Having problems with your Bissell 9200 Upright Vacuum ?

9200 Bissell carpet cleaner, water will NOT dispense

\015 Water will not dispense form the cleaner. Everything else seems fine. I've only used it 4 times but haven't used it in the last year.\015

Answers :

My Bissell also STOPPED SPRAYING WATER.

I've owned a Bissell 9200 for a few months. I've used it twice, the last time most likely being around August. I attempted to use it this past weekend and it wouldn't spray. I searched all the help sites I could find and thought the solution was a clog in the heater, which many said was located in the arm. After I took the arm apart, to my surprise, THE HEATER IS NOT LOCATED IN THE ARM OF THE 9200 MODEL.

It's still under warranty, however am not located near a service center so I took it upon myself to try to fix it.

I'm just a single female who ends up trying to fix a lot of stuff herself so, I don't speak "technical instructions". But, here's what I did in the event that it may help someone else.

I unscrewed all the screws that I could on the base. I removed the cover over the motor. Doing so revealed the hoses attached to the soap dispenser. Located closer to the rollers were more hoses. On the same side as the foot lever, above the wheel is the where the HEATER is located.

Being that I was looking for a clog, I unclamped one hose at a time; inserted a safty pin into what the hose was attached to and wiggled it; re-clamped hose afterwards.

The only slight confusion may be with the screws. There are only two sizes. I used finger nail polish to mark where the small ones went.

I reassembled it, turned it on, and it actually started spraying again!!!!!!!!

So that this "blockage" won't occur again, I will take advice I've read about cleaning Bissell's hoses out after using it.
See, taking the thing apart was really nerve racking! Especially not knowing if it would even work after I put it back together.

GOOD LUCK WITH FIXING YOUR CLOG!....you'll probably need to sooner or later.
The water or soap line might be clogged, or something is broken. If it is just the upright part and not the handle, then its a solenoid, if its both then either the pump motor or the pump is not working.
\015\012
\015\012Here is a list of parts.
\015\012
\015\012http://www.nelsonappliance.com/bissell+proheat2x+parts.asp
\015\012
\015\012Hope this helps.
Repair Help & Product Troubleshooting for Bissell 9200 Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My bissell steam cleaner Model #9200P purchased 12/12/12 and only used once does not soak up the dirty water from the carpet. The bladder dispenses water and the solution is dispensed but the dirty w


Hi Barbara. I understand how frustrating no suction can be when you're trying to clean. Here's a quick link to troubleshooting steps to assist you: \015\012 ... Bissell 2X Proheat 9200 rug cleaner

I have a Bissell proheat 2x microban carpet cleaner. no water is dispensing . I have tried double cleaning everything, changing soulation(bissell steam clening) checking the filters checking for hot water, the brushes turn (belt?) What should I do?,


... Bissell Vacuums

My bissell carpet cleaner was dispensing and not sucking up the water, now it isn't even spitting out the water and cleaner


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell carpet cleaner not dispensing water - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell proheat 2x carpet cleaner won't dispense water or cleaner


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

9200 Bissell carpet cleaner, water will NOT dispense


My Bissell also STOPPED SPRAYING WATER.I've owned a Bissell 9200 for a few months. I've used it twice, the last time most likely being around August. I attempted to use it this past weekend and it wouldn't spray. I searched all the help ... Bissell 9200 Upright Vacuum

My Bissel 12 amp carpet cleaner will not dispense water when I push down on the button on the handle.I thoughly cleaned the machine it sucks water up but doesnot disperse


The water pusher needs to change. ... Vacuums

It won't dispense water or suction it up - Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum


I have a Proheat 2X and had the same problem. I don't know if this will work with your unit... but I tried the Water Rinse setting and found water came out and was suctioned properly, but on the Light Clean, Normal Clean, and Heavy Traffic settings, ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

My 2X Bissell carpet cleaner is not sucking the water back up after dispensing. I do not have any dirty water collected around the bladder. How do I fix that?


If the carpet cleaner is not sucking any water, nine times out of ten, the culprit is the lid on the lower recovery tank. The lid on the lower tank (or dirty water tank) needs to hinge at the front and snap down at the back in order to cr ... Bissell Vacuums

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

I have a Bissell Pro Heat 2X carpet cleaner, and it won't dispense the water and soap. It's only 2 years old, so certainly should still be working.


You need to check that the motor drive belt is OK and turning freely to drive the water pump - under the flap on the right side at the front as you look at the front of the Bissell. If this is OK have you filled the cleaning bottle with fluid e ... Vacuums

I have a Bissell 1622 PowerLifter Powerbrush carpet cleaner and it will not dispense water/cleaner and it will not suction. I have tried just running hot hot water through it and it still won't work.


... Bissell 1622 PowerLifter Upright Vacuum

Water wont dispense from bissell carpet cleaner


Ensure you have water in tank and solution (or water in solution tank). When you start the vacuum up, the pump starts to prime itself. If you have air in the system, it takes a little longer to prime. Allow the vacuum to run for 1 minute before attem ... Bissell 9200 Upright Vacuum

My bissell carpet cleaner runs, but no water is dispensed


... Bissell 1695 PowerSteamer Vacuum

Will not dispense water how do I trouble shoot bissell proheat steam carpet cleaner


Listen to see if you can hear pump run when pressing button, if the pump does run, than either you have a clogged nozzle or screen in water fill compartment. ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell ProHeat I really loved this carpet cleaner and it seemed to work extremely well.  However, now it won't dispense either the water or the cleaning solution.  What's up with that?


The first thing to check is the belt: if the rubber belt from the motor to the pump is stretched or missing, the pump will not operate. If the belt seems fine, either your pump has gone bad or you have a clog somewhere in the lines. \015\012 ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

My Bissell carpet cleaner model #1697-W will not dispense the cleaning solution and will not **** the water back up--also need to know how you get to the belt on the machine?


The drive belt for the pump is located under a cover on the front right side as you look for the front of the machine. Just lift it up and the belt will be obvious. If it is not sucking then make sure that the dirty water tank is empty and that ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

My bissell Proheat 2X Carpet cleaner will not dispense water


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bissell 9200 Upright Vacuum

Bissell ClearView powersteamer carpet cleaner does not seem to be dispensing water in the pre-treat mode


Pretreating (optional)\015\012Note: Pretreating is recommended to improve\015\012cleaning effectiveness for heavily soiled carpet in\015\012high traffic areas such as entryways and hallways.\015\012A. Spray the BISSELL ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not


Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Bissel carpet shampooer is not dispensing water


Probably , the water tank is not firmly pressed down,my does the same thing and i have to press it down harder. ... Bissell 9200 Upright Vacuum

Bissell ProHeat Plus carpet cleaner does not **** up water


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My Bissell proheat 2x model 9200 is not dispensing cleaning solution. I hold the trigger and the carpet doesnt get wet at all. i poured water on the carpet and it sucks it up. the cleaning solution does mix with the water but it not being dispensed on the floor.


Hi, \015\012when last did you service the machine?\015\012\015\012i believe should service the machine.\015\012try to open the machine.\015\012\015\012when opening make sure you notice where the part you are remov ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I HAVE A BISSELL PROHEAT CARPET CLEANER 7920 I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I HAVE A BISSELL PROHEAT CARPET CLEANER I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0948 seconds