Having problems with your Bissell SpotBot Robotic Wet/Dry Vacuum ?

Leaving bigger dirtier wet spots after cleaning

\015 I start with a small "spot" of dirt and after the Spot Bot finishes I have a large, wet circle that looks like all the machine did was disperse the dirt. The dirty areas - I've done this 12 times - are all now large round dirty areas. MUCH more noticeable - much worse\015

Answers :

Sounds like the vacuum motor is defective or you have a clog in the vaccum line. Basically everything is running except the vacuum "Suction" cycle. Do you hear the "Suction" phase (light indicator) during operation when it loudens like a whine? That would be the vacuum phase. Is the dirty water reservoir clean, do you rinse it thoroughly when you empty it? Have you removed the hose assy and rinsed it out? I think it is still part of the auto cycle even if you don't use the manual tool.
Your Spot Bot is not suctioning up the dirty water. Empty the waste tank and look underneath it. Remove the black rubber gasket right under the tank and rinse it out. Then make sure you put it back snugly into the fitted crevice. Try cleaning over that spot again. You should see the dirty water being suction out and the finished area should not be as wet as before.
Repair Help & Product Troubleshooting for Bissell SpotBot Robotic Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Leaving bigger dirtier wet spots after cleaning


Sounds like the vacuum motor is defective or you have a clog in the vaccum line. Basically everything is running except the vacuum "Suction" cycle. Do you hear the "Suction" phase (light indicator) during operation when it loudens like a whine? Th ... Bissell SpotBot Robotic Wet/Dry Vacuum

It leaves dirt and fluff in the rollers not in the filter. So is not cleaning properly. There is never anf fluff at all in the filter. Also the lid does not close properly and we constantly get the 'check tank' light coming on. It leaves streaky marks across the floor and seems to leave the floor too wet (hence the streaks). Look forward to hearing from you.


Is there something stuck in the air passage between the tank and inlet ... iRobot 5800 Scooba Vacuum

My carpet cleaner (bissell proheat plus) is not steaming, dispensing cleaner. Seems like there's a little thingy that should be spinning or turning..... When I work a small area of carpet, it just leaves behind dry blobs of carpet gunk like pet hair. I had to use a carpet sweeper to clean up. FYI - I filled the cleaning fluid container and after trying to clean the carpet, it did empty out but the carpet isn't wet. Any tips? The manual doesn't help.


You need to replace the pump belt. Here is the belt you need:Bissell ProHeat Belt ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bissell ProHeat 2X 9200 -Leaves Dirty Streaks and Leave carpet very wet!


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Bissell proheat2x worked great for awhile. Now it leaves dirty spots on the carpet I've just cleaned both forward and backward. I've cleaned the whole machine several times and can't figure out what's going on.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell proheat 2x leaves dirty water spots


Your belt for the brush might need to be changed, that or the suction parts is clogged with hair or fuzz, check that clear part of the front of the machine to see if theres anything clogging it ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Spot Bot leaves mold rings


Hey, the mold ring is showing the carpet is now clean in comparison to the rest of the room. You may want to have the rest of the carpet cleaned using a BISSELL deep cleaning machine or by calling a professional. ... Bissell 12005 Spot Bot Handheld Vacuum

Does not spray or wet surface im cleaning doesnt transfer water from one side to another


... Bissell SpotBot Robotic Wet/Dry Vacuum

Hoover Max Extract LS F6056900 Hand Tool not working / Cleaning Solution I need to know what I need to get in order to have the hand tool work on this model. Also, what cleaning solution is best for pet stains? Tried cleaning, pre-treating with Spot Shot and towel and/or scrub brush, then cleaning, still doesn't work. PLEASE HELP!!


... Vacuums

No Water My Bissell rug shampooer does not eject water or saop whan I pull the saop trigger on the handle. I checked both filters and they are clean. Then, I removed the container that sucks up the water and pulled the saop trigger, water barely came out of the tubes. I tried to clean the rug in our family room and the rug was not wet when I finished, no water coming out to clean the rug. HELP HELP HELP!!! I live in Colorado is there a Bissell repair shop near Denver, HELP!!! Thanks Dominick ema


Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be o ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I do not have my users manual and have never vacuumed wet with this vacuum. How do I change it from a dry to wet vacuum. Can't find my manual and I need to use the shop vac for water in basement, do I have to change the filter or what lost my user manual never used it to pick up water. need to know how to puit it in wet mode i want to clean the dirty water out of my pool.


\015\012Vacuuming Liquids\015\0121. When picking up small amounts of liquid\015\012the filter may be left in place.\015\0122. When picking up large amounts of liquid\015\012we recommend that the filter be\015\012r ... Craftsman 17765 Canister Wet/Dry Vacuum

I want to take apart and clean my D4C Rainbow and my E series 1 speed, I bought both of them on Ebay, and both have odors,( They are suppose to be the vacuum that cleans and purifies the air) that leaves the house smelling like smoke, and musk. We do not smoke, and we do not have pets. Uckie! Thanks'


Sorry, but a Rainbow D4 has no filtration at all. The E series has a HEPA filter that needs replacing. You can put liquid Lysol in the water on the D4 and that will help ... Rainbow E series Canister Wet/Dry Vacuum

My roomba stays in one spot and cirles like it's spot cleaning and it's not. It won't move around like it use toi haven't used it in some time altho it is charged.


My Roomba 535 stays in spot clean and will not go into any other mode. ... iRobot 530 Roomba Vacuuming Robot, White Vacuum

Poor cleaning I recently bought the Shark Steam Mop as I read mainly fantastic reviews. I was disappointed to find that it leaves a slight film on my dark hardwood floors when finished. I can wipe the film away with my finger and you can see foot prints if walked over. I also found that there are cloth streaks on my ceramic floors after drying as well. I followed all instructions, vacuumed beforehand, used distilled water even though my water is not considered hard, cleaned slowly, etc. I am wo


Hi,This type of problem usually is not he fault of the Shark Steam Mop.The problem is the old residue left on the floors by other cleaners.Here is a tip that I wrote that will help you out with that problem... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Carpet stained recently cleaned my cream coloured carpet in my entrance hall with a carpet cleaning product, wet foamy spray type, ran out of this and found a part bottle of a different brand in my cupboard, used this to finish off however must be some sort of reaction and carpet gone a greenish colour i think (colour blind sorry ) any idea's of any product that might restore my carpet, will try anything, nothing to loose. thank you Peter McGurk Goole East Yorks


Ok in the future try to have carpet cleaned only by a pro. For spot cleaning use white paper towels or dish towels and warm water. (ONLY WHITE) 99% of fabric is white and then dyed to color and if you use a color cloth you might pull the dye from the ... Bissell OxyKIC - Oxygen Activated Carpet Spot and Stain Remover Vacuum

My roomba stays in one spot and cirles like it's spot cleaning and it's not. It won't move around like it use to,i haven't used it in some time altho it is charged.


You need to clean the sensors.....you have pets...the dander gets on the sensors...it's a common issue. (See...you didnt even tell me you had pets!) ... iRobot 530 Roomba Vacuuming Robot, White Vacuum

My Roomba only works correctly when I leave out the rubbery type brush (not the fiber filled brush)...... when I leave the rubber one in, it doesn't pick up & then finally stops & says REMOVED BRUSHES..... I have cleaned every nook & cranny of this thing... inside & out. I finally found that if this one brush is left off.... it works great & has for 2 weeks??? What could be the problem?


Hi,\015\012First let’s try one more time to clear out anything that might be caught inside. For this disassemble the green brush cage unit, partially, from the blue box. This would expose the cover of the gear box. On t ... iRobot Roomba 560 Robotic Vacuum

My Bissell Proheat Turbo has poor suction and leaves the carpet too wet. Is there a way to improve the suction so the carpet will be left just damp not soaking wet?


Flip the unit over you will see a grey panel that looks like a V with 6 or 8 screws remove it and you will find a black cover I think it has 2 screws remove it and you will see a gasket seal for the bottom for the motor mine was white some times ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Lost instructions for old vax wet and dry but still working well but need instructions wet carpet cleaning VAX1171734


... Vacuums

Roomba Discovery Roomba is fully charged and cleaned with sensor wiped clean. When turned on it it sounds normal and commences to go, but it then acts like it is putting on the breaks, spins, tries to go and manages a short distance and breaks again, just not making any progress because it keeps breaking after a foot or so and turns and tries again. Sometimes is gets so stuck from moving forward at all, like it is stuck in one spot just trying to go while seemingly surrounded by barriers. Somet


I had the same back-up, turn, move forward a couple inches, backup-up, etc. problem. Try cleaning/cutting the hair, etc. out from around the brushes, as well as around the ends of the brushes. Also, try a Q-tip to clean out the four pair of sensors ... Roomba Robotic Floor Bagless Vacuum

Need instructions for use of dirt devil spot scrubber; have borrowed one to use to get some serious spots off of carpet; no instructions with it; need to know how to fill the container and how much solution to use for cleaning.


To have a manual mailed to you at no charge, please contact our customer service department at 1-800-321-1134. ... Dirt Devil SE2800 Spot Scrubber Handheld Wet/Dry Vacuum

My Roomba 4210 plays the dead battery song 10 seconds after I press Clean, Spot or Max. But I notice that I can put my roomba in diagnostic mode (with brushes, wheels etc) for long periods of time with plenty of strong power. Why won't it clean for more than five seconds without that dreadful tune, flashing power light and an amber status light?


... Roomba Robotic Floor Bagless Vacuum

I am using a bissell powerlifter plus to clean my carpet. i am using the bissellnodor remover formula. my carpet isnt wet and i was wondering if it was working if my carpet isnt wet.


... Bissell 16943 Powerlifter Wet/Dry Vacuum

Spot Bot My spot bot leaks water when it is vacuuming up the cleaning product. Where can I get in fixed? I live in Bedford Texas,near Fort Worth. Zip 76021


Their customer service # is 1-800-237-7691 and they can tell who to call for service. You can also go to bissell.com, there is a link for service centers, just put in your zip code and a list will come up. \015\012\015\012\015\012\015\0 ... Bissell 12005 Spot Bot Handheld Vacuum

My roomba discovery will not operate on the clean or max buttons, will do the spot clean and goes forward then circles. Turns itself off and plays a little da do da do do do do. I have emptied tray, sprayed with compressed air.


If your Roomba goes "uh-oh", beep-beep-beep, that's a 3-beep error code, indicating that your vacuum motor is stalled. Remove the grill from the outside (back) of the dustbin and make sure that the impeller (looks like a fan) turns easily and is not ... iRobot Roomba Discovery SE Bagless Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0513 seconds