Having problems with your Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum ?

Water will not **** up the dirty water

\015 The water will dispense, but it will not **** up the dirty water. It is still under its' warranty.\015\012\015\012Can you help?\015

Answers :

Check the lint filter. This is located in the top clear plastic section (the one with the dial to switch from floor to tool use) that sits on top of the bladder section. There is a red plastic filter, about 1 inch square, with a little door on it. Open the door and you will probably find it is blocked with hair, etc.. Remove the blockage and you should have suction once again.
Repair Help & Product Troubleshooting for Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

I used the Scooba 390 for the first time this weekend and it seems that the robot had problem sucking up the dirty water from the floor. When I emptied the dirty water tank, there was hardly any dirty water. Can you please let me know what can cause this problem?


... Roomba iRobot Scooba 390 Floor Washing Robot

My bissell pro heat does not **** up the dirty water anymore at least the dirty water tank does not fill with dirty water


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

The cleaner/water solution dispenses into the carpet, cleans it, pulls out the pet hair, but no dirty water goes into the dirty water reservoir! is all this dirty water going into my carpet?


The pet hair may be clogging the water return inlet I suugest you clean the bushes and inlet as well ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Bissell Steam Cleaner that is not sucking up the water when cleaning. I used a full container of water and when it was empty I emptied out the water, only to find very little dirty water in it. I noticed the window, as i used it, seemed like it wasnt sucking up the water. I took the plastic cover off to clean it (it didnt look very dirty in the first place), an i noticed that the grey plastic flap was on but not moving up or down. I thought there may be dirt in it that prevented it from


... Bissell Vacuums

We just took our dirt devil Platinum Force Carpet Shampooer Model CE7900 out of the box - first time used. It puts soap and water down fine, but we can't get any dirty water picked up. None of the trouble shooting suggestions in the manual apply. HELP! (We had only the power on when trying to pick up the dirty water.)


... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

DIRTY WATER THE FRESH WATER AND SOLUTION COMES OUTON TO THE CARPET, BUT NO DIRTY WATER IS COMING INTO THE CANISTER.


Remove the dirty water tank and see if the front nozzle is fitted correctly, also see if the filter is clean on the dirty water tank ... Bissell 1770 Quicksteamer II Upright Vacuum

Does the dirty water go into the bladder? I thought that the bladder was the holding tank for dirty water. Any water (very little) was collected and sat on top of bladder. Any advise is appreciated


... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My bissell steam cleaner Model #9200P purchased 12/12/12 and only used once does not soak up the dirty water from the carpet. The bladder dispenses water and the solution is dispensed but the dirty w


Hi Barbara. I understand how frustrating no suction can be when you're trying to clean. Here's a quick link to troubleshooting steps to assist you: \015\012 ... Bissell 2X Proheat 9200 rug cleaner

Hoover Max Extract 77 fills the dirty water tank with clean water from the clean tank.


... Hoover Vacuums

My Bissell proheat shampooer releases the shampoo on the carpet but when I go to ****-up the dirty water into the plastic bucket to empty it there is no dirty water. Please advise or refer a repair place close to Pinellas Park, FL 33782. I have used this machine for about 2 years.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

My steam vac was working...i thought the dirty water was full but it didn't make the hi pitched noise now that i think about it.....now it is not sucking up the dirty water.....i checked to make sure it was placed right and can't visually find anything wrong....help! i have pet stains to vacuum up...this is only about 1 year old.....


\015\012The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on th ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

There is no suction and the machine will not pick up any dirty water in the dirty water tank.


... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

The suction on my Hoover Spin Scrub 50 is suddenly not working. This is the 2nd or 3rd time I've used it and until now it has done a great job. But now it leaves my carpets soaking wet with no hope of drying and no dirty water is being suctioned into the dirty water tank. Help!


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

After shampooing carpet there is no dirty water in dirty water dispenser


Normally this is caused by the dirty water reserves lid is not seated properly. Take the lid off completely. Make sure there is no residue on the\015\012rubber part that seals the tank. When putting the lid back on, put the\015\012back hinges on firs ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How do i disengage the dirty water tank from the machine to empty dirty water.


There are two colored levers on the left and right side of the tank, simply pull them outward and then lift the tank off of the machine. \015\012 \015\012-OR-\015\012 \015\012There is a handle on the top of th ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Shampooer instructions..... I have a Kirby Generation 3 with the shampooer. it has been awhile since i have used it and i sort of remember how to attach it but i was wondering this vacuum has a tray and i assume it is for sucking up the dirty water but when i went to use it no dirty water was going into the tray.....help what did i do wrong......thank you for your time...............spanny


Try this link....http://reviews.ebay.com/KIRBY-CARPET-SHAMPOOER-INSTRUCTIONS-MANUAL-DIRECTI ... Kirby Generation 3 Bagged Upright Vacuum

It won't suction the dirty water up to the container. I have ck'd the lid for the dirty water several times. Any other suggestions?


Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Vax is dispensing from clean water tank but dirty water tank is not collecting anything


... Vacuums

The Hoover Steamvac Widepath will NOT pick up water. The dispenser with cleaner DOES have water. The TANK that would receive the dirty water is NOT full. All tanks are on properly and the machine will still not pick up the used water. I found a tear in the interior hose leading to the receiving tank and repaired throughly with electrical tape. Still will not pick up the water. Any suggestions?


Sounds like a clogged air path (no vacuum action) from the floor pick-up to the collection tank. Take the tanks off and deal with the vacuum problem alone. The collection tank should have a air exit vent--is it clear? Check the interior hose that you ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

My Bissell Pro Heat Select 2X does not pull up the dirt from the carpet into the water. The water just slowly disappears. The first time I used it the water got really dirty. The very next time I used it it worked differently and the water just disappeared until it was all gone. I've only used it a couple times and I don't see where it is working. Has anyone else had this problem?


Inside the plastic suction lid is a little red plastic filter that has to be cleaned out every time you use it because it sounds like your vaccum is not picking up all the hair and debri before you clean the carpet causing the water to be injected in ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

The hoover steam vac 5 brush agitator dispenses water and soap but does not show any return water to dirty water reservoir. The carpet seems damp but not soaked, still a bit troubling no waste water...what up ?


You do not have the needed vacuum on the dirty water intake. Possible causes are:\015\0121. No adapter sleeve in the back of the dirty water tank (the one that you remove to put the fabric hose adapter in)\015\0122. The dirty water top i ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Bissel 9300-C 0714 BC Carpet Shampooer. It was working great and all of a sudden it stopped working. It still sucks up dirty water but it does not spray water onto the carpet. I can get it to spray water through the smallest hand attatchment but not through the large hand held piece on the base of the machine. I really hope you can help me, I am a dog groomer and I really need my machine to work properly. I can get it to spray water out of the smallest hand attatchment but that's all t


The spray jet has become clogged from the soap.... just clean it out. same thing happened to my attachment. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl


There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

Water will not **** up the dirty water


Check the lint filter. This is located in the top clear plastic section (the one with the dial to switch from floor to tool use) that sits on top of the bladder section. There is a red plastic filter, about 1 inch square, with a little door on it. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0428 seconds