Having problems with your Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum ?

The brushes will not rotate so no dirt is being sucked in


Answers :

Follow link below to www.bissell.com for belt change instructions.
\012http://www.bissell.com/how-to-videos/replace-brush-proheat-2x/
Repair Help & Product Troubleshooting for Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Why doesnt my rootcycle dyson **** up! belt ok, emptied regularly, the handle bit where it sucks is fine but not the rotating brush. it sucks up fluff but not light dirt and bits. changed white pipe underneath as it was split.


There is a removable cover on the bottom of some Dysons which is like a U-Bend. On occasion this is a likely spot for blockages. Also make sure that all of your filters have been cleaned. Locate your local Dyson Customer Service from ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

The brushes will not rotate so no dirt is being sucked in


Follow link below to www.bissell.com for belt change instructions.\012 ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Kirby Heritage II vacuum is not picking up dirt up out of the carpet like usual, and I have to keep setting it lower to pick anything up. I finally get it to such a low setting that it starts sucking the carpet up and makes a whirring noise, and starts smelling. Every time this happens, we find the belt has been burned. We are wondering if the brush roll inside with the brushes that pick up dirt are worn out and too short?


... Kirby Heritage II Vacuum

I have dirt devil envision M086710 less than a year and rotating brush does not work ? 'everything works except suction from rotating brush ..


... Dirt Devil CE5500 Floor Keeper Upright Wet/Dry Vacuum

Rotating bruch My vaccum brush will not turn. This happened after sucking up a cord that wrapped arou8nd the brush. I was able to pull the cord back out but now the brush will not turn. The vaccum does turn on an sounds like it is working with no soinning brush.


Take off the bottom cover where the roller brush is a few screws should be all it takes underneath cover should be roller and belt if belt is broke replace it lift up roller there is a slot for the belt to run in put other end should be the motor sid ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

The brush does not rotate - the brush that brushes the dirt up. The brush does not turn


Hello, see if you can turn the roler by hand ( MAKE SURE VACCUME is OFF), if you cant turn it try checking that there isnt something caught up on either side of the roler. Sometimes things can get caught on the spindel at either side and it winds up ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

The brushroll on my dirt devil (vax X3) was caught o the curtain, and now the reset button will not reset the brush. the power comes on for the brush, but the brush will not rotate. What can i di to fix this problem


I didn't find the reset button until I took all the screws out and then couldn't separate it. Good luck! ... VAX Appliances Vax X3 Bagless Upright Vacuum

The brush on our Dyson DC07 isn't moving - the band has not broken, is still attached but not moving the brush. the hoover is still sucking up dirt but not brushing anything up


Check beside the on/off switch. My model has a button beside the on/off switch that turns the brush on and off. It just has a picture on it no word. Hope this helps! ... Vacuums

My Dyson Animal has good suction and works fine for actually picking up dirt, but when I use the vacuum with the roller, I hear a grinding/rumbling noise. Its only when I use the vacuum with the brush rotating. It does not happen hen I shut the roller brush off. The belt is fine. I cannot figure out what is wrong as there are no clogs, debris, or foreign objects stuck in the brush or in the belt. The noise seems to be the only issue. The vacuum picks up fine. It just doesn't sound right a


Trace the path of the suction into the tank and see if there is anything loose or ingested.\015\012Also, remove the brush and clean as best you can. Perhaps there is something caught in it. Lubricate where it makes sense with some WD40. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

How to disassemble the brush to empty anything that might be stuck inside of the brush? The motor seems to be overheating, all belts have been checked, all airways are clear and the filter is clean. The vacuum is vibrating and releasing a burning smell, but still sucking up dirt. There is nothing stuck on the outside of the brush, but is there a way to check inside of it to see if that is where a clog is occuring?


If there's a burning smell and the belts are fine, the problem is going to be hot wires causing the insulation to melt, or the motor going bad. Discontinue use and have it checked at a repair shop. ... Bissell 6594 PowerForce Bagless Upright Vacuum

My vacuum blows air instead of sucking air. I have a dirt devil swivel guide. I got something stuck in the brush spinner, got it out...but now the vacuum doesnt suck stuff up anymore.


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=571660\015\012Generic problem for all Vacuums\015\012My vacuum blows air instead\015\012Posted by katweaver3 on ... Vacuums

Rotating brush is not rotating - Dirt Devil Featherlite Bagless Upright Vacuum


... Dirt Devil Featherlite Bagless Upright Vacuum

Doesn't suck I have a Hoover Empower. The motor runs, but it is not sucking anything up and the brushes aren't rotating.


Every vacuum needs to be occasionly taken apart and throughly cleaned. Usually when the brushes don't rotae it's a belt. But sometimes it's because junk gets wrapped around the roller. Things like string or thread or fiber that wounds around the r ... Kenmore 35912 / 35913 Progressive Upright Vacuum

I put in a ne Kirby Bag and it still is not sucking up the dirt. The brush is turning but the bag does not seem to be getting any sucking snce it is not expanding


See if this helps:\015\012http://www.goodvac.com/kb_results.asp?ID=13\015\012\015\012Good Luck,\015\012Rocky ... Kirby Ultimate G Bagged Upright Vacuum

I accidentally sucked up a string. The brushes stopped rotating and the suction was low. I took the frame off the brushes, and the rubber belt came out. How do I re-attach the belt/fix this problem? It is a Bissell power force turbo upright.


You'll need to replace the belt. \015\012On uprights with rubber belts, the belts need to be replaced every 3-6 months due to the fact that since the belts are rubber, they stretch, and once they stretch out they decrease the rotational speed o ... Bissell Vacuums

My hoover Savvy vacuum is no longer sucking up dirt- brush turns


... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Dirt Devil- Brush not rotating on its own. No suction.


Drive belt. take housing apart (draw a diagram so you can put it back together) take the broken belt to a vacuum repair shop to get the same one. mine cost 7$.\015\012\015\01215 minutes work. ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

I have a Hoover Linx cordless vacuum stick and it is not picking up anything. The motor works, the brush rolls but it spits out dirt instead of sucking it up.


... Hoover Platinum LiNX Cordless Stick Vacuum

Hi, The belt of our Dirt devil bagless vaccum broke and we got new belt and replaced it. Even after replacing the belt, the brush is not rotating. Any suggestions please ?


Did you check to see that the beater brush, the brush that the belt drives, is free of debris and moves freely?\015\012When they bind up they can cause the belt to break.\015\012Remove the beater brush just as you do when changing the belt and clean ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

I accidentally sucked up a strap from a bag, and when I pulled it out from the vacuum the vacuum now makes a loud noise only when the brush is rotating. Please help! Thank you!


Is it the vacuum making a loud noise, or the power head. I'd say the belt in the power held came apart and is flapping around inside. You may be able to replace, but I recommend taking it to the dealer for repairs. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My dyson dc07 animal bagless upright cyclonic is giving me problems with the bottom part where it sucks up the dirt the part that covers the brushes is not going on like it suppose to what am i doing wrong


CKECK Clutch Assy and belt\015\012bottom part where it sucks \015\0121: try us WD40... \015\0122: Replaced power switch Part No : 910971-01 ... Vacuums

PROBLEM I HAVE CLEANED PART OF MY CARPET, BUT WHAT SUCKS UP THE DIRT OR WATER AS CARPET WAS WET, I HAVE WATCHED A VIDEO, BUT DIDN'T GO FAR ENOUGH TO EXPLAIN THIS, AND WHAT DOES THE BELT DO THAT IS LOOSE FITTING IN BETWEEN EACH SIDE OF BRUSH. KINDEST REGARDS


A Shop vac is my usual solution to my crappy Kirby shampooer.. ... Kirby Heritage II Vacuum

Brush doesn't rotate - Dirt Devil MVP Swivel Glide M0820 Handheld Vacuum


Check if belt is broken.... ... Dirt Devil MVP Swivel Glide M0820 Handheld Vacuum

No Suction Something made a pop and my dirt devil featherlite is not sucking anything up. The roller brush is still spinning and the belt is good. What's the possible problem?


It is probably the dirt fan. u may have to get it serviced ... Dirt Devil Featherlite Bagged VacuumVacuum

Brush spins, motor heats up, container doesn't spin anymore, not sure if it is "sucking up" anything ..had it for less than a year. Why won't it vacuum? dirt devil 12 amp HEPA filter vacuum


Probably clogged, or filters are very dirty ... Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0665 seconds