Having problems with your Bissell 8910 ProHeat Clear View Upright Vacuum ?

How to dissasemble proheat 8910 pet steam cleaner to get to the motor

\015 I'm trying to blow out the tubes in case they are clogged but can't bet to one of the hoses so I need to take it a part\015

Answers :

This link will give you a good idea what you need to do
http://www.youtube.com/watch?v=AjHeMnpTLlY
Repair Help & Product Troubleshooting for Bissell 8910 ProHeat Clear View Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to dissasemble proheat 8910 pet steam cleaner to get to the motor


This link will give you a good idea what you need to dohttp://www.youtube.com/watch?v=AjHeMnpTLlY ... Bissell 8910 ProHeat Clear View Upright Vacuum

Bissell proheat 2x 9200 series carpet cleaner. I need to remove the Brush Drive motor. However, this series has the gear end of the motor shaft poking out a hole on the left hand side. I removed the retaining washer and pin from the gear shaft. I need to get the gear off of the shaft in order to remove the motor. It's not budging. How do I remove the gear so I can pull the motor out of the unit? Thanks .


Chap, I wish someone had answered this. I'm having the exact same issue. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My carpet cleaner (bissell proheat plus) is not steaming, dispensing cleaner. Seems like there's a little thingy that should be spinning or turning..... When I work a small area of carpet, it just leaves behind dry blobs of carpet gunk like pet hair. I had to use a carpet sweeper to clean up. FYI - I filled the cleaning fluid container and after trying to clean the carpet, it did empty out but the carpet isn't wet. Any tips? The manual doesn't help.


You need to replace the pump belt. Here is the belt you need:Bissell ProHeat Belt ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My bissell proheat upright steam cleaner is spraying out through the attachments just fine, but will not spray to the floor when using upright. we've taken it apart to find that there is no water at all going through one of the hoses, but it appears the hose is connected behind the on/off and heat switches, we can't seem to figure out how to get in there to replace that hose....any suggestions on how to access this?? just curious how you would get in to replace the hose, we know it is the hose..


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Replace belts on bissell proheat 2x complete pet steam cleaner model 8960-2


... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

I used my new proheat 2x steam cleaner the first


You may have mislaid a piece when you took your Bissell apart to clean it after using it the first time.\015\012\015\012I experimented with mine to try and reproduce your issue. On the bottom of the water tank, there are two pieces that ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have the 8920 bissell proheat steam cleaner. i


You must have a suction problem. Try checking the lint filter, which is located in the top clear plastic section (the section that goes on top of the bladder section - it has the dial to switch from floor to tool use). There is a small plastic lint ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell ProHeat Carpet Steam Cleaner stopped spraying.


The problem was a clogged heating unit which is located in the lower handle. There are two clear hoses going up the inside of the left leg of the lower handle that go to the heater and to the in-line water switch all within the lower handle. I unplu ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My bissell 9400 pro heat steam cleaners sprayers are clogged again...how can I fix this with out taking it to a shop to get fixed?


The water sprayers on your Bissell are probably clogged. I had this problem this morning, myself, with my machine, about 15 months old. They get clogged up with mineral deposits. This is a *fairly* easy thing to fix yourself. Read all the w ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have an Electrolux LITE upright carpet cleaner - about 15 years old. Suddenly last night when using it, from the normal motor (whooshing) sound, the motor suddenly went very slow and with a slight grinding sound. The brushes are now just turning round very slowly and areobviously not picking up anything. Has the motor gone or is this repairable, or should I just get a new cleaner? I have tried to open the machine from the bottom to see if anything is obviously wrong, but it looks complicated a


... Electrolux Vacuums

Steam cleaner does not get it to steam pressure


Scaled up temp sensor, faulty thermostat ... Euro-Pro Shark SC-505 Handheld Steam Vacuum

My vac then steam 2in1stoped steaming motor runs gets hot but no steam


... Shark Steam Vacuum, 2-in-1 Vac-then-Steam

I have a Polti Vaporetto household steam cleaner that I bought 16 years ago. I haven't used it for about 10 years because the connection between the steam er and the attachments doesn't work properly and it is difficult to use. The shop where I bought it no longer sells them and can't get them fixed anymore. I'm about to ditch it, but thought I would have another go at using it. (It was very expensive). Now I can't get the safety cap off so I can't fill it or test it. Any ideas on what I can do


... Polti Eco Pro 3000 Canister Steam Vacuum

I have a steam cleaner and i can not get the black arm brush to keep one side up and when you trun on the steam cleaner the brush dose not spin when you start to clean the floor but it will spin when you have it siting up right


Sounds like you could have an elevator broken (part #2000010). You will have to take the top off to replace them or to check to see if one of them is broke. There is one on each side so when the handle is in the upright, they push againsy the brush ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bissell proheat pet 2x leaks water - Bissell Proheat 2X Select Pet Upright Deep Cleaner Green


... Bissell Proheat 2X Select Pet Upright Deep Cleaner Green

Brush will not spin on the steam cleaner - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

VAX STEAM CLEANER CANT GET IT OPEN - VAX Appliances V081 Canister Steam Cleaner


... VAX Appliances V081 Canister Steam Cleaner

Water wont come out fo the steam cleaner. - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Try adding a table spoon of salt to the water. ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Airlock in my carpet cleaner bissell proheat - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

8910 proheat steam cleaner belt


... Bissell 8910 ProHeat Clear View Upright Vacuum

Bissell 1699 ProHeat Clearview Steam Cleaner won't pick up


Usually if the water isn't being sucked up is either the filter in the lid of the tank is clogged, or the gasket that sits on top of the clear window nozzle and the tank is missing. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Help I have a yq 5888 steam cleaner which gets to temperature then I press for steam but it just makes a clicking sound and no steam help!


... Vacuums

Suction problem I have a Hoover Widepath Fold Away, 12 amp motor vacuum cleaner and the problem I am having is every time I vacuum, the vacuum gets clogged up with carpet. I am probably only able to do one stroke then it gets clogged and I have to stop and unclog it or it spits it out on the carpet. This is very frustrating and I don't get much vacuuming done. Please can you help me. Thank you. Gwen email is [email protected]


Get rid of the carpet its shredding and falling apart.no sence in vacuuming old rotten carpet.or try using a vacuum without a brush roller and just suction ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

The pump motor in my Bissel Proheat 2x Plus seems to have failed. It was seized so I sprayed WD-40 in it and let it sit for 3 days. Now I can turn it by hand, but when plugged into the unit it still doesn't spin. Here's a picture: http://bbay.dreamhost.com/bissel_proheat_2x_plus/P1070021.JPG I wanted to take the motor out and hook it into another power source to see if I can get it going but it has 3 wires. I'm used to only 2 (+ and -). How can I hook the motor up to another power source,


... Bissell Vacuums

Motor problem When i plug my steam vac in the motor sparks and smokes. It smells as if the motor is burning out. I've tried different outlets through out the house and get the same outcome, what can i do to solve this?


Nothing you can do im affraid its the motor armature so unless it can be stripped down then you will need to replace the motor i would get a price for the motor to decide if it is worth doin sorry. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0949 seconds