Having problems with your Bissell 9200 Upright Vacuum ?

Water flowing out bottom of steamcleaner

\015 Does anyone know why my Bissel Steamcleaner is not holding the water when the water tank is filled up . It is reletively knew only used maybe 4 or 5 times. The water just runs right through out bottom of steamcleaner. It is seated down firmly. \015\012If anyone knows would like some ideas thanks.\015

Answers :

It sounds like one of the internal tubes is loose or has a leak. You'll need to open up the black plate (the plate where you place the water tank on top of). Inside there, you'll be able to see all the tubes and hopefully track down which one is leaking or loose. Some of the tubes have clips to hold them in place. Perhaps one of those came loose.
Repair Help & Product Troubleshooting for Bissell 9200 Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water flowing out bottom of steamcleaner

It sounds like one of the internal tubes is loose or has a leak. You'll need to open up the black plate (the plate where you place the water tank on top of). Inside there, you'll be able to see all the tubes and hopefully track down which one is le ... Bissell 9200 Upright Vacuum

Hoover steamvac when I use it it leaks out of bottom. when it off an water in tank leaks out of bottom,when its off an I pull the triggar it flows big time out of bottom. tank doesnt leak when off sitting with water in it

Let me start out with an apology. I did not ask my question very well - and you did not answer it as I needed.\015\012If you wish, we MAY be able to communicate in your native language. We can do most indian languages, Turkish, Ukranian and s ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Model 8905...water or cleaner will not come out the bottom, only through the hand sprayer. Everything at the user level has been cleaned and the water and cleaning solutions are full. Nothing is going through the flow assembly. The selection switch is in the correct position

Hi, I checked through the troubleshooting for this model and came up with 2 possibilities. It could be that the tank is not seating well. If this is the case, trying putting a small amount of vegetable oil or vaseline on the seal. Please, ... Bissell 8910 ProHeat Clear View Upright Vacuum

Hoover F7431-900 my carpet shampooer/steam vac was working fine until the brushes at the bottom of it just miraculously stopped working. they wont spin at all. Is this a motor problem? perhaps a water flow problem? please write back if you can be of any help. thanks

If the screen is not dirty, and the flapper valve to the turbine inlet is open, then the problem is mostly a stuck turbine impeller. The turbine impeller on my F7431-900 has seized TWICE!! The shaft for the turbine is not made of stainless steel, t ... Hoover F7431-900 SteamVac Vacuum

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm

I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The Lower body of the Bissell QuickSteamer, water pours out from the body. Solution: I took apart the machine and there is a spring loaded valve with a rubber washer at the bottom. Think of the letter T upside down with the rubber washer on it. The washer stretches over the bottom and the spring creates a leakproof plug and won't allow water to pass till the button on the handle is pressed. This old washer came partially off and allowed water to leak. I purchased from the plumbing dept. a mi

... Bissell Vacuums

I was vacuuming today, and it was doing fine, then all of a sudden the motor kicked up a notch or two, then I heard the LOUDEST POP!!!...I turned it off, went and unplugged it, took off the top of the canister, then took the water pan to empty it, because I seen something on the bottom, as I was pouring the water out, I seen on the bottom, ALOT of, what looked like, small bands of metal...could you tell me what may have happened..??

It's possible the fan on the motor has disintgrated. If this is the case replace the motor. ... Rainbow E series Canister Wet/Dry Vacuum

Water leaks out the bottom of vac have new tank but the water still comes out the bottom while running like it is automatic no control

Hi Steve I have the same problem can you help if you were able to fix? ... Hoover F7220900 SteamVac V2 Upright Vacuum

I have a bissell quickwash 1950-e. I bought it Jan. 2006, and have only used it 8-10 times, I live in a very hard water area, so I though if I put some vinegar in with the cleaning solution it would get rid of any hard water deposits, unfortunatly the solution went lumpy in the tank and stoped spraying out water, I have opened it, hose clean, sprayer not blocked, x at bottom of water container when depresed water trickles out, component that opens the x when water container placed, also ran wate

Hard to say what is causing your problem, replacing the cap and insert on the water tank may help, part #2041111, even tho it may trickle out water when depressed, they can still be bad. The other thing would be the rod not relesing the water like i ... Vacuums

I have a Sunbeam Model Number 4065-000 and there is white particles comming out of the holes in the bottom. I think it is because we used tap water and there is a lot of deposits in the water. I read on the box that it was ok to use tap water and not distilled water. Is ther any way to clean the inside out to get the deposits cleaned out without affecting the possibility of doing something to the cloths that I will iron after cleaning the iron?

If the deposits are recent and still fairly soft, running a tank of vinegar through the machine should remove the deposits (obviously not using on any clothes, hold it over a sink). if the deposits are more stubborn, you can use a cleaning agent like ... Sunbeam Vacuums

My Eureka Atlantis Express is brand new - never used. I took it out of the box, read the manual, filled the soap and clean water tanks, put them in. I lifted the machine off the counter to take into the living room but all the water came running out of the bottom all over the kitchen floor. I can see where the little white plastic piece sticks up into the water release valve and lets the water out. How do you stop this? Can it be fixed?

... Eureka 2553A Atlantis Handheld Wet/Dry Vacuum

When I put the clean water bottle on water pours out of the bottom. A little water has always come out but it is now pouring out. I tested my water bottle which seems to be okay. What is the problem?

I have the same problem with mine. I did the chat thing at the Eureka site, but the info wasn't helpful. There is a little part that opens the bottle to release the water when the handle is squeezed. I don't know if that needs replaced or if there is ... Eureka 2576A Steam Vacuum

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl

There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

Hoover SteamVac Plus 1200 upright hot water extractor Water/carpet cleaner applying o.k. Suction on the "floor" does not work. Suction on the hand tool works somewhat, but water is not collecting in the bucket. There is suction coming from the floor but water is not going into the bucket. It does not appear to be clogged because I can feel with my hand that air is flowing from the floor. The water is not being sucked into the bucket.

... Hoover Vacuums

Saeco Odea Giro pumps the water but the internal spline or gear is not turning moving the ground coffee grinds to the point where the water can pump to the front exit lines so the water is pumped into the over flow resevoir. How do I replace the gear or check to make sure this is the problem. I want to replace this myself.. Also how do I get the unit apart it seems to be bullet proof. Is this a common problem.

It is a common problem if it is what I think it is. However your description is a little confusing. So the coffee does get ground up, but then has a hard time getting to the next stage of the process? Please clarify... And no water gets pumped th ... Vacuums

Envirosteamer 300 leaking water. Older yellow model. I put water in it and as soon as it heats up, all the water leaks out the bottom, and it barely gets warm! It worked fine before. Could it be seals need replacing or something? Thanks!!

... Eureka Enviro Steamer 370 Upright Vacuum

Just bought a used bissell steamcleaner 2x model 9300 needs fluid tank tried it out by filling water bladder does not dispense water when I pushed the tigger it does **** up water that I spilled on the carpet is it worth keeping after I buy the fluid tank

Click this link for spares for bissell 9300http://www.vacsite.com/en/bissell-parts-1/bissell-parts/9300-upright-deep-cleaner-se ... Hoover F5906-900 Upright Steam Vacuum

I have a signature 2000 ac window unit (10,000 BTU). Recently, water begin to slowly drip from the bottom right of the unit. I heard it hitting my floor. I took the front panel off and saw water build up. The unit is mounted in the window perfectly. How do I remove the water? I live on the 2nd story of my apartment building.

... Vacuums

November 2008 I bought a Simac Stirella 9000D steam generator iron. Recently its been leaking water out the bottom of the regenerator. It makes a noise when it is trying to get the steam to the iron and it works then but afterwards when the noise stops it stops steaming and I find a puddle of water underneath the regenerator. Also a little steam comes out of the water tank at the top. I understand this is happening because of scale in the base unit. Can I get something to get rid of the scale? -

... Vacuums

My Delonghi DSS50 steam floor cleaner water reservoir has a broken valve on the bottom where it fits into the steam unit. It leaks water rather than producing steam. I would like to find the valve and replace it or buy a new water reservoir with the valve in it. I cannot find the part I need. Can you help me?

... DeLonghi DSS50 Scopa Upright Steam Vacuum

My Bissell ProHeat 2x is pouring water out of the bottom anytime it's turned on. I had it in the shop for no water, took it back again for the same problem, took it back again because it had no suction, finally took it apart and found the problem with the suction and fixed it myself. Worked fine for a day and now it is constantly leaking water, if it's turned on, and is useless for anything except for making a mess.

Took the unit apart and discovered my heater had small pinholes in the metal and they had put in silicone, instead of a gasket, which didn't seal. So much for the place I took it to "saving" my heater for me. I repaired it myself by getting a few o ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Hi my proheat bissell 7901 stopped pumping water to the floor, but it pumps water from the hand hose. I read the manual and followed how to check belt and the flat belt on right side of shampooer is fine and I turned on and it turns and so do the brushes at the bottom of the machine. I was reading online and I guess there's two belts on this machine? where can I find the other belt to see if it needs replacing. I guess it's a ribbed belt? that is the water pump belt?

Just taken ours apart with the same problem... found it was caused by the 2 halves of the main casing coming apart in the area where the upright pedal release is. I found this to be due to the upper casing having broken in 2 places - the bottom of th ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bissell ProHeat 2X Select Upright Deep Cleaner not pumping water to floor. Water is not flowing out of the pouch area into the carpet. Water does not come out of the blater, I have checked the line & valve and they are clear how do I check the pump

Make sure you have soap in the soap container or the water will not pump. Sounds strange I know. Even if you have the soap mixture selector turned off, it seems that these machines won't pump clear water unless the soap resovior has fluid in it. D ... Vacuums

Electrolux ew910t after each washing small amount of water (about 1-2 glasses)appear under washing machine. I have checked both water filling and dump tubes - both are dry during whole washing cycle. Water commes from bottom corner of washer in drops. Do you have any idea what can be the problem? Many thanks, Pavel.

Are your loads spinning even if off balance it will cause the drum to spin off balance and water will come out of the bottom ... Vacuums

We have bissell pro heat and I have put new belts on and took off the top plastic cover I blew out the lines and I still can't get it to pump water or solution. The red little spinner flow indicater does'nt get water, if I pour water into it it runs out the front. I guess I don't know what else to do. The machine worked fine the last time we used it about 6 months ago. Any suggesttions?

Did you check and make sure the belt is still on right? They do come off from time to time.There are like 6 long screws holding the top cover to the bottom. The are real pain in the behind to put back together once you take them off. T ... Bissell Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0691 seconds