Having problems with your Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum ?

Help the water and shampoo will not come out of the shampooer what could be the problem


Answers :

• tanks are not sealed into receivers
• faulty auto load receiver
• pinched/clogged line
• defective component allowing air into system
• pump not mounted so it can move freely
• defective bridge rectifier
• clogged heater
• defective pump
• defective circuit board
* spray nozzles are clogged
Repair Help & Product Troubleshooting for Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Help the water and shampoo will not come out of the shampooer what could be the problem


• tanks are not sealed into receivers• faulty auto load receiver• pinched/clogged line• defective component allowing air into system• pump not mounted so it can move freely• defective bridge ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Kirby Sentria Shampooer is not foaming the width of the tray. It is only coming out on one line and is saturating the carpet with water in that area. What is the problem? What do I do? We just bought this 5 mos. ago. Please help.


Your shampooer is not broken. (sorry Fanny)\015\012\015\012You are missing a wee screen that fits on the hole where the little hose plugs into the tank. Check inside the hose end or down inside your shampooer box. Here's a link to my onli ... Kirby Ultimate G Bagged Upright Vacuum

No Water My Bissell rug shampooer does not eject water or saop whan I pull the saop trigger on the handle. I checked both filters and they are clean. Then, I removed the container that sucks up the water and pulled the saop trigger, water barely came out of the tubes. I tried to clean the rug in our family room and the rug was not wet when I finished, no water coming out to clean the rug. HELP HELP HELP!!! I live in Colorado is there a Bissell repair shop near Denver, HELP!!! Thanks Dominick ema


Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be o ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Hello, could you help please. I have a Bissel ProHeat 9400-M. The water remains in the bladder when the machine is on, in other words nothing happens and I cannot clean with it. Inside the tank the small flap is in the open position. I have always used your products although I did run the Bissell over an area that had been cleaned with another product. Could that have caused the problem by blocking it somewhere? I have cleaned everything and cannot see a blockage. Thank you for your help.


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Shampooer I have a rainbow e series and my shampooer is not working. The tubes do not seem to be clogged and it sounds like it is trying to work but we cant get the water to come out. We pull the trigger and nothing no soap, no water, nothing. Can anyone help?


Aqua mates have an o-ringed valve assembly that go bad regularly reccoment having it replaced by local vac shop ... Rainbow E series Canister Wet/Dry Vacuum

No water or shampoo coming out of bissell proheat 2X healthy home shampooer


... Bissell 66Q4 PROHEAT 2X HEALTHY HOME

No water coming out...shampoo does though...even when I have it on rinse!! ERRRRRRR!!! Please help...I called to have it repaired...and well I'm broke!!! SO HELP ME PLEASE B4 I THROW IT OUT THE WINDOW!!!!


I know three people including me who have had the same problem. Mine is currently in pieces. My girlfriend replaced her belts and hers works now. I replaced my belts to no avail. Hand tool works, so it;s not the pump. Have to get it back togethe ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Kenmore carpet shampooer will not **** up any water at all. What could the problem be? I have a world's largest tank capacity shampooer.


... Kenmore 22822 Canister Vacuum

Cleaning solution does not come out when I pull trigger.Also no water is coming out.What could the problem be?


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 8910 ProHeat Clear View Upright Vacuum

Low suction Have a Powr-Flite PF 18, suction is good at motor, but low at where hose comes out of top of vacuum. Could new lid seals help the problem? Where can I get new seals for this model. Also my zip is 98801 and my shop is not listed, could you add it please? Sew Creative 1139 N. Princeton Wenatchee, Wa 98801 509-663-5516 Thanks, Lauren-Sew Creative


Replacing the motor cover solved the problem, it must have been warped and was letting suction out thru it. ... Vacuums

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not


Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Carpet shampooer Why cant i shampoo with my Kirby. I get lots of water over the floor but it doesn't seem to suck it up. Any help would be gratefully received . Thanks.


Hello!\015\012\015\012It sound to me like your shampooer is missing the little round suds screen that goes over the hole where the hose plugs in to the tank. Look inside the hose and see if it's in there. Sometimes it gets turned sideways a ... Kirby Heritage II Vacuum

I have bissell powersteamer powerbrush. I have been using it a over 1 year. Sometimes though duirng use, the water from the container doesn't come out much, resulting in a less effective cleaning. Could you help? Thanks


... Bissell Vacuums

Shampoo-er This seems to be a common problem, the shampooer is putting out alot of water and hardly any suds. I read through the posts about the little filter that sometimes gets out of place and I think I found it in the box - is it about 1" diameter hard plastic ring around very fine mesh? If so where exactly does it go? Some posts say in the hose, and others say in the opening of the tank. Or does it go in the place where the hose attaches to the tray? I also found a round sponge in the box o


It goes on the small hole on the tank where the hose attaches to it. The sponge goes in the hole directly under the on/off valve. Here is a link to my online shampooer instructions.\015\012 \015\012 ... Kirby Ultimate G Bagged Upright Vacuum

I have a dirt devil platinum force carpet shampooer,bought it at the beginning of august this year. The sprayer seems to have stopped spraying from the main tank. The shampoo tank is letting the soap out but the main tank isnt emptying at all Can you help me fix this problem?


... Dirt Devil M091400 Platinum Force Wet/Dry Vacuum

Hello. first id like to thank you very much for helping me. There is no problem really. Id just like to know if i can use other soap or product to clean the rug besides the kirby evaporated dry foam.. Also how could i **** up as much water as i can?


I would only use the brand intended to be used in this machine. Home Solutions Turbo Shampoo by Aerus Electrolux. This machine doesn't **** up water, and if used according to the directions, there really shouldn't be much water on the carpet. ... Electrolux Floor Pro Vacuum

A friend used my Bissell Proheat Clearview shampooer, and didn't wash out the shamppoo bottle nor turn the dial to water only after using. The flow assembly on the bottle was destroyed. I bought a new bottle but still can't get the shampoo to flow. Hope you can help.


Pls model no ... Bissell Vacuums

No water or shampoo coming out of aquamate II shampooer


... Rainbow E series Canister Wet/Dry Vacuum

The carpet cleaner comes on and the heat source is working in it, but the machine is not dispensing the water and cleaning solution. It does have consistant suction. What could cause this type of problem?


Most likely a bad belt you might think it looks good but i'd say thats your prob after you replace it you should be fine if not we can go deeper ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

I just bought a hoover floor mate for hard floors. The problem is the water with cleaner is not coming down to the brissles at all. Help please. It is brand new. any ideas???


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=40471&thid=603805\015\012I just bought a Hoover\015\012Posted by serdmann4 on May 17, 2008\015\012I just bought a ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

I have an older model Bissell rug shampoo machine, model # 1631. I have several bottles of Bissell 5 One carpet formula to use in this machine, however I have lost the measuring bottle that tells me the amount of soap solution to use per 64 oz. bottle of water. I sure would appreciate if you could help me.


I have a older mod. Bissell carpet machine plus mod. 1630-5 and need a floor nozzle part num.013-6194 and grip tube w/button part num.014-4181 and trigger part num.010-9406 and tube ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

NO WATER COMING OUT FOR SHAMPOOING /DUMPS WATER WHEN UPRIGHT


There is a belt inside that runs the pump to spray the water. I would take it in a have it replaced. Mine did the same exact thing. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

We have the water hooked up at the back of machine. there is a spout for the water to come in and fill the ice tray.but is does not. If we turn the water on it fills up the space under the ice basket. I keep getting red light and then the two smal llight one ice and one water come on. We can hear the motor trying to fill the ice try and then lights come on. Please help me this so I can use this product. It did not come with a manual.


The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it will freeze blocking the fill ... Vacuums

My Kirby shampooer - G4 - hardly used any water from the tank and no suds at all. Pet hair did blow out of the small slotted holes in the tray as I moved the shampooer back and forth, but the carpet was basically dry. I did vacuum before shampooing, so the brush part seemed to work great during shampooing, but no water! The small screen was stuck in the crook of the hose that attached to the tank so I did get that out and put it on the small hole on the tank, but it didn't make any difference. I


Few things:Make sure the sponge and the valve under the sponge (water tank) is clean.Make sure you follow the instructions (f you do not have the manual you can find one ... Kirby Ultimate G Bagged Upright Vacuum

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!


Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0905 seconds