Having problems with your Bissell SpotBot Robotic Wet/Dry Vacuum ?

In the manuel mode spray will not work. In automatic mode, brushes will not turn.

Answers :

How do I turn on the light for my kurby?
Repair Help & Product Troubleshooting for Bissell SpotBot Robotic Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

In the manuel mode spray will not work. In automatic mode, brushes will not turn.

How do I turn on the light for my kurby? ... Bissell SpotBot Robotic Wet/Dry Vacuum

My Bissel proheat carpet cleaner wont spray out of the bottom or the spray handle. I took of the scrub brushes and off and cleaned out the bottom of the machine including popping out the two spray heads to make sure they were not clogged. Put it back together. Still no spray! I also did the turn off, remove fluid containers, replace, turn on for one minute to prime the pump, and still so spray...does this mean my pump is not working?

... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Brand new Hoover Max Extract Deep Cleaner brushes won't turn. Read manual. Checked filters - all clear. Set Spin Scrub Mode Selector to a scrub setting. Brushes still won,t turn. However the brushes on the Spin Scrub hand tool rotate.

... Vacuums

My brush bar won't turn - works in bare floor mode, but carpet brush won't turn when it should...

Replace the belt the belt sounds like its worn or stretched the belts turn at high rpms and get very hot and soon just ware out they work fine on floors but when it comes to carpet they slow down, i hope this works out thanks ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

When vacuuming carpet with the electric power brush it will ocassionly , go to zero suction mode and shut off the brush. I have tried to cause it to happen by playing with the joint areas ( handle to tube and tube to power brush) without sucess. When the problem does occur I just turn the suction back on and power up the brush again at the handle controls.

You gave a good start to giving us good information to help you with solving this problem-- But I need a little more information:It sounds like you have the Electric Motor driven Power nozzle/ Floo ... Miele Blue Moon Bagged Canister Vacuum

The brushes won't turn. Staying in 'Tools' mode.

What brand & model number ... Hoover F7431-900 SteamVac Vacuum

Automatic brush roller turned off

This model you will tilt forward and then change the carpet knob to bare floor ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Water does not spray and do the brushes turn

The problem could be it needs new belts the link below will show you how to replace them ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Kirby G3 made loud noise when running. Sprayed silicon in fan thinking it might be a bearing. Found a coin and nail in fan and removed. Tha vacuum would not turn on. Replaced switch and brushes. Still nothing. Did the silicon spray do something?

No - the silicon is an insulating material and would have no effect on the electrics of the vacuum. Most likely you have a bad connection - dismantle the vacuum again and check the wiring and the motor with an ohmmeter. Be very attentive with the bru ... Kirby Generation 3 Bagged Upright Vacuum

I have a cannister vacume, Fuller Brush red model # FB-DCC when I turn it on it will shut itself off in about 30 seconds this will happen several times then it will not turn on. I do not have the owners manuel

First, the word is "VACUUM." Second, it's obvoius that your motor is overheating. When's the last time you CLEANED THE FILTERS, per the operating instructions? ... Fuller Brush Vacuums

The cleaning solution on my bissell spot bot is not being pumped through....on the stationary mode or the manuel hand held mode with the brush attachment

I had the same problem, and found that the culprit was that the small filter element. about the size of a dime, that sits arount the nozzle activator (pin that depresses the clean water nozzel) was clogged with "gunk", and prevented cleaning solution ... Bissell 12005 Spot Bot Handheld Vacuum

My Kenmore canister model (116) 26212601 works in hard-surface mode (basic suction), but the brush won't spin for carpets, and when I try to turn it on, it makes a whiny sound and then turns off as it does when I need to press the overload button. I looked inside a bit, and the belt isn't broken--it seems fine. So not sure what the problem is. Thanks for any help.

... Kenmore 27815 Bagged Canister Vacuum

Brushes on Hoover Steam Vac F7441-980 do not turn.Brush control on;drive pin present;filter intake clean; Drive mechanism doesn't appear to be turning. Also when spraying on cleaning solution, spray comes out in streeks rather than the width of nozzle. JBB

... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Electrolux 8807 the exclamation light is turning red. I cleaned the brush but the brush does not move automatically and the light stays on.

May need belt ... Vacuums

Ratchet noise, beater will not turn, belt not broken, in carpet mode the Dyson d07 makes huge ratchet noise and the belt will not turn the beater brush.

Ok, so I had the same ratching noise and took the advice of many sites directing me to clean the brush. But like most I cleaned the brush and the noise continues and the brush does not spin. Reluctant to take it to get serviced I dug a l ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Brushes won't turn and vacuum will not pick up sprayed cleaner

There's a Capt. Obvious fix to check before you go any farther. Like many vacuum cleaners, the brushes on the Bissell carpet cleaners, by design, only spin when the handle is not locked in the upright position, so be sure to plug it in, turn it on, ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell spot lifter: there is no spray coming from the nozzle when I pull the trigger. It turns on and the brushes spin, but there is no way to activate the solution.

Took it back to the store...customer service found a clog...gave me new one that works ... Bissell Vacuums

Brushes wont turn and wont spray water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Brush will not stop moving when put in upright or bar floor mode. Also red power light doesn't come on when turned on.

Hi Chris,I'm sorry to hear you're having difficulties with your DC28. I'd encourage you to get in touch with us directly, so we can provide further assistance in resolving this issue. Please call our Helpline free on 1-866-693-9766 - or if yo ... Dyson DC28 Animal Bagless Upright Vacuum

Brush turn in hose mode - Eureka Smartvac 4870 Bagged Upright Vacuum

Please go to : http://www.eureka.com/en-US/Customer-Service/Videos/see the video and troubleshooting guide with common sense,for repair.this problem normally come : a) belt is broken or worn, need replace b)brushroller blockage, clean ... Eureka Smartvac 4870 Bagged Upright Vacuum

The rotating brush does not turn automatically. How do i get into my vax2 power. Many thanks

... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Hi i have a dyson dc07 it doesn't work in the upright mode. It works with the tools only .... think the brush isn't turning. it's not making any nasty noises just not picking anything up!

Has the belt snapped? ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Steam vac has no suckion ,brushes do not turn and machine stays in tools mode

Be sure to check, if the handle is upright it will have suction to tools only, if the top water is empty... it will not clean, if the drive belt is broke the brushes wont turn nor will they turn if the agitator switch is set for floors, that mode is ... Hoover Steamvac F5864-900 Vacuum

The gear that turns the dual brushes on my Bissell Spot Lifter 1716 seems to be stripped. The belt looks loose as well, but when I take the belt cover and the brush assembly out, the gear that turns the brushes is loose and appears to be stripped on the cogs. When I turn the machine on the belt turns the gear but the brushes just sit there an vibrate. They make an attempt to turn now and then but not much. Need to get a schematic or the parts so I can order the gear if it is available and th

... Bissell 1716 Spot Lifter PowerBrush Bagless Handheld Vacuum

Hoover Mach 6 U5198-900 vacuum roller brush won't turn. I had opened the bottom to clean hair off the roller. the belts are not broken. When I closed it and turned it on, now the roller brush won't turn. I can push and turn it by hand, but not easily. Then I noticed the brush on/off switch is turned off, but when I step on it, it won't turn on. I was thinking I let something get out of place when I opened the bottom, but can't see what.

... Hoover Tempo Widepath Upright Vacuum - Blue
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0701 seconds