Having problems with your Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum ?

I have the 8920 bissell proheat steam cleaner. i

\015 I have the 9200 bissell proheat steam cleaner. i have it on heavy traffic and floor cleaner ... when i hold the handle in , it puts out the water but i can't get it to **** up the dirt..' the woman i got it from said when you fill the water up in the bottom it should have the clean water in the bag and when it sucks up the dirty water it will be on the outside of the bag... but when i was done the water was gone out of the bag and there was no dirty water on the outside of the bag\015

Answers :

You must have a suction problem. Try checking the lint filter, which is located in the top clear plastic section (the section that goes on top of the bladder section - it has the dial to switch from floor to tool use). There is a small plastic lint filter (about 1 inch square) with a little door on it (on my model it is red plastic) . Open the door, remove the hair or whatever is clogging it and hopefully your problem will be solved. And the lady you got it from is correct, the dirty water is stored in the area that surrounds the clean water bladder.
Repair Help & Product Troubleshooting for Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Airlock in my carpet cleaner bissell proheat - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell steam cleaner water leaking - Bissell 1699 ProHeat Clear View Upright Steam Vacuum


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Bissell proheat 2x not dispensing soap - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell proheat 2x 8930 won't spray - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

The bissell proheat will not suction - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Try the following suggestions to see if you can get your machine suctioning properly:\015\012\015\0121) Remove the Tank-in-Tank Assembly and place your hand over the motor intake valve. This valve is located next to the Floor Nozzle gaske ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Brush will not spin on the steam cleaner - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell carpet cleaner not dispensing water - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell proheat isn't spraying water out - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Hi,As the weather is getting warmer for many people their freezer and/or refrigerator do not work right because of a dirty condenser coil...there are also many other things that can go wrong. If you are hearing a clicking or buzzing ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Water wont come out fo the steam cleaner. - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Try adding a table spoon of salt to the water. ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell proheat no water - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Instruction manual for bissell proheat turbo - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have the 8920 bissell proheat steam cleaner. i


You must have a suction problem. Try checking the lint filter, which is located in the top clear plastic section (the section that goes on top of the bladder section - it has the dial to switch from floor to tool use). There is a small plastic lint ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell ProHeat Carpet Steam Cleaner stopped spraying.


The problem was a clogged heating unit which is located in the lower handle. There are two clear hoses going up the inside of the left leg of the lower handle that go to the heater and to the in-line water switch all within the lower handle. I unplu ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

ProHeat Turbo Deep Cleaner Upright Steam Vacuum: Hello, My Bissell Proheat is not spraying water, ...


Most likely the pump belt is worn and needs to be replaced. Here is the belt you need: Bissell Proheat Pump Belt ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Brushes won't turn on the bissell proheat 2X steam cleaner-I don't have the manual to see if there is a button I am not pushing to turn on the brushes. Also, do you put the clean water in the "bladder" in the tank? Sorry I am so dumb-this cleaner was given to me with no manual and I can't figure it out. There is a small tank on the bottom at the back of the machine, that says "formula here" and I don't know if that is where the cleaner goes or what that is for. The machine turns on just fine


... Bissell 8910 ProHeat Clear View Upright Vacuum

My bissell steamer smell burning - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Proheat turbo 2x operating instructions - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Changing trigger in the bissell - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Hi Scott. You may want to purchase a new handle for your BISSELL machine. Here's a link to the BISSELL website. \015\012http://www.bissell.com/parts/?cid=ccsocial ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My bissell will not **** up water - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Reset circuit breaker in bissell proheat 2X - Bissell 8930M Upright Steam Cleaner


... Bissell 8930M Upright Steam Cleaner

I have a Bissell proheat 2x microban carpet cleaner. no water is dispensing . I have tried double cleaning everything, changing soulation(bissell steam clening) checking the filters checking for hot water, the brushes turn (belt?) What should I do?,


... Bissell Vacuums

I have Bissell Model 1699-R Proheat carpet steam cleaner one of the tubings that connects into spray got mixed with some tubings during tubing replacment to the point that tubing that is conected into flow indicator cap does not turn at all to show if the chemical is sprying or not.i am looking mainly for tubing water/chemical diagram in order to verify the right connection.please help if you can bissell user. thanks


... Vacuums

How do i operate the steam cleaner machine - Bissell 1699 ProHeat Clear View Upright Steam Vacuum


Here is a link to the user guidehttp://www.dirtdevil.com/search.aspx?type=3 ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Cleaner solution doesn't mix with the water - Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum


Hi, this is very common problem the problem is that the problem is a simple one but solving it can take time. The problem you have got is that the detergent has turned to a gel over time and caused a blockage somewhere in the system now the problem y ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My carpet cleaner (bissell proheat plus) is not steaming, dispensing cleaner. Seems like there's a little thingy that should be spinning or turning..... When I work a small area of carpet, it just leaves behind dry blobs of carpet gunk like pet hair. I had to use a carpet sweeper to clean up. FYI - I filled the cleaning fluid container and after trying to clean the carpet, it did empty out but the carpet isn't wet. Any tips? The manual doesn't help.


You need to replace the pump belt. Here is the belt you need:Bissell ProHeat Belt ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0533 seconds