Having problems with your Bissell Upright Vacuum - The Pet Hair Eraser 1 ea Vacuum ?

Vacuum doesn't vaccum!

\015 My Pet Hair Eraser vacuum doesn't vacuum with the regular floor attachment on. It doesn't seem to pick anything up! I've cleaned out all the hair and pet fur and the rollers seem to roll fine- but it's hard to push now and it doesn't vacuum anything up!I've changed the belt, I've cleaned the filters, I've cleaned out all the hair and it just doesn't work! It sucks up fine whenever I take the regular attachment off- but there's only so much I can do to clean my place with a hose!\015

Answers :

Sounds like there is a clog near where the hose conects to the lower brush part.. Try to look up in there.. Under the brush there should be an opening that goes into the hose.. There might be a clog there..
Repair Help & Product Troubleshooting for Bissell Upright Vacuum - The Pet Hair Eraser 1 ea Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Infinity Vaccum by Shark, model number NV31COS, will not start. The vacuum was running just fine until it grabbed the edge of a curtain. Turned it off to release the suction. Turned it back on and was working fine. About a minute later the vacuum was making an odd noise. Every 2 seconds or so it would "heave" (lack of a better word) then go away, then come back and so on. Turned the vacuum off and checked for blockage, none that could be seen or felt, and now the vacuum won't turn. Any suggestio

Carpet brush won't turn when vac on ... Euro-Pro NV31 Infinity Vacuum

Vacuum won't run light comes on but vacuum doesnt

... Panasonic MC-V5745 Bagged Upright Vacuum

My DC07 Animal Bagless Upright Cyclonic Vacuum has a small attachment for vacuuming carpeted stairs. This attachment is currently not spinning its internal brush necessary to pickup the dirt on the stairs. The rest of the vaccum is working fine. The suction cap on this attachment is pulled out, as it should be. I have checked the vacuum over thoroguhly and there are no bloackages anywhere.

Make sure to extend the wand straight up and completely out of the handle and watch that you don't kink the hose. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

While vacuuming the red light for the bag of the vacuum came on and the vacuum stopped. The bag was no where near full so I replaced it with a new bag - same problem. It vaccumes for a minute or then stops with bag light on. It is the correct bag for the machine - so what's the problem?

I'm assuming this is the Epic 6500 or similar model.\015\012Detach the hose, turn vacuum on. If it runs, place palm of hand against inport hole. If it shuts off the problem is with either the control valve setting or the control valve assembl ... Electrolux Vacuums

Why doesnt my Dyson auto adjust on our carpet? We have a taller, soft carpet and it digs into it, making it very difficult to vacuum. We have had the vacuum for about a year at another house and it worked GREAT on the berber......our new has a tall carpet somewhat like shaved berber and now the vacuum wont work.

... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Why does the vacuum not have any suction. I vacuum the same spot over and over again and sometimes it still doesnt pick up

Check hose for obstruction. Undo hose from unit and shake. ... Dirt Devil Reaction Twin Cyclone Upright Vacuum

My vaccum has a 3 position handle. This no longer works, so I have to pick up vacuum to move it. Makes it hard to vacuum scatter rugs. It does not lock into place

What is the brand and model of the vaccum? the description i see says Hoover U6311930. When I check the info for this model it gives me maytag vaccum cleaner. ... Hoover U6311-930 Power Drive Bagged Upright Vacuum

Pensare Vaccum Hi: I have an older Pensare hand held vacuum. It's the T-Rex, mod # 1505. My daughter lost the filter with the plastic frame around it that goes inside. I love the vacuum, it works great, so I don't want to buy another one and add to the land fills. Can I buy a replacement filter for it? Thanks! Autumn Moore 503-481 1817

... Pensare' Rocket V17201 Handheld Vacuum

My vaccum cleaner doesnt show the gathering dirt in the transparent section while vaccuming

My vacuum was working for a few minutes and just stop in middle of doing its job and no problem with electricity ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Relace power cord for tornado vaccum CV38 - Tornado VACUUM CV38 - 15" Vacuum

... Tornado VACUUM CV38 - 15" Vacuum

Ive changed the filter and checked the hoses but vacuum doesnt pick up ...when its on the dust is being blown out the bottom of the vacuum....i took the canister off to test the suction its fine...also cleaned the filter ...help!

Have you check the roller brush and drive belt? It may be your belt has broke or is slipping and therefore not turning the brush.\015\012Turn on machine and power head see if brush is turning if it is put a small amount of pressure on the rol ... Kenmore Vacuums

My vacuum blows air instead of sucking air. I have a dirt devil swivel guide. I got something stuck in the brush spinner, got it out...but now the vacuum doesnt suck stuff up anymore.

Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=571660\015\012Generic problem for all Vacuums\015\012My vacuum blows air instead\015\012Posted by katweaver3 on ... Vacuums

I bought a used vacuum seal machine (hobart model ht-120) it does excellent vacuum but it doesnt seal correctly all the time. it seems like there is something wrong with the valve that activates the bar that goes up and makes pressure and heats the bag for complete sealing. The heating is perfect but what is not working is what make the bar go up and down.

... Vacuums

Vaccum is making a loud high pitched sound, doesn't work well through the hose or the floor piece and shuts its self off after about 5 minutes. I have cleaned the entire vacuum out several times but this problem persists. Usually after I clean it, it'll work for a couple months, not this time. Vacuum is only 2 years old, is this typical?

... Dirt Devil Featherlight Bagless Upright Vacuum

When I turn the vacuum on, and let go of the button, the vacuum just immediately turns itself off again. I have checked the cylinder and the hose and there doesnt appear to be any blockages. Can you please help?

Hi there, \012The problem is the switch itself. It is just a really common ailment for the Dyson DC08. I h ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

My vacuum doesnt seem to **** up anything - iRobot Roomba 560 Robotic Vacuum

It is either clogged or a inlet filter is blocked with dust. If something is clogging pickup tube. Flip over and clean out. Take off dirt catcher and make sure it is clean. ... iRobot Roomba 560 Robotic Vacuum

I have a Eureka "The Boss" vacuum that doesnt seem to be sucking up as much as it should and did in the past when vacuuming on carpet and hard floor surfaces.

I have a Eureka "The Boss" vacuum that doesn’t seem to be sucking up as much as it should and did in the past when vacuuming on carpet and hard floor surfaces.\015\012 \015\012I woul ... Vacuums

Oreck vaccum when i put a new belt on, the belt rubs the side of the wall of the vacuum gets real hot and busts. is there any type of washer fitting that goes on the vacuum to hold the belt in place? i dont know i need help thank you. you can reach me at [email protected]

The belt must not be running true to the pulley. You may need a brush roll, but also check the motor to make sure it isn't moving inward after the belt is put on. ... Oreck XL Ultra Bagged Upright Vacuum

Vacuum works but doesnt ****

Make and model is ????? ... Vacuums

My dyson vacuum appears to still have suction but it doesnt

That means that the belt is stretched or worn. This causes the roller brush to not be able to turn the way its supposed to against the resistance of the carpet and therefore won't pick up well. You need to replace the belt. Here are the belts you nee ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Vacuum doesn't vaccum!

Sounds like there is a clog near where the hose conects to the lower brush part.. Try to look up in there.. Under the brush there should be an opening that goes into the hose.. There might be a clog there.. ... Bissell Upright Vacuum - The Pet Hair Eraser 1 ea Vacuum

Dyson vaccum, it will not stay on, it turns itself off and I have to hold down the start button to continue vacuuming.

... Dyson DC07 Bagless Upright Cyclonic Vacuum

Hi, I bought a used Miele silvermoon vacuum on ebay and the motor just doesnt seem as powerful as my Miele red star

... Vacuums

Canister works, vacuum doesnt

I 've been cannibalizing Kenmore canister vacs for decades b/c you can use some of the parts some of the time but not all of the parts all of the time. Presently I use the cannister of a maroon 24111 with the beater bar of 2395 b/c none of my colle ... Filter Queen Majestic Canister Vacuum

Vacuum turned off in the midst of vaccuming

Your machine has cut out because it got too hot. It will re-set itself when it cools down. The cause is almost certainly a blockage (the motor sound changes because it's not having to work at moving so much air). Follow the user manual guidelines for ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 2.2128 seconds