exact model number of that unit. There are several with that name. The only things that it could be are the handle mechanism that activates the brushes or the indicator is not working nad the level that selects the brushes is not working. ... Hoover Vacuums

Hoover steam vac does not spary soution out well on carpet, carpet not getting wet

With the tank off, check to see if the rod in the handle is hitting the reservior asm,(this what the tank sits on). If it is, then the reservior asm. could be bad. If it isn't, then there is a problem inside the handle. Also make sure the filter a ... Hoover F5835900 Upright Steam Vacuum

My vacuum cleaner is making a loud squealing sound when I turn it on and the brush is turning. It gets louder while vacuuming the carpet. I tried to remove the bottom cover to see inside but, took out a bunch of screws and couldn't get the cover off.

... Kenmore Progressive Direct Drive 30912 Vacuum

Help i can get suction from the hose but when i stick it in the back of the carpet head i get no suction and the beater bar will not turn. can you help

... Miele S184 Powerhouse Bagged Upright Vacuum

How to clean Dirt Devil Easy Steamer Deluxe Carpet Shampooer to get dirt and grime out of the machine itself after cleaning carpet

You can download manual here:\015\012See page 9\015\012\015\012http://www.dir ... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

I need a manual for the bissell pro heat carpet cleaner #7091H. I used it but I can not get it to **** the dirty water out of the carpet. What am I doing wrong?

Try here:\015\012\015\012http://www.bissell.com/Product_Search.aspx?Criteria=pro+heat+carpet+cleaner\015\012 ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Windtunnel U6425-900 It seems the vacuum gets stuck in the carpet when the front dips and sucks up the carpet.

I think I may have the solution to all these same problems: If you buy a new front brush this might solve your problems, because the brushes have worn down and causing the vacuum to **** stronger because it is closer to the carpet. I hacve the same ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My Kirby Heritage II vacuum is not picking up dirt up out of the carpet like usual, and I have to keep setting it lower to pick anything up. I finally get it to such a low setting that it starts sucking the carpet up and makes a whirring noise, and starts smelling. Every time this happens, we find the belt has been burned. We are wondering if the brush roll inside with the brushes that pick up dirt are worn out and too short?

... Kirby Heritage II Vacuum

My carpet cleaner won't pick up the water after the carpet gets wet

Go to:\015\012http://Bissell9500TroubleShootingGuide ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0773 seconds