Having problems with your Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum ?
Bissell Lift-Off Revolution keeps clogging
\015 Every time I use my vacuumn(it is the Turbo model) the debris gets stuck before it makes it to the canister bucket where you would take off to empty the vac. It all gets stuck on the outside edges, in where I would guess is the filter(big yellow round looking thing), against the outside of the canister and will not budge! I have to take a screwdriver and literally open up the canister then try to push/pull it all out using that to clear it... but then, less than 2 minutes later it's clogged again in the same area! The canister is not full when it clogs, I clean it out every time I use it and it clogs right off. Is there anything I can do to keep that from happening?\015
Sounds like it is partially clogged. That yellow thing you are talking about, twist it and it should come out, clean or replace the filters, then re-install it. Check the hose and make sure there isn't a clog in it and clean any other filter. One problem with this bagless is the filters will clog up fast and need to be cleaned on a regular basis. Another place a clog happens is in the inlet by the brush roll.
Repair Help & Product Troubleshooting for Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Bissell Lift-Off Revolution keeps clogging
Sounds like it is partially clogged. That yellow thing you are talking about, twist it and it should come out, clean or replace the filters, then re-install it. Check the hose and make sure there isn't a clog in it and clean any other filter. One ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
I took apart my bissell easy vac to clean it because it was clogged and now I cannot remember how a part goes on that is underneith the vacuum. I keep putting it on but its not right. It lifts the vacuum off the floor so it is not sitting in there right.
Make sure the plate is lined up correctly it should side down flush ... Vacuums
Bissell 37604 Bagless Upright Vacuum. Hose keeps clogging every time I vacuum. Is there a way to prevent this? I am ready to buy a new vacuum, but it does do a great job picking up hair...until it clogs. It clogs at top of hose. Could the hose be kinked? It does not look like it.
That is a defect in the design of that style of vacuum. I went back to my old vac because I got so tired of having to unstop it. The sharp turns in the hose and the molded plastic causes it. Find one without the turns. ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum
Bissell Lift Off pet revolution vacuum losing suction
You may have a clog in the hose. Unhook the hose and see how the suction is there, if ok, then check the dirt inlet by the brush roll. If suction is low at the hose, then there is a clog in it. ... Vacuums
Troubleshoot Bissell Lift-Off Revolution Pet Vacuum Cleaner
Probably a hose clog. Check the hose on the back of the cannister. Most likely clogged where it attaches to allow debris into the cannister. If cannister is not filling up, that's a sure sign. To remove from top of back of cannister, just turn th ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum
Need a new belt for a bissell lift off revolution turbo
Hi Dale, sorry to hear the belt has broken. Now is a good time to order filters for orders that are $30 or more receive free shipping. Here's a quick link to ordering one. ... Bissell Cleanview Helix Deluxe Bagless Upright Vacuum Cleaner 21K3
High pitch noise bissel revolution - Bissell 3750 Lift Off Bagless Upright Vacuum
... Bissell 3750 Lift Off Bagless Upright Vacuum
Bissell lift off no suction - Bissell LiftOff Revolution Pet Vac 37602 Vacuum
... Bissell LiftOff Revolution Pet Vac 37602 Vacuum
I have a new bissell 50c9 upright vacuum and it keeps clogging in the clear window in the back. there is a flap that keeps coming open and filling up. everytime i clean and restart, the flap opens. i tried holding it closed and noticed lose of suction.
I have a Bissell lift-off revolution. The power won't turn on at all. Tried different outlets. It doesn't work whether the lift-off canister is out of the frame or in the frame. The manual refers to a reset switch but can't find it, even when I took the cover off the main canister unit. Where is the reset button and/or fuse?
I have the same issue too. Brush motor is working and brush is turning on but the vaccum motor is not working. If I take the canister out of the frame then it wont turn on at all. Any help? ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
Bissell Lift-Off(R) Revolution(R) Turbo Upright.
If you have a rubber smell, then the belt is slipping, does the brush roll turn freely while holding the ends? If not then replace it, part #2036619, if it is ok, then the belt has strectched and is slipping under load, part # 2106679, Style 8. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
Bissell Lift OfF Brush Roller Stops Rotating
They make the worst machines, the rollers are cheap and they make it so you cant take them apart to clean them. You don't want a dyson either, they aren't any better for pets. With all that hardwood floors you should get a good canister vacuum, sebo ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
No suction i have a bissell lift off revolution vacuum. I have cleaned all the filters and emptied out the canister made sure that the hoses are not plugged but it will not pick up unless you use the hose. the floor brush is clean and still no suction coming from under the vacuum... could you help me please
Is there a blockage in the small hose in the bottom of the machine \015\012take of the pod and you will see the small hose, \015\012Is the main hose pushed into the bottom housing ... Bissell 37603 Upright Vacuum
We have the Bissell Lift off Revolution vacuum. The brush roll and belt are broken. The brush roll has seized up and no longer spins which caused the belt to burn out. How much is a replacement part cost? Debie [email protected]
You can get the belts for that model here: http://vacbelts.xps.convina.com/bissell-style-8-belt.htmThey are only 4.99 for a 2 pack. Plus they ... Vacuums
BISSELL - Lift-Off Revolution Pet Bagless Upright Vacuum main brush stopped turning
Check your belt ... Bissell Vacuums
How do you change the belt on the Bissell Lift Off Revolution Vacuum cleaner?
Http://www.bissell.com/images/UserGuides/3750_905.indd.pdf ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
Bissell lift-off revolution, motor gets hot, loud whining sound
... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
Bissell lift off pet revolution vacuum smells bad when I vacuum!
Put a BOUNCE sheet inside the filter ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum
Well my bissell lift off revolution turbo just lost its suction?
Here's the manual for your vacuum is you don't have it alreadywww.thinkvacuums.com/pdf/uprights/Bissell_LiftOff.pdfI would first start checking for a clog somewhere in the system. Second I would check the brush roller for prob ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
Hair gets stuck in upper filter basket instead of going into the lower basket that you are supposed to empty. It is a Bissell 37604 Lift-Off Revolution Pet Bagless Upright Vacuum Cleaner
Check both filters. If one or other is increasingly dirty, wash or clean it out. Also check the air waves leading to the bagless bin canister part. If one air way is blocked the remaining dirt will try and access the bin other way due to the natural ... Vacuums
I have a Bissell Lift-Off Revolution upright vacuum cleaner. The dirt is sticking around the black round sponge filter which is in the upper part of the cleaner. It isn't falling into the bowl like it should. What could be the cause of this?
Thats what its supposed to di i suggest to clean that filter after every couple of uses to prevent any problems in the future ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum
I cant find my manual to clean my Bissell lift of revolution
BISSELL User's Guides can be downloaded at www.bissell.com\012On the front page under Customer Service click on User's Guides and enter the model number of your unit.\012User Guide will be displayed as a PDF file. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
We have a Bissell Revolution Lift-Off Turbo 3760-1 and the upright brush is not working/rolling. It only moves when pushing the vacuum. We checked the belt and it seems to be fine. The vacuum works fine as a hand-held. Any suggestions? Thanks!
These belts need to be changed every 6 months regardless of the way they look. ... Vacuums
I have a Bissell Lift-off Revolution Turbo vacuum and the brush doesn't spin on its own anymore. Does this mean the motor is busted because there's no noise when you press the brush button. We've just replaced the belt, hepa filter and a new brush. But its still the same. What's wrong with my vacuum?
Its probably the motor. remove the covers with a #2 phillips head screwdriver and cut the wires to the motor ( unplugged ). purchase some crimps at radio shack to resplice the wires together in the same fashion. ... Bissell Vacuums
No suction on the bissell lift-off revolution
I had the same problem. In the water resevoir, there is a red flap that allows the dirty water to flow back into the water tank. Lift that flap up and there is a small red screen. Pop that screen out with a butter knife and rinse it out. I have dogs ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum