Having problems with your Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum ?

My shampoor will not pick up the dirty water?


Answers :

If your ProHeat 2X machine is not suctioning properly, first check the motor duct gasket. To check this, first remove the tank and place your hand over the rubber square opening. If there is no suction there, please take your machine to a BISSELL Authorized Service Center for inspection. If your machine does have suction at the duct, continue to check the following:\015\012
\015\012 - Ensure the Ready Tools Dial is set to the appropriate setting (Floor Cleaning or Hose Attachments).
\015\012- Remove the tank from the machine and ensure the tank lid is attached properly. The front window must first hook onto the lip of the bottom of the tank and then drape over the tank. Latch the bottom tank to the top tank lid. THIS LID CANNOT BE ATTACHED PROPERLY IF THE TANK IS NOT REMOVED FROM THE MACHINE.
\015\012- Make sure the Water Tank is not full on the outside of the bladder. If it is, empty the tank.
\015\012 - Ensure the hose is firmly attached to the back of the machine. If not, re-insert as necessary by twisting into place.
\015\012 - The machine must be in an upright, locked position and set to the Hose Attachment setting. If the handle is slightly tilted back while using, it will create a small gap at the suction inlet (where handle meets gasket, above the Bottom Tank) which will cause little or no suction.
\015\012- Check the red Tank Lint Screen for debris. If the Lint Screen is dirty, the unit will have poor suction. Clean the Lint Screen if necessary.
\015\012- If the float flap door in the tank lid is activating prematurely when you turn the machine on, this flap door should be replaced.
\015\012- Check the Tank Lid and Tank for damage.
\015\012
\015\012 If you continue to experience low suction, please take your machine to a BISSELL Authorized Service Center. The warranty on your machine is one year. To locate your nearest BISSELL Authorized Service Center, click here.
\015\012To contact Consumer Services by phone, please call us at 1-800-237-7691, Monday - Friday 8 a.m. to 10 p.m., or Saturday 9 a.m. to 8 p.m., ET. A representative will assist you.
Repair Help & Product Troubleshooting for Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My shampoor will not pick up the dirty water?


If your ProHeat 2X machine is not suctioning properly, first check the motor duct gasket. To check this, first remove the tank and place your hand over the rubber square opening. If there is no suction there, please take your machine to a BISSELL Aut ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

We just took our dirt devil Platinum Force Carpet Shampooer Model CE7900 out of the box - first time used. It puts soap and water down fine, but we can't get any dirty water picked up. None of the trouble shooting suggestions in the manual apply. HELP! (We had only the power on when trying to pick up the dirty water.)


... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

The Hoover Steamvac Widepath will NOT pick up water. The dispenser with cleaner DOES have water. The TANK that would receive the dirty water is NOT full. All tanks are on properly and the machine will still not pick up the used water. I found a tear in the interior hose leading to the receiving tank and repaired throughly with electrical tape. Still will not pick up the water. Any suggestions?


Sounds like a clogged air path (no vacuum action) from the floor pick-up to the collection tank. Take the tanks off and deal with the vacuum problem alone. The collection tank should have a air exit vent--is it clear? Check the interior hose that you ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

There is no suction and the machine will not pick up any dirty water in the dirty water tank.


... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

I do not have my users manual and have never vacuumed wet with this vacuum. How do I change it from a dry to wet vacuum. Can't find my manual and I need to use the shop vac for water in basement, do I have to change the filter or what lost my user manual never used it to pick up water. need to know how to puit it in wet mode i want to clean the dirty water out of my pool.


\015\012Vacuuming Liquids\015\0121. When picking up small amounts of liquid\015\012the filter may be left in place.\015\0122. When picking up large amounts of liquid\015\012we recommend that the filter be\015\012r ... Craftsman 17765 Canister Wet/Dry Vacuum

Scooba model 6050. The robot picks up dirt as found in the screen, but does not vacuum up any water. The dirty water tank remains empty after using all of the clean water. Help. Thanks.


The dirty water lines may be clogged. I don't exactly know how to un-clog it, but I would check to see if there is any way to flush them out. or talk to the company's customer service people. They would know what to do without voiding the warrenty. ... iRobot 5800 Scooba Vacuum

Does not pick up dirty water


... Bissell 8920 ProHeat 2XTM Upright Vacuum

Dear Sir: I just purchased a Bissell Rug Shampooer at a garage sale. The only thing I find for a model is on the back and it says Model 1695 there. Nothing on front. It is Navy blue and has a grey tank on it with a smaller one inserted at bottom of the large tank. It has two switches on the back of it and the trigger switch at the handle. The cleaner works, BUT, it does not extract any water back into the tank that is to pick up the dirty water. Could you suggest what I may look at t


... Bissell Vacuums

My carpet cleaner won't pick up the dirty water... it works fine to spray out, but not to pick up


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My machine wont pick up the dirty water. If I take the cover off the recovery tank there is a lot of suction but it wont **** up the water. my carpet is soaked. What can I do


At power head clean out area before power head also look for small hose and clean out and look at rollers,i hope this works if you have directions still they should be able to help you out some more.thanks ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Not getting sucktion to the hose. not picking up dirty water


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9400 ProHeat Upright Wet/Dry Vacuum

Steam vac will not pick up dirty water


My Hoover Steamvac problem isn't with the bruches--it's with the suction. Dirty soapy water stays in the carpet instead of being returned to one of the holding tanks. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My scooba isn't picking up any water and the dirty tank is dry


I found that if I filled the two oblong extended openings under the tank with water and gave it a quick **** I was able to clear a large amount of [email protected] out. It took many attempts to get it to the point where I could blow into the holes and sen ... iRobot 5800 Scooba Vacuum

Hoover Steamvac Agility won't pick up dirty water


Press the handle release kick-button with your foot, extend the handle all of the way back, and take a look at the gap between the base of the unit and the handle/reseviour assembly. You should see several black hoses attached to the base and runnin ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

My pet wash bissell shampoor won't pick up the water


Hey Deanne!I know how frustrating it is not having suction when you need it. Here's a quick link to troubleshooting steps to assist you with the suction. \015\012 ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

ICAN NOT GET IT TO PICK UP THE DIRTY WATER. - Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum


THERE ARE TWO BELTS ONE IS OFF ITS THE VACUUM ONE YOU HAVE TO TAKE OFF THE COVER AND REPLACE WHEN YOU DO THOU MAKE SURE YOU LOOK AT EXACTLY HOW THAT LITTLE RED CLICKER THAT HOLD THE ROLLER BAR IN VERY IMPORTANT, ALSO WHEN YOU GET THE BELT BACK ON LIM ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Vacumm not working shampoo the rug but does not pick up dirty water


Try the following suggestions to see if you can get your machine suctioning properly:\012\0121) Remove the Tank-in-Tank Assembly and place your hand over the motor intake valve. This valve is located next to the Floor Nozzle gasket (at th ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Not picking up dirty water off floor. - Hoover Floormate H3000 Upright Wet/Dry Vacuum


First make sure that you are getting suction from the bottom of the \015\012machine. Most of the time the squeegee is worn out which does not allow \015\012it to pick up the water like it use to. Turn over the machine and \015\012inspect \015\012th ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Why wont my bisel pro heat 2x pick up the dirty water?


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a hoover steam vac spin scrub that won't pick up the dirty water heeelllllllppppppppppppp please


\015\012The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on th ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My cleaner won't pick up the dirty water - Bissell 1697-7 Powersteamer Pro Deluxe Vacuum


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

Kirby mi kirby does not picking the water when im using the shampoorer


If your shampoooer is laying out WET foam in the center of the tray and not all the way across, you are missing the wee round suds screen that goes over the hole where the hose attaches to the tank. It may be wedged in your hose. If the foam is white ... Kirby Ultimate G Bagged Upright Vacuum

Pet hair and dirty water back on carpet


If you have followed the instructions.And your not happy i would return it.Get a repacement. ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Not picking up water on a bissel proheat turbo 2x


If unit is not picking up solution it is most likely the small red plastic filter that is just above the small float door in the top piece just left of the tool switch.. pop it out clean muck out of it and it will work like new again.. have fun!! ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0504 seconds