Having problems with your Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum ?

This model (9300-1) will not pump water although it tries

\015 Have checked everything i can think of. water attempts to come out but is just a few drops.\015

Answers :

Will be the heater tank blocked the link below will show you how to fix
Repair Help & Product Troubleshooting for Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

This model (9300-1) will not pump water although it tries

Will be the heater tank blocked the link below will show you how to fixhttp://www.youtube.com/watch?v=SLyDeM10k9k ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My Bissell Quicksteamer Model 1960-R won't spray cleaning solution. I have cleaned it and taken apart the whole thing. I can't find any problems. The holes are not cloged where the water comes out as I disconnected it and blew through it to be sure. The lines show water trying to go through. It is as if it doesn't have enough power to pump the water out when I squeeze the trigger. I am thinking it is the pump thing but can't find a replacement part for it.

... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

I own a Bissell Proheat Pet Model 8910. After just a few uses and changing both the brush and pump belts (trying to resolve problem) carpet doesn't get wet any longer. Carpet solution comes out normally but the water barly leaves the section of the tank I fill water into, resulting in carpet recieving to much solution and not enough water. Any advice?

... Bissell 8910 ProHeat Clear View Upright Vacuum

My airpot became extremely hard to pump. Someone suggested trying to "re-seat" the lid gasket. We tried this and found mineral deposits on the gasket and metal plate, which we removed with vinegar and water. When we reassembled the pot, the lid pumps much easoer. but no water comes out. What should I do?

... Vacuums

I have a Polti Vaporetto Lecoaspira 710. I have filled the tank and set the machine up as usual. When I turn it on the boiler pump runs continuously for a minute or so and then the 'beep' begins and the machine shows that the boiler is empty. Obviously the water is not getting through. We don't live in a hard water area so it shouldn't be 'limed -up'. The manual says to leave it to cool down and then try again. That had no effect. The only answer that Polti 'Service' could give me was to try 'G

... Polti Eco Pro 3000 Canister Steam Vacuum

Vaccuum issue I just bought a Eureka upright model 5892 BVZ, my concern is, I bought it on sale (floor model) and it didn't have a manual with it. I took it home and tried it, and although it appears to be working very well there is not dirt in the catch bin on the front of the unit. I tried the hose w/attachment and again it worked very well in picking up the cat hair, but where does the hair and the dirt go, I am afraid it is spitting it back out somewhere since I can not see anything in the c

If the dirt being vacuumed is not going into the dirt cup, then it must be just stuck in the hose and evenually will clog up. Check the hose and see it there is a clog in it, otherwise you have a years warranty on a new vacuum, take it into a warran ... Eureka 5892AVZ Bagless Upright Cyclonic Vacuum

My sunbeam water cooler model #YLR2-5-67H3 has been sitting unplugged for 3 years. I moved, plugged it in and put a water bottle on top and water went all over the floor. I unplugged it, (read the instructions on the front, duh) and it still leaks on the floor. What should I do? I put it over the sink, emptied it, checked the drain plug, tried running a glass full of tap water through each tap. Only the room temperature one would work.

One of the rubber connecting hoses inside it has dried and aged so the pressure of the water from the bottle made it burst.\012\012\012You will need to open it, find the defective hose and replace it - a 2 hour relatively easy job. The hardest ... Sunbeam Vacuums

Just bought a used bissell steamcleaner 2x model 9300 needs fluid tank tried it out by filling water bladder does not dispense water when I pushed the tigger it does **** up water that I spilled on the carpet is it worth keeping after I buy the fluid tank

Click this link for spares for bissell 9300http://www.vacsite.com/en/bissell-parts-1/bissell-parts/9300-upright-deep-cleaner-se ... Hoover F5906-900 Upright Steam Vacuum

We just took our dirt devil Platinum Force Carpet Shampooer Model CE7900 out of the box - first time used. It puts soap and water down fine, but we can't get any dirty water picked up. None of the trouble shooting suggestions in the manual apply. HELP! (We had only the power on when trying to pick up the dirty water.)

... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

I have a Bissell Model 7920 that does not spray through the floor or the attachment. I have disassembled the unit and the only area that water does not pass through is the top of the pump through the pump. How can I unclog or trouble shot a bad pump?

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I have a Whirlpool Power Spa (Pollenex) Model 1900B that sounds like it is pumping but no water is dispersed. I followed all directions including making sure the bath tub water level was above the line. Thank you

... Vacuums

Bissell proheat model# 8910-3. motor works good. Will not suck water up out of carpet. please give me an ideal on what to look for. pumps water out, will not suck up

... Vacuums

I have an old oil lamp. this motor/pump pumps mineral oil up a tubing and then the oil drips down the fishing line for lack of better word. and the pump does not work. On the motor itself it reads UPPCO, Inc. Chicago Model 50 Impedance Protected 120v-60 hz .30 amps P-8365-1 Use sonneborn mineral oil only do NOT use water. Any help would be greatly appreciated. Thanks Shelley

... Vacuums

Bissell prodry-model 8350, no water will spray, tried all instructions-turn off, 30 seconds, reseat tank ect-no water--used 3 times since purchase-very disapointed in product

... Vacuums

I have a Bissell Proheat model 7901. When I pull the trigger on the handle, there is no water flow. The brushe revolves and the unit vacuums any water spilled on the floor. Could it be a failed pump or kink hose or ? Thanks Zap

Take the handle apart and put spring back into place. ... Bissell Vacuums

I have a bissell power steamer That is not spraying soap, only water. I have checked all the filters and belts that I know of I also tried to reprime the pump as indicated in the trouble shooting section. Is there anything else I can try? Thanks

If it spraying water, then the pump is ok. The valve at the bottom of the soap bottle may be bad. Also when you turn the smart mix vavle, does it turn easily or hard, if hard, try spraying some furniture polish around the knob and turn it to work i ... Vacuums

I have bissell Model 1697 Powersteamer Pro. i filled bucket up with water and no water is releasing when I try to steam clean, carpet is dry.Am I filling it up correctly, manual lost. Is there a way to view the online manual.

The pump belt may be worn and that is why it is not dispensing water. Here is a link where you can get the belts and you can view the manual: ... Vacuums

I have a bissell powersteamer model 1697 that does spray water any more. Will a new water pump solve my problem?

Check all lines from being gloggged /also check screen in the water tank on hose can you here the pump working ... Bissell Vacuums

My bissell powersteamer model 1695 does not spray enough water out. Hardly anything will come out of the handheld attachment either, just a few drips. With the floor unit, it appears the only water coming out is a result of gravity when the control is squeezed. Nothing appears to be plugged up with debrie or deposits. There does not appear to be any kind of drive belt for the pump as it seems to operate off the main vacuum motor. Any ideas?

Hi, my name is John I will do my best to assist you.\015\012\015\012Referring to this ... Bissell 1695 PowerSteamer Vacuum

Hi I have a Breville BarVista espresso machine model BES200. The water doesn't go through anymore, even when the filter is empty, so it's not a coffee problem. Pump maybe ? How can I fix it Thanks

... Vacuums

Bissell quicksteamer plus-model 1950c j01339 bearings burnt out at the water pump at the base of the shaft of the armature. How do you dissasembile to replace the bearings of the centrifugal propeller between the two propellers ?

Water comes out to fast. What is the problem?? ... Vacuums

My new domestic Pentax cam 50 water pump is sometimes going to 0 bar and not cutting in I would like to adjust the lower pressure from 1.5 bar (22 psi) to 2 bar (30).I have a diaphram type pressure tank.

... Vacuums

I have a Hoover carpet cleaner F5358-900 It no longer sucks up the water. I have taken it apart from the top down and can find no real problem. (Although I am a woman!) The spray works and the scrubbing heads go around. Should I try to disassemble it further--I will need a special screw driver? Thanks, Jana

... Hoover Vacuums

Can any one send me a diagram of the internal water and soap connection for A Bissell proheat carpet cleaner Model #7901-1. i imagine pump also needs to be primed, which port do I use to do this. Thank you for your help. [email protected] 319 550-5902

Click here for the manual - We think this will guide you,As for the pump / port to be primed - For Prime and loss of prime please click ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bissell 8920 will not dispense water and I am trying to locate the heating unit on this model. I would like to see if there is a build up on the element. Thanks

... Bissell 8920 ProHeat 2XTM Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0669 seconds