Having problems with your Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum ?

I can not get any water to spray from it. I have done what the operator manual says to do and still nothing.


Answers :

Hello,

Does water squirt out of the hose nozzle, if it does, then check the \015\012heater inside the handle asm. Make sure that where the tubes hook up to\015\012 it are not clogged. If water doesn't squirt, check for the seal at the\015\012 bottom of the tank, it needs to be on the tank, not in the hole, this \015\012is for the soap bottle, there is a seal on the bottom of it as well. \015\012The flow indictor cap is leaking air or maybe is too tight. If you had \015\012the top cover off, make sure that the tubes are routed right so as not \015\012to get pinched when the cover is put back on, the smart mix knob should \015\012be in the water setting and that the piston is on the bottom of the \015\012smart mix knob. Pump is bad. Try running a mix of vinegar and water to\015\012 see if that unclogs the lines. Is the top cover and the base tight \015\012together in the back, sometimes the top breaks loose and it will raise \015\012up and it can't spray, just re-fasten it down.\015\012\011\011

Take care.
Here's what a customer had to say about this problem in a review:
\015\012
\015\012Cons: I've had to replace a metal clamp on one of the sprayer nozzles. The unit wasn't spraying water anymore and I noticed that the hose clamp underneath the unit had rusted through. Not sure how that happened but it did so in about a year. Also, the price is a bit high, especially when you see standard-sized units selling for nearly $200 less, but considering how it performs in comparision to those units, it's only a temporary con.
\015\012
\015\012This makes sense, since a loose or rusted clamp would not allow the pressure necessary for the unit to operate. Another customer reported that they wanted too much to fix the problem, and so they bought another unit.
\015\012
\015\012I'm thinking that a hose clamp is loose or bad- that would make sense. You can probably replace one with a automobile type clamp yourself, and save a lot on repairs. Didn't find any other major complaints about the Bissell, so it sounds like it would be worth fixing yourself, but in the event that it comes to having to have it serviced, make sure you get an estimate first. In God I trust, but all other things I get more than one opinion, just to be on the safe side. Good luck, and hope this helps!
Repair Help & Product Troubleshooting for Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I can not get any water to spray from it. I have done what the operator manual says to do and still nothing.


Hello,Does water squirt out of the hose nozzle, if it does, then check the \015\012heater inside the handle asm. Make sure that where the tubes hook up to\015\012 it are not clogged. If water doesn't squirt, check for the seal at the\01 ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Neotec XJ-2000 ionic air purifier. On the bottom of the device, it says I should open the casing and take out and clean the dust filter every month. I haven't done it in years and no longer have the manual. How do I open it up to get the dust filter out?


... Vacuums

My dc17 squeals when the brushes are rotating. I have replaced the brushes twice and the belt three times. It has been back to the factory twice and they say they have done the same thing. The suction is still there but it is getting to the point I might have to wear ear plugs to vacuum any suggestions.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Operating manual i have lost my operating manual for my bissell Model #9500 proheat x2 cleaner. where can i get another manual? on one of the sites it shows that i can download the manual but for some reason i can not down load it. can you please help me with this problem?


BISSELL User's Guides can be downloaded at www.bissell.com\015\012On the front page under Customer Service click on User's Guides and enter the model number of your unit.\015\012User Guide will be displayed as a PDF file. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Operating manual I upgraded my vacuum to the new DC41 Ball, and gave my mother the other DC41 - bought in 2008 - and I don't have the operating manual for it anymore. She needs it. Where can I get the PDF manual? The link for the previous person requesting goes to the manual for the ball. Thanks!!!


... Vacuums

Just got a Polti Vaporetto 1020 from someone and cannot get it to work. One yellow light lit up and was on for a few minutes then turned off...and there is nothing...flip the switch on the handle, nothing...flipped other yellow button, nothing...any suggestions? or where I might get directions on how to use it? didn't come with manual. Many thanks. best, pat


... Polti Vaporetto 2400 Canister Steam Vacuum

Our kenmore progressive model #11634922 was working fine today. And then - it's not. Plugged in - nothing is working on it. We let it cool down (though it didn't seem hot). Still nothing - no light, no motor. Tried it in some other plugs that we know are functioning well - and still nothing. Any idea what might be wrong with it? It's six years old but doesn't get heavy use. Thanks so much ~ Susan Golden


Hi, it could be a number of things, cord may be bad as well as a problem with the motor. There also is a fuse that could have blown. If you go to sears.com, click on parts, put in your model number, when the page loads, click on the first link ... Kenmore Vacuums

We just purchased a Miele upright s7000. I vacuumed for 5 minutes (literally) and it completely shut down. Waited the suggested 30 minutes for cool down, but nothing happens. Waited another 30 minutes and still nothing. My husband checked for clogs according to the manual but still nothing at all. Is it just a dud?


... Miele Vacuums

Good morning, I have a Krups Variomix 3000 Premium, don't have a user manual, and haven't used it yet as I can't get the blender to lock into place. The user manual downloads that are on-line say the link has been removed. Please can you help me get the blender to work? Thank you, Marian


This is listed under vacuum cleaners as the repair catagory, is that what it is? ... Vacuums

Lost operation manual for my Roomba 2.1 in our recent move. Item was purchased in Aug 2007 at Costco. Where can I get a replacemnet operation manual through a free download? Thanks in advance for your assistance.


... Vacuums

Get manual lost operator manual an parts book where can i get one?


You can get the manual off the link belowhttp://hoover.com/support/manuals/ ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Bissell powersteamer i have a bissell powersteamer my aunt gave me, but do not know how to operate it to put the water and cleaning solution in it. please let me know how to operate. or how can i get the operation guide or manual


BISSELL User's Guides can be downloaded at www.bissell.com\012On the front page under Customer Service click on User's Guides and enter the model number of your unit.\012User Guide will be displayed as a PDF file. ... Bissell 8806 Powersteamer Upright Vacuum

How do I get the users manual for operating a


... Vacuums

I have model RGR126 Wireless Rain Monitor. All of a sudden, it has quit registering outside temperature. I changed the battery in the outside sensor and even pushed the reset button, but nothing I have done is fixing the problem. Please help! I really miss getting the temperature outside before I get dressed for work. Thanks.


... Vacuums

Chatter We have a Kirby Ultimate G. Since we purchased it it bounces across the floor and the level of the sweeper has nothing to do with it. To get it to stop, it has to be at the highest level. The place we bought it, has done nothing to help us. We tried a new beater brush, no help. If I have to use it at it's highest level to sweep my carpet, I might as well not waste my time. ANy suggestions?


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=11557&thid=576381\015\012Chatter\015\012Posted by CANRN on May 06, 2008\015\012We have a Kirby Ultimate G. Since we purcha ... Kirby Ultimate G Bagged Upright Vacuum

We recently bought a home with a 52" Hampton Bay Berlini Model 729 395 ceiling fan with a light that operates on a remote control. There is also a wall switch plate with two circular controls - one pushes and spins, the other turns with 4 clicks. We can not get the light or the fan to operate using either the switches or the remote. We have checked the circuit breaker. The manual that came with the unit - provided to us from the previous homeowner - really only describes how to install the uni


Nancy do you want to sell the Berlini fan if youstillo have it? ... Vacuums

Altrev, I have an ODC325 Black&Decker spacemaker coffeemaker on my boat and it stopped working this weekend although the hot plate still gets hot. I suspect it is the thermal switch as you described (I hear a click when I switch the machine on but nothing happens and the heating element does not kick in). I would be very happy to receive one or two of these 14 spare switches you mention so I can repair the unit. If still available I would appreciate hearing from you how we can do the transact


We don't sell parts individually on the site here.... was it some other solution for another person you saw about the switch? I don't believe there really is a part called a thermal switch... there is a thermal fuse but if the hotplate gets hot I wo ... Vacuums

HI MY WIFE HAS A NECCHI SUPERNOVA AUTOMATIC SE DGE 3344 MODEL, BUT WE DONT HAVE A MANUAL FOR OPERATION, COULD YOU PLEASE PROVIDE TO US SOME REFERENCES ABOUT WHERE WE CAN GET THIS MANUAL ??? THANKS IN ADVANCE


... Vacuums

I have a nearly 9 year old Electrolux Excellio Z5228 vacuum cleaner. It has recently started cutting out during operation. I cleaned the micro filter (between bag & motor) via brush & hitting against wall & seems / looks quite clean. I washed the gore filter (output from motor to clean the exhaust air) as per instructions, then let to dry. It was very clogged but now very clean. The vacuum clearner still cuts out often. Even after a long rest (say overnight) it still won't start, then ano


... Electrolux Vacuums

I have the yellow altima vac. for a while now I can not get the darn thing to pick up properly. Or should i say keep it up.. The vac does seem to be getting everything picked up but as soon as you turn it off, you have a mess under the vac.. I have checked for clogks and can't seem to find any.. I have removed the hose, Nothing there.. And yep have removed the yellow thing inside the trash cup.. Is there anything else you could suggest??


If it smells hot, then there's a strain on the motor no doubt about it. Check the suction channel behind the sole plate and remove all of the hoses to check for a clog. It could well be that there is a clog inside the machine after the dust channel f ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

I HAVE LOST MY INSTRUCTION BOOK FOR THE STEAM VAC SPIN AND SCRUB. I WANT TO USE THE STAIR ATTACHMENT, BUT I CAN'T FIGURE OUT HOW TO HOOK IT UP, OR OPERATE IT. I SEE WHERE THE PLUG IN PART GOES IN THE FRONT OF THE MACHINE, BUT I CAN'T GET THE OTHER PART TO SLIDE INTO PLACE ON THE FRONT OF THE RESOVIOR TANK AFTER I REMOVE THE FRONT PANEL, AS THE DIRECTIONS ON THE FRONT OF THE RECOVERY TANK SAY TO DO. THE FIT IS JUST TOO TIGHT. WHAT AM I DON'T WRONG- OR HOW COULD I GET A REPLACEMENT INSTRUCTION BOO


You can download a PDF version of the manual at the link below. I believe you can contact Hoover as well and they might mail you one.http://www.hoover.com/CustomerService/Manuals/Default.aspxGood Luck! ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I was vacuuming and noticed that the bag needed changing. the red light with the ! inside the triangle also came on. When the bag was changed, the vacuum would not restart. The red light came on. Tried the reset button but nothing happened. Tried unplugging and re-plugging in and nothing happened. Replaced all the filters and still it wouldh't start. So I brought it downstairs and tried one more time to get it to start. it worked! Is there something wrong with the vacuum cleaner? Was it overheat


It was overheated that is why it worked downstairs after cooling off. ... Miele S548 Bagged Canister Vacuum

Emerson Microwave Model #8126 W/S/D doesn't produce any heat. No matter how many times I run it or for how long, nothing gets remotely warm. Nothing in the manual about this. Any ideas or suggestions? Thanks! Lestat


... Vacuums

Rule 1800 Pool Cover Pump With Leaf Protector 110v not running. Pump had a partially severed electrical cord which I repaired. I have cleaned out the pump for debris (took off outer parts). I still get nothing when I plug it in. Impeller is somewhat hard to turn but I can find nothing impeding it. Thoughts?


Most likely the shaft bearing is seized up and not allowing the impeller to turn. Pull the bottom odd till you can spin the impeller by hand and use some penetrating oil around the shaft turn it by hand a few times and then with it still apart plugg ... Vacuums

Lost insruction manual for my 6.5 qt. Manttra Pressure Cooker (Code 16630. Batch No. 9608 01B). How does the petcock work? Should it be screwed all the way down? Part of the way? Or what? Also, can I get another copy of the manual? Prior to this cooker, I've only operated a Presto. Thanks for any assistance you can provide. Don't want any accidents!


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1067 seconds