Having problems with your Bissell Vacuums ?

I have a 1867-1. It will not steam at the mop, instead the steam comes out a side hole. I have replaced the filter with no results.


Answers :

Repair Help & Product Troubleshooting for Bissell Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 1867-1. It will not steam at the mop, instead the steam comes out a side hole. I have replaced the filter with no results.


... Bissell Vacuums

Replacement parts where can i find replacement steam pocket towels online for the shark ultra steam blaster hard surface cleaner? I went online to www.sharkcompany.com & www.sharkvac.com and when I enter my model number S3325 search comes back with 0. Thanks


You can found them on amazon, take a look here: Amazon com Euro Pro S3325. I hope this was helpful. Cheers ... Euro-Pro S3325 Handheld Steam Vacuum

Bissell steam mop is shooting the steam and some water out the side in a little hole. The water tank was left on the mop so i'm thinking the filter is plugged?


... Bissell 1867 steamMOP Stick Vacuum

I have a Filter Queen Majestic canister vacuum cleaner. At the end of the wand, a button to release the attachement not only broke, but also one eyehole on the wand where one nipple on the button falls into. So therefore a new button isn't going to fix the wand because there isn't a hole on one side of the area where the button falls in place for a nipple to secure the button in place. IS THERE A REPLACEMENT PART FOR A NEW SECTION OF THE WAND WHERE THE RELEASE BUTTON IS SECURED IN PLACE THAT I C


... Filter Queen Majestic Canister Vacuum

My steam mop doent work. The water come from the small hole in the side of the units


... Bissell 1867 steamMOP Stick Vacuum

Steam is coming out of the cap of my steam buggy which is preventing steam to build up inside the canister. The canister did fall on its side right before this happened. Why would steam be coming out of the cap?


... Tristar SB Steam Buggy Vacuum

Is there suppose to be a cone shaped part on the mop that the steam comes out of my is just a small hole put steam does not come out the head of it shoots out with a bunch of steam


\012\012\012Hi,Here\012is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it\012may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Replacing the old chamber filter (cloth on both sides)with filter that has cloth on one side black foam on the other. Which side faces the bag?


... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

I have older Electrolux Epic Model C102D - warning light is on (icon of cup with bunch of holes in it). Is this about the filter BAG needing replaced or about the HEPA filter? Do I have a HEPA filter, and if so, how do I replace it?


... Electrolux Lux 5500 Canister Vacuum

Does the hoover runabout u427-930 have a filter? I replaced the belt and next to the light bulb was a square gray mat that looked like a filter covering a screen full of holes that looked like the motor was behind. I think it was a mat of cat hair so I took it off and threw it away; I just want to make sure that it wasn't a filter that I need to replace.


From doing a search on the internet and hoovers website it looks as if this unit does not have a filter. Such as a hepa that needs to be replaced or that is washable. So i think you are safe and dont need to worry about it. ... Hoover Elite U5061-900 Bagged Upright Vacuum

I have the euro steam blaster s3325 when I turn it on, the steam ready **** comes on right away not heating can the heating element be replaced? thanks


There is a device attach to the heating element called a thermo fuse, this devise brakes down when it get to hot.open the machine and replace it with the same value. it is written on it.. ... Euro-Pro S3325 Handheld Steam Vacuum

Unbeknownst to me, someone took the bag out of my Kenmore Progressive vacuum and failed to replace it. I have been vacuuming without a bag for months, and today the vacuum stopped sucking. When I opened up the front to replace the bag, tons of dirt and dust came pouring out. I thoroughly cleaned the vacuum, put in a new bag, but still no sucking power. Just dust coming from the rear vents where one of the filters is. Is the vacuum ruined, or is it a simple solution of buying a new filter?


Sounds like you need to buy a new motor. All that grit and dust will ruin a motor and I'm surprised it lasted as long as it did.\015\012This is where a vacuum that won't run without a bag would have been nice. (Aerus for one) ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

The CV750 stopped working. It will come on sometimes but most of time it will not work. I installed new bag and cleaned filter. Green light on side of unit is on. Switch on side of unit will not make it come on either.


My CV750 comes on but makes a very loud noise. it sounds like something is stuck then it lets loose but the noise sounds terrible and the unit smells warm. I installed a new bag and cleaned filter. Green light on side of unit is on. Switch on side ... Broan-NuTone CV750 Central Vacuum

When replacing the Kenmore chamber filter (CF-1 replaces 86883) which way does the white felted side face and which way the black sponge side?


... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

The water tank is getting really hot,steams come out the sides of it but no steam is coming out the bottom.


I was having the same problem. No steam out the bottom. I took the whole thing apart and cleaned it...inside and the mop heads. I now get water to the heads but steam is still coming out the sides of the unit and leaking. I took it apart again and th ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

The water tank is getting really hot,steams come out the sides of it but no steam is coming out the bottom.


Hi,It is clogged...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Sha ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have bought new filters for my hoover sensory 2300w . Which way do I replace the the pre motor filter? White side inwards or grey side inwards ?


... Hoover Vacuums

I noticed the Roomba's brushes were not sweeping, or turning so they could sweep. There was a new sound coming from the machine, the sound of grinding nylon! Upon inspection, I determined the problem to be a heat melted gear support hole. The hole was no longer round but oblong. You could see a ridge of plastic around this hole. So melting I believe was the culprit. The gear that uses that hole was then able to tilt to one side, thereby allowing the gear to disengage from the drive train. I


Be sure to keep your brush bearings clean. If they get clogged, the brushes don't turn and the drive sockets can get damaged. ... Vacuums

I have a bissell steam mop and it has been working fine but now there is a small hole in the side of the unit that the hot water and steam is shooting out of and it will not steam clean my floors. What should I do?


Mine TOO. Is it possible that it needs a new filter? they are available on amazon for $14. ... Bissell 1867 steamMOP Stick Vacuum

My shark steamer has stopped working after a year of having it (I have already replaced one, I'm a idiot!). My problem; however, is that it will steam, but the steam stops traveling through the actual "mop" part. I plugged it in, wait seconds and start pumping, but the steam builds up until it's hard to pump. I had to press the button really hard for the bottom to come off and it shot off like a rocket! I tried to stick something through the tubing, but it did nothing. What am I doing wrong? I


\012\012\012Hi,Here\012is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it\012may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My bissell brush band has come off and wont stay on thus the brush will not turn, there is also a black arm type thing on a spring inside (on both sides) on the pump belt side it has broken - the side where the brush belt is, help im searching for parts and a way to fix it but im getting no joy, incidentley the brush belt thickness looks way to thick for the small thickness for the brush belt cog (?) to stay on........am i missing something? so i need to get the arm thing replaced plus find a


... Bissell ProHeat Deep Cleaner Upright Vacuum

Not sucking from bottom into bag, but blows out the side filter,..yet it DOES **** FROM HOSE ATTACHMENT. How can this be?...the.belt is fine recently replace, the rollers clean..I can feel anything i


Here is a diagram ,it's probably the hose behind the brush bar thats blocked.http://www.vacsite.com/en/bissell-parts-1/bissell-parts/3522-powerf ... Bissell 3522 PowerForce Bagged Upright Vacuum

When pressing steam does not come out. need to replace (part) PUM


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Shark steam mop s3550 steam doesn't come out the pad


... Euro-Pro Shark SC-505 Handheld Steam Vacuum

Using my hoover steam vac tonight and too much water coming out. once it's turned on, water and shampoo continuously come out underneath until tanks are empty. looks to be leaking from left side bottom as looking at it standing behind the unit


Make sure that you have filled everthing properly and the hoover steam is in a good condition. or check else is there any loose coonections in the bottom of the hoover, which makes the tank empty.if the problem persists take it to service. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1169 seconds