Having problems with your Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum ?

Tank filter and Float door: are they to snap into each other or is the door to flap freely

\015 While cleaning the machine my wife removed the filter and door: the filter snapped back in place; but we aren;t sure about the float door;\015

Answers :

Click on the link below for the users manual
http://canada.bissell.com/images/UserGuides/9500_107.pdf
Repair Help & Product Troubleshooting for Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Tank filter and Float door: are they to snap into each other or is the door to flap freely


Click on the link below for the users manualhttp://canada.bissell.com/images/UserGuides/9500_107.pdf ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

What does the float flap door look like? Is it red?


It is a red square with rounded corners located on the tank lid. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Shark Navigator Pro Hepa filter exhaust door & filter keeps blowing off when I turn vac on. Was fine before I cleaned it. I've inserted the door multiple times as per manual & won't stay on.


... Vacuums

My Dyson DC25 keeps blowing off the filter within the ball. It then stops the ball from rotating freely. Will a replacement filter solve the problem? Sear has no clue they "THINK" it's the filter


Ive just been onto Dyson and they have sent me a new filter . i mentioned 2 other parts that were broken and they're sending those too . All free of charge , RESULT !!! ... Dyson DC25 All Floors Bagless Upright Vacuum

Shop vacuum float rises to shut off vaccuum immediately when turned on. Is using foam filter covered by Shop vac paper filter. Vac is shopvac 86L450


Click this link for video helphttp://www.ehow.co.uk/videos-on_4811_care-portable-shop-vac.html ... Vacuums

Does not pick up, no vaccum, motor runs, no blockage, should feel suction on hose outlet without hose hook up. Paper filter missing over cloth filter. float overload ball free, seal on section good no leakage. Maybe bad motor but runs.


Here\015\012 is a Link to one of my Tips:www.fixya.com/support/r6311178-vacuum_brush_bar_not_spinningThis\015\012 should solve the problem. ... Minuteman C82906-01 HEPA Vacuum Vacuum

The pre filter catch on my DC07 has snapped. I have the replacement, but can't get the bit left in the filter out! any ideas?


... Dyson DC07 Bagless Upright Cyclonic Vacuum

The hose to my Dyson Dc24 has no suction. There is suction from the exhaust when I move the cyclone bin. I have removed, washed and replaced filters. The valve next to the top filter keeps flapping. I've checked for blockages and can't find anything.


... Dyson Ball DC24 Bagless Upright Vacuum

I can't get the filter door to shut after installing a new generic filter.


Is there one of the attachments (If this unit stores attachments under this door?)-- is one of the attachments just a little out of its 'proper' spot?Sometimes generic filters need to e trimmed down, to fit better than manufacture specifi ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

My Dyson DC25 keeps blowing off the filter within the ball. It then stops the ball from rotating freely. Will a replacement filter solve the problem?


I just started having the same problem. Did you figure out yet? ... Dyson DC25 All Floors Bagless Upright Vacuum

HEPA post-filter on Dyson DC25 doesn't stay secure causing the ball not to roll smoothly. the red button keeps popping causing the filter to pop up enough to cause the ball not to spin freely.


... Dyson Ball HEPA Upright Bagless Vacuum - Iron/Satin Yellow

I have a bagless hoover windtunnel. The plastic flap down by the roller wont open! thus nothing will **** into the filter


Go here > http://hoover.com/file/513/ ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Back filter and its door blows off as soon as I turn it on.


Thats good has good suction i guess there should be a cover on that back filter if you can't find you can tape it down leave air coming out ... Electrolux UltraLux 2000 Bagged Canister Vacuum

My dyson dc08 has a loss of suction. A flap valve operates within a few seconds of startup which appears to divert air. I have replaced both the hepa and sponge filters but the problem persists. If there is another blockage where might it be? I cant see how to dismantle the airways to check more than the very obvious. Suggestions gratefully accepted.


You have used your Dyson too long without thorough cleaning - Here's how. Obtain a torx screwdriver, or a set of torx bits, you will need to select the correct size when you come to remove the screws. They are all the same, so you will ne ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Air leak The air leaks out at the bottom of the door (to the filter compartment) right above the controls.  We have to plug that space with tissue to keep up the vaccum/


Check the seal that is in place between the top and bottom sections. If it came out of place even a little, it will leak and you lose suction. Part number 03611180, it is called a buffer. ... Miele S251 Flamenco II Bagged Canister Vacuum

The HEPA filter blows out, pops door off, when vacumn is turned on.


... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Where can I get a filter canister door - Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum


... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

My dyson dc07 filter catch has snapped off and it's stuck


You need to take off the little vent that goes around the filter. this is hard. you take off the cover for the hepa filter (under the dustbin) there are three catches. you take off the two torx style screws under the vent and then you work the vent u ... Dyson DCO7 Upright Vacuum

Hoover upright bagless vacum.motor runs, brush turns, no suction through hole behind brush roller. however there is suction going out of dust cannister filter flap to motor. what could possible problems be?


Sorry to read about your problem, I hope this helps you out.you have a clog between the brush and bagI tried to help you. Please help me and Rate/Vote on my response, thanks and good luck ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

The water that is supposed to go into the dirty tank is running through the bottom of the machine and all over the floor. The float seems to be moving freely.


... Bissell 1400 Little Green Pro Canister Steam Vacuum

Brushes don't spin, brand new unit righr out of the box. lint filter is clean ... speed is set to high ... brushes are snapped in properly.


There should be a switch on the head of the unit. Its probably in the brushes off position. I think its by the spin brush indicator on the left hand side ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Where does the float door go??? - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Hi.My model 116 36933502 only works as suction hose. When I use the bottom, a loud "flapping" noise and no suction. Everything is clean. Seems like a broken diphragm or filter? Sears Kenmore Progressive Bagless Intelliclean 5 years. Thanks Kate


... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

My Shop Vac (Brand) Mdl#934-16-11 keeps shutting off while I'm dry vacuuming. I can turn it back on then it will shut off again. The filter is spotless, so that's not the issue. There isn't any reset buttons. The only thing I can think of is that the float for wet vacuuming is somehow being sucked up causing the the motor to be tripped off. The vacuum is only about a year and a half old and used only sparingly. Help!


... Vacuums

I have recently replaced the belt and filters. The belt is in the correct position and the rotating brush moves freely. The motor is very loud. It still vacumns but I'm afraid the motor will burn up.


Does it sound different than it did before you made the repairs to it or does it sound the same. Just so you know some of the upright vacuums on the market today sound like a jet airplane landing in your living room.Ca ... Bissell 6594 PowerForce Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0484 seconds