Having problems with your Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum ?

Not spraying The machin e is new and i use it a few days ago, we cleaned it inside and out, it is not spraying any cleaner or water. Can you help me?


Answers :

• tanks are not sealed into receivers
• faulty auto load receiver
• pinched/clogged line
• defective component allowing air into system
• pump not mounted so it can move freely
• defective bridge rectifier
• clogged heater
• defective pump
• defective circuit board
\015\012another is the spray nozzles are clogged.
Repair Help & Product Troubleshooting for Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My bissell carpet cleaner does not spray water even though the water compartment is full and the filter has been cleaned out. Any idea what I should try before having to take it 2 hours out of town for servicing? Thanks for any help


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Not spraying The machin e is new and i use it a few days ago, we cleaned it inside and out, it is not spraying any cleaner or water. Can you help me?


• tanks are not sealed into receivers• faulty auto load receiver• pinched/clogged line• defective component allowing air into system• pump not mounted so it can move freely• defective bridge ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Bex Bissell Proheat carpet cleaner refuses to spray water from the lower jets and it is intermittant from the wand. I have cleaned the jets to no avail. Any help would be appreciated. Thanks


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9200 Upright Vacuum

I have a powersteamer and it does not spray water when I squeeze the trigger. The clean water tank is full, the cleaning solution is full and this is the same problem I had with my last Bissell steam cleaner, which I assumed was just that I had it for a few years, but this cleaner is only over a year old.


Every line has an O Ring at each end. inspect each one by removing the O Ring for nicks and cracks. Lubricate the with Vaseline and reinstall if ok so they will hold the prime to pump and vacuum up Your leaking O rings will draw air causing your p ... Bissell Vacuums

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

Bissell will spray water when set to water rinse, but as soon as it is set to light, normal, or heavy cleaning, there is no spray. I have tried priming but to no avail. I put plain water in the solution tank to test without ay success. It is like it loses it's prime whenever you try to use a solution mix. Once you set it back to water rinse only and go through the priming steps, it is OK. Any help would be appreciated. Thanks.


Please check the following with liquid in both tanks.\012 \012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\012- Check for ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Bissel proheat 7901 carpet cleaner and it is not sucking the water up. Normally when I clean the water gets sucked back up and I have to empty the dirty tank. Now no water is in the tank when I am done cleaning. Please help I cannot afford to take it to the shop.


I'm not sure if this will help but I had the same problem and was about ready to pull my hair out. I ended up taking the fill tank off and if you look inside where the red overflow flap is you will find a small screened opening. I found that mine w ... Vacuums

My hover extract deep cleaner won't spray water or cleaning solution


... Hoover F7431-900 SteamVac Vacuum

My bissel has a upolsty cleaner on it, I used it to clean my couch then shut it off to emty then went to clean the other couch now it wont spray cleaner or ****? can anyone help me?


Things to look at...\015\012\015\012Tank is properly seated (remove and reinstall)\015\012Tools are selected (not floors)\015\012ensure the handle is in the full upri ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I HAVE A BISSELL PROHEAT CARPET CLEANER 7920 I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My bissell proheat 2x 8920 series will not dispense the cleaning fluid from the little tank. The water sprays out fine and everything else works, it just wont spray out the cleaning solution. Please help!


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I HAVE A BISSELL PROHEAT CARPET CLEANER I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Hoover F6212-900 My dear wife thought our 2 year old steam cleaner was a vaccum cleaner and used it with no fluid, I used it yesterday, it didn,t seem to clean the carpet and no water went into the dirty water tank it stayed dry. motor sounded ok Am I in big trouble Thanks for any help you can offer P.S. I still love her Alan from Canada


Press the handle release kick-button with your foot, extend the handle all of the way back, and take a look at the gap between the base of the unit and the handle/reseviour assembly. You should see several black hoses attached to the base and running ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Water spray The water from the bottom of my carpet cleaner is not spraying. It comes out in lines and this doesn't clean the carpet evenly.


Are the brushes turning while you are shampooing? If not then this could be the problem. The turbine is what turns the brushes, it may have gone bad. ... Hoover V1 SteamVac SpinScrub Vacuum

I have a Bissell powersteamer powerbrush that sprays for only a few seconds then stops. If I wait 20 seconds or so it will spray again for another 1 or 2 seconds. I have only used Bissell cleaning products in it and clean it every time after use. The hot water tank and cleaner tank are full.


... Bissell Vacuums

My Bissell ProHeat Pro-Clean upright cleaner won't spray either water or solution onto the floor, however it does spray when using the attachments on the hose. The belt is fine, I've actually tried all of the troubleshooting steps indicated in the User Manual. I'm not even certain where it is supposed to be spraying out from! Any ideas where/what to check for?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My hoover max extract carpet cleaner won't release the cleaning solution. It's just spraying out the clean water and not mixing with the cleaning solution.


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

I have a bissell quicksteamer powerbrush home steam cleaner and it will not **** up water anymore. All the filters are clean, it sprays water fine, but no water goes into the waste container?


... Vacuums

The carpet cleaner does not spray cleaner, nor vaccum up excess water. It's been taken apart, cleaned, reassembled, refilled, twice. Have double checked seating of tank, placement of filled cleaner bottle and yes - it's plugged in.


Hi\015\012\015\012 \015\012\015\012The issue may be due to flow system; to troubleshoot the\015\012system follow the instructions--\015\012\015\0121. Remove Smart Mix piston from the main housing and place Smart\015\012M ... Bissell 1698-1 PowerSteamer ProHeat Plus Upright Vacuum

My Bissell Proheat 2X carpet cleaner won't spray water when the "Hose" mode is selected. It sprays for about 5 seconds then stops. If you then wait 10 seconds it will spray again, but only for 5 seconds. Can you help?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

It will empty the cleaner but will not spray water filter is clean spray heads were taken off & i could blow threw them is it a case of no prime in pump if so should i fill pump i had this thing all apart and i now know evry inch of this matchine when i pull the triger it sometimes will spray for a sec.but thats it i also took the switch out and air goes threw when i press the switch if it is the prime in the pump how can i fill the pump . what hose on the pump will prime i thankx for your advic


The problem is most likely that your pump belt is worn, stretched or broken. Here you can get the belts you need and view the manual:htt ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

My bissell proheat carpet cleaner wont dump water or solution. It will however **** up water and solution if dumped on the carpet. Help I cant clean up doggie pee and it smells in this heat!


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

Originally worked fine, but after storing it for about 8 months-a year, it still powers on and sucks but it will not squirt the water and soap to wet it, or even spray just the water to rinse. Help!!! I'm sure there has to be some filters or something that is plugged up and needs cleaned or replaced.


Hi,First, check to see that you put the water in the bladder rather than in the clear tank. Second, did you fill the solution bottle? The Bissell shampooer will not spray water if either of these is empty.Also, if the seal on ... Bissell 9200 Upright Vacuum

I have a Bissell Proheat 2x cleaner which has worked perfectly on every occasion. Today I filled the machine as usual with water and formula and switched on, the motor ran, the lights were on and the brushes rotated but upon pressing the spray trigger no water or formula was released. I have cleaned the jets underneath and also followed instructions to release any airlock. It still wont release the water/formula. What else can I do? Thanks Charles


Please check the following with liquid in both tanks.\015\012 \015\012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\015\012- ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Bissell proheat clearview 12 amp 5 cleaning rows of dirtlifter powerbrush. It won't shoot the cleaner to the brushes. I cleaned the filter, checked the belt, water is full, and soap dispenser is full. Still no soap going to rug. Can you help? Thanks


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0767 seconds